Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: RobM
Showing results 1 to 9 of 9
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
07-30-2011, 11:29 AM
Replies: 11
Views: 1,931
Posted By RobM

Are you sure the distribuor was put back in the...

Are you sure the distribuor was put back in the correct place? First time I did this repair I was off just a little and had similar difficulties. Corrected it and the problem was solved.
Forum: Engine & Transmission
07-26-2011, 10:32 AM
Replies: 21
Views: 9,450
Posted By RobM

Did you try using a MAF sensor cleaner before...

Did you try using a MAF sensor cleaner before buying a new unit? You can find the cleaner at AutoZone for about $6 a can. CRC makes it.
Forum: 2nd Generation S-series (1995-2005) Tech
04-17-2011, 11:59 AM
Replies: 15
Views: 3,634
Posted By RobM

Why 2 people, I've changed out two sets on...

Why 2 people, I've changed out two sets on different vehicles alone with no difficulty?
Forum: Steering, Suspension & Drivetrain
04-10-2011, 05:15 PM
Replies: 2
Views: 2,868
Posted By RobM

Sounds like the same issue (the roar) I'm having....

Sounds like the same issue (the roar) I'm having. I'm thinking right now the springs in the 4X actuator system are fatigued and are not keep it disengaged completely right now. Take at look at your...
Forum: 1st Generation S-series (1983-1994) Tech
04-10-2011, 01:27 PM
Replies: 4
Views: 1,306
Posted By RobM

Intake manifold gaskets beginning to leak? ...

Intake manifold gaskets beginning to leak? That's what happened with my 1996 Suburban - couldn't see a leak and it didn't show any loss of fluid.
Forum: Steering, Suspension & Drivetrain
04-09-2011, 05:52 PM
Replies: 3
Views: 3,145
Posted By RobM

Well, took a look at the vacuum on the 4X4...

Well, took a look at the vacuum on the 4X4 actuator and it works as expected - no vacuum pressure in 2 HI and pressure as expected in both 4 HI and 4 Lo.

However, I did find out the noise goes...
Forum: Steering, Suspension & Drivetrain
04-07-2011, 09:21 PM
Replies: 3
Views: 3,145
Posted By RobM

Thanks for the reply, I'll take a look at that. ...

Thanks for the reply, I'll take a look at that. Would I get the roar I get instead of clicking were this the cause?

I like easy tests like this one to rule possibilies in and out!
Forum: Steering, Suspension & Drivetrain
04-07-2011, 04:22 PM
Replies: 3
Views: 3,145
Posted By RobM

Need assistance diagnosing a growl

I've searched for a similar occurance without success so I thought I'd begin a new thread to try and figure out my issue.

I have a 1996 S-10 "W". 157k miles

My issue is after driving for a few...
Forum: 2nd Generation S-series (1995-2005) Tech
04-06-2011, 10:52 PM
Replies: 6
Views: 2,064
Posted By RobM

Old post with out an answer - thought I'd fill in...

Old post with out an answer - thought I'd fill in the blank in case someone needs the info. in the future.

Just changed my rear bearings and seals out yesterday - they most definately do no...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands