Blazer Forum - Chevy Blazer Forums - Search Results

Community
Search
Search: Posts Made By: Willwag3
Showing results 1 to 15 of 15
Search took 0.00 seconds.
01-13-2011, 06:45 PM
Replies: 7
Views: 770
Posted By Willwag3

Thats what I thought about heater controls, they...

Thats what I thought about heater controls, they are on right side of dash. Can I pull the dash(digital) and get to wiring harness from there? Pulled stereo , lighter and back window switch today and...
01-13-2011, 04:52 PM
Replies: 7
Views: 770
Posted By Willwag3

volts seem to go up slightly,around 14, normally...

volts seem to go up slightly,around 14, normally just under 14. Have noticed a slight noise from alt but was suspecting belt. Not really worn though. GFuess its not a big deal, just very strange. was...
01-13-2011, 01:32 PM
Replies: 7
Views: 770
Posted By Willwag3

Question Gotta good one here

This has to be the strangest thing I`ve ever ran into here. Have a 91 s10 blazer, 4.3 , 4 wheel drive. If I turn off the heat/defrost controls it will start bogging out like timing off. Turn heater,...
10-07-2010, 09:34 AM
Replies: 7
Views: 1,268
Posted By Willwag3

It was the catalytic converter. Was partially...

It was the catalytic converter. Was partially plugged up. Blazer running great again, only problem now is the bald spots from where I pulled my hair out!
10-01-2010, 10:28 AM
Replies: 14
Views: 12,482
Posted By Willwag3

You should have both a sock and an inline. The...

You should have both a sock and an inline. The sock filter is inside the tank on the end of the fuel pump. There should be an inline on the frame about middle of truck.
09-28-2010, 06:21 PM
Replies: 7
Views: 1,268
Posted By Willwag3

Just did a test drive after changing the...

Just did a test drive after changing the injectors. No luck, runs as bad as before. So that rules out fuel ,any ideas anyone? ...
09-27-2010, 09:11 PM
Replies: 7
Views: 1,268
Posted By Willwag3

changed pressure regulater, didnt help. set of...

changed pressure regulater, didnt help. set of injectors will be in tomorrow so am hoping that will get it fixed, Am wondering if timing could be the problem?
09-23-2010, 09:07 PM
Replies: 7
Views: 1,268
Posted By Willwag3

Pressure regulator replaced a few months ago...

Pressure regulator replaced a few months ago along with gaskets. Injectors seem to have a good spray pattern. I have not checked the fuel pressure but will do. Thanks for the help, this blazer has...
09-23-2010, 04:40 PM
Replies: 7
Views: 1,268
Posted By Willwag3

Yes i installed fuel filter correctly. It`s got...

Yes i installed fuel filter correctly. It`s got the 220 tbi . I keep thinking spark but really don`t know. When going down the hiway it will not maintain speed. either speeding up or slowing down....
09-23-2010, 07:22 AM
Replies: 7
Views: 1,268
Posted By Willwag3

Unhappy Guys I am lost and need help. My blazer(91 4.3...

Guys I am lost and need help. My blazer(91 4.3 auto 4wd 150000) stalls and backfires on take off, will not do 65 unless I keep pedal to the floor. Replaced all sensors, fuel pump,pressure...
08-09-2010, 02:34 PM
Replies: 4
Views: 939
Posted By Willwag3

Hey, thanks alot. I would`ve hooked them up wrong...

Hey, thanks alot. I would`ve hooked them up wrong without your help. Very much apreciated ohsofly!
08-09-2010, 12:59 PM
Replies: 4
Views: 939
Posted By Willwag3

Sorry, thats s10 blazer, 4.3, 1991

Sorry, thats s10 blazer, 4.3, 1991
08-09-2010, 12:57 PM
Replies: 4
Views: 939
Posted By Willwag3

fuel line at tank

Had a friend helping me change out fuel pump, he unhooked the fuel lines at pump without marking what went where. Now not remembering. Anyone sure where the return line goes? Pretty sure its the last...
08-09-2010, 10:59 AM
Replies: 7
Views: 2,578
Posted By Willwag3

That is your MAP sensor.

That is your MAP sensor.
03-26-2010, 08:23 AM
Replies: 3
Views: 5,837
Posted By Willwag3

You`ll have to drop the oil pan all the way....

You`ll have to drop the oil pan all the way. before getting in to all that take a look at youre timing tab. Is it in the 2 o`clock position or 12? I changed a timing cover and wound up having to...
Showing results 1 to 15 of 15


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands