Blazer Forum - Chevy Blazer Forums - Search Results

Community
Search
Search: Posts Made By: RolliE319
Showing results 1 to 19 of 19
Search took 0.00 seconds.
05-06-2014, 08:30 PM
Replies: 6
Views: 1,194
Posted By RolliE319

I tried that too and nothing. It is not worth...

I tried that too and nothing. It is not worth more investment. I'm going to cut my losses and junk the car and remove all the parts I just installed . Looking at 2 blazers for sale in the area that...
05-05-2014, 06:39 PM
Replies: 6
Views: 1,194
Posted By RolliE319

So compression is steady across all cylinders at...

So compression is steady across all cylinders at 160-175.
New plugs and cap and rotor and still stumbles once or twice but no start.
05-04-2014, 12:31 PM
Replies: 6
Views: 1,194
Posted By RolliE319

So I'm right at the lines for fuel pressure. 60...

So I'm right at the lines for fuel pressure. 60 KOEO and 55 for 10. All that was replaced with the injector kit. Spark jumps a 1" gap at the coil inline to the cap. I'm going to finish compreesion on...
05-01-2014, 08:16 PM
Replies: 6
Views: 1,194
Posted By RolliE319

Cranks and stumbles, but No Start

2000 Blazer LS 4.6 Vortec

Alright guys Im at my wits end with this thing. Ill list out what I have checked and tested and see if anyone can come up with something new for me to check.

Story...
03-29-2013, 11:08 AM
Replies: 27
Views: 20,717
Posted By RolliE319

I picked up an ecm off a 2000 blazer and did the...

I picked up an ecm off a 2000 blazer and did the anti theft relearn and still the same problem.<br />
so let me recap on the scantool I am reading 300rpm while cranking so I believe the ckp sensor...
03-28-2013, 09:56 PM
Replies: 27
Views: 20,717
Posted By RolliE319

I know ecm's need to be flashed, but if I get one...

I know ecm's need to be flashed, but if I get one off a running vehicle shouldn't I just have to change out the EPROM inside to transfer the vin information?
03-28-2013, 08:19 PM
Replies: 27
Views: 20,717
Posted By RolliE319

189000 miles and the only code it tripped the...

189000 miles and the only code it tripped the last time it ran was a p0300. I was thinking of going to the junk yard tomorrow and getting an ecm.
it sounds like a timing issue to me too and the ecm...
03-27-2013, 06:28 PM
Replies: 27
Views: 20,717
Posted By RolliE319

I have not seen it but can an ICM send a bad...

I have not seen it but can an ICM send a bad signal so it still gives spark just not in the right timing with the compression tdc? or would that be more crank sensor?
03-26-2013, 08:06 PM
Replies: 27
Views: 20,717
Posted By RolliE319

it cranks the same way when attached. I was in...

it cranks the same way when attached. I was in the process of pulling the dist. cap again to check for play in the shaft and gear.
03-26-2013, 06:14 PM
Replies: 27
Views: 20,717
Posted By RolliE319

yes. the car would not try to start if it was off...

yes. the car would not try to start if it was off 180 or even 100 degrees using the wrong mark. below is the link to YouTube for where I'm at.
2000 Blazer will crank but not start - YouTube
03-26-2013, 05:18 PM
Replies: 27
Views: 20,717
Posted By RolliE319

all of that is checked and double checked. I am...

all of that is checked and double checked. I am jumping a 12mm gap with blue spark at each plug while cranking. I am pointing at the 6 with the #1 cyl at tdc lined up with the balancer marking/block...
03-25-2013, 09:29 PM
Replies: 27
Views: 20,717
Posted By RolliE319

I think I have eliminated everything. can a CPS...

I think I have eliminated everything. can a CPS relearn be done with the vehicle not starting? I am thinking not since you have to go through engine RPM's but minus that I'm lost at this point. <br...
03-25-2013, 06:30 PM
Replies: 27
Views: 20,717
Posted By RolliE319

I pulled up the live data while cranking the...

I pulled up the live data while cranking the motor and the scan tool says 0 degrees retarded( at this point I think this whole thing is more than retarted). I may be looking at this wrong but is that...
03-24-2013, 11:54 PM
Replies: 27
Views: 20,717
Posted By RolliE319

I am using a snap on scan tool that will go up to...

I am using a snap on scan tool that will go up to a 99 blazer. I have a 2000 but I am almost positive they are going to be the same.
as for the distributor, I have verified I am getting spark at...
03-24-2013, 01:10 PM
Replies: 27
Views: 20,717
Posted By RolliE319

new follow up. it was still holding pressure on...

new follow up. it was still holding pressure on the fuel system after charging up. using a scan tool I noticed the knock sensor is sitting at 4.9 volts. I think this means that it is showing active...
03-24-2013, 12:34 PM
Replies: 27
Views: 20,717
Posted By RolliE319

codes present p300 multi cylinder misfire. ...

codes present p300 multi cylinder misfire.
vehicle will not start on ether so fuel is out but it will hit 60 psi while cranking. not sure how long pressure holds but again vehicle will not start on...
03-23-2013, 06:45 PM
Replies: 27
Views: 20,717
Posted By RolliE319

update... I ran a compression test on 5 of the 6...

update... I ran a compression test on 5 of the 6 cylinders and range from 175 to 205 psi.
at this point the car sounds like it is trying to start but just won't and after about 30 seconds of trying...
03-23-2013, 03:29 PM
Replies: 27
Views: 20,717
Posted By RolliE319

2000 blazer has fuel and spark no start

OK so start of the story... for the last 2 years the car has started fine. when it was very. old out it would have a miss under light acceleration until it was warmed up then it would run fine the...
03-23-2013, 03:26 PM
Replies: 1
Views: 1,296
Posted By RolliE319

2000 blazer was missing now No start

OK so start of the story... for the last 2 years the car has started fine. when it was very. old out it would have a miss under light acceleration until it was warmed up then it would run fine the...
Showing results 1 to 19 of 19


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands