Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: seanblazer
Showing results 1 to 22 of 22
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
05-05-2014, 04:44 AM
Replies: 0
Views: 708
Posted By seanblazer

Exclamation Highway speed hesitation

I have an 01 chevy blazer zr2 with a lift and 33s.
about a month ago i noticed a hesitation at highway speeds when cruising or slightly accelerating around 1500-2000 rpms. if i punch it the...
Forum: Engine & Transmission
06-03-2013, 03:53 AM
Replies: 13
Views: 17,030
Posted By seanblazer

well it seems like I got the idle right. I went...

well it seems like I got the idle right. I went through and checked everything out. No leaks in the plenum, sprayed some brake cleaner around the intake manifold and throttle body gaskets. checked...
Forum: Engine & Transmission
05-29-2013, 06:31 AM
Replies: 13
Views: 17,030
Posted By seanblazer

yeah i did kind of move it a little, and it didnt...

yeah i did kind of move it a little, and it didnt want to at all at first. Hmm, another thing to think about it guess. theyre about $100 dollars though so i dont know if i want to spend that kind of...
Forum: Engine & Transmission
05-27-2013, 09:17 PM
Replies: 13
Views: 17,030
Posted By seanblazer

Found out where the lose vac line goes. Into the...

Found out where the lose vac line goes. Into the reservoir in the drivers side fender. put it on but it didnt change anything.

Messed with the egr today, cut a piece of a pop can to fit the...
Forum: Steering, Suspension & Drivetrain
05-27-2013, 12:47 AM
Replies: 7
Views: 1,350
Posted By seanblazer

so the vac line that goes to the actuator is from...

so the vac line that goes to the actuator is from the transfer case and the actuator pulls the cable and holds it out with the vacuum. pulling the cable and holding it out engages the front dif.. I...
Forum: Engine & Transmission
05-26-2013, 11:31 PM
Replies: 0
Views: 2,282
Posted By seanblazer

Vacuum Diagram? 01 zr2

01 chevy blazer zr2.
Im having a high idle issue. I have replaced MAF and TPS and cleaned throttle body thoroughly. I found a vac line with tape on the end of it but dont know where it is supposed...
Forum: Engine & Transmission
05-26-2013, 11:06 PM
Replies: 13
Views: 17,030
Posted By seanblazer

i followed some of my vac lines today and found...

i followed some of my vac lines today and found one the goes up by the dirvers side firewall and it was just taped at the end. but I couldnt find where it is supposed to go. I started it and covered...
Forum: Steering, Suspension & Drivetrain
05-26-2013, 04:32 PM
Replies: 7
Views: 1,350
Posted By seanblazer

Its the push button type. but i do like that...

Its the push button type.

but i do like that posilock mod. So tell me if im wrong but that compression fitting creates the vacuum that locks in the hubs when you pull the cable? And then you push...
Forum: Steering, Suspension & Drivetrain
05-26-2013, 01:29 AM
Replies: 7
Views: 1,350
Posted By seanblazer

Question 4wd actuator

I have an 01 zr2 with a 6 inch lift and 33s.
When i got about a month ago the 4wd didnt work. So i put a new actuator in, the old one was trash. Now a month later after i have used the 4wd maybe 2...
Forum: Engine & Transmission
05-25-2013, 10:56 PM
Replies: 4
Views: 754
Posted By seanblazer

Rent tool from local parts store. Give them a...

Rent tool from local parts store. Give them a down payment and when you bring it back they should give you 100% of your money back. there should be a screw on nozzle (kind of like for puting air in...
Forum: Engine & Transmission
05-25-2013, 10:50 PM
Replies: 5
Views: 994
Posted By seanblazer

I would agree that the ignition switch is bad.

I would agree that the ignition switch is bad.
Forum: Engine & Transmission
05-25-2013, 10:46 PM
Replies: 7
Views: 1,935
Posted By seanblazer

I would just follow the vacuum lines all over to...

I would just follow the vacuum lines all over to make sure that they are all good.
Forum: Engine & Transmission
05-25-2013, 10:25 PM
Replies: 13
Views: 17,030
Posted By seanblazer

Well I took off the TB and cleaned it really...

Well I took off the TB and cleaned it really good. Didnt help.
So I bought a TPS and put that in. Didnt help.
So since I had a MAF code I got a new one. Didnt help.

maybe ill go for the EGR...
Forum: Engine & Transmission
05-23-2013, 02:36 AM
Replies: 13
Views: 17,030
Posted By seanblazer

I actually had a maf code before and cleaned the...

I actually had a maf code before and cleaned the maf with maf cleaner. I never got the code checked again, i dont want to buy a new maf unless its pretty obvious that its causing the problem. Theyre...
Forum: Engine & Transmission
05-21-2013, 08:07 PM
Replies: 13
Views: 17,030
Posted By seanblazer

High idle problems

01 blazer zr2, 6 inch lift, 33s.
had an idle issue where it would drop and come back up over and over again. I think i started noticing it while i was driving as well. So today i got some throttle...
Forum: Engine & Transmission
05-21-2013, 02:42 PM
Replies: 2
Views: 452
Posted By seanblazer

No I havent checked for vacuum leaks yet, i don't...

No I havent checked for vacuum leaks yet, i don't really know where to start. I was thinking tps right away but i dont want to just throw parts at my truck because that gets expensive.

And Im...
Forum: Engine & Transmission
05-12-2013, 08:02 AM
Replies: 2
Views: 452
Posted By seanblazer

RPMS problems

Ive got an 01 blazer zr2 with a 6 inch suspension and 33s.
Ive only had it about a month.
The problem Im having is that when in park the rpms fall down to about 700 and then bounce back up to 900...
Forum: Engine & Transmission
05-05-2013, 10:02 PM
Replies: 5
Views: 2,415
Posted By seanblazer

I got the fuel pressure tester last night and it...

I got the fuel pressure tester last night and it seemed alright and i cleaned my MAF sensor. I did notice last night that the hose/tube from the valve cover was not on the air intake, just resting...
Forum: Engine & Transmission
05-04-2013, 09:05 PM
Replies: 5
Views: 2,415
Posted By seanblazer

I also noticed that before i this problem even...

I also noticed that before i this problem even started my idle would bounce back and forth between about 700 and 800 rpms (didnt think much of it) and now its lower around 500 and 600 but seems to be...
Forum: Engine & Transmission
05-04-2013, 07:32 PM
Replies: 5
Views: 2,415
Posted By seanblazer

Died completely today. right in front of my house...

Died completely today. right in front of my house as i was pulling away. It started up fine and then drove crappy about half way to the auto parts store. could this be a fuel problem? im thinking its...
Forum: Engine & Transmission
05-02-2013, 02:30 PM
Replies: 5
Views: 2,415
Posted By seanblazer

Got my CEL codes today and they are.. P0300-...

Got my CEL codes today and they are..
P0300- Random Misfire
P0101- MAP/MAF/VAF sensor
P0452- Fuel tank pressure sensor (evap emission system)
P0404- EGR system fault

Im going to start with...
Forum: Engine & Transmission
05-02-2013, 05:03 AM
Replies: 5
Views: 2,415
Posted By seanblazer

Exclamation Multiple random misfires - 01 zr2

2001 zr2, 6 inch all suspension lift and 33/12.5/15s.
My blazer is misfiring when its cold but not at idle when i start it up. its after i start to drive and after about 2-3 minutes of driving it...
Showing results 1 to 22 of 22


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands