Blazer Forum - Chevy Blazer Forums - Search Results

Community
Search
Search: Posts Made By: 95POSmoneypit
Showing results 1 to 18 of 18
Search took 0.00 seconds.
09-26-2009, 02:26 PM
Replies: 0
Views: 565
Posted By 95POSmoneypit

Transmission ???

Just bought a 95 S10 Blazer with a blown tranny. It still moves a bit when you first start it off, but no more than ~600 ft. or so, and you can always tell it is slipping. Yesterday I was moving it...
09-21-2009, 02:22 AM
Replies: 3
Views: 2,343
Posted By 95POSmoneypit

If the only diff between the 700r4 and 4L6OE is...

If the only diff between the 700r4 and 4L6OE is computer stuff, and a throttle linkage, sounds in theory that it would work just fine as long as you don't mind a check engine light? Or am I missing...
09-21-2009, 02:17 AM
Replies: 6
Views: 1,524
Posted By 95POSmoneypit

Thank you for the replys. Is the procedure to...

Thank you for the replys. Is the procedure to replace the pins and bushing pretty cumbersome, or require specialty tools? I remember reading in other threads that the kit is only about $20? Thanks...
09-20-2009, 10:00 AM
Replies: 6
Views: 1,524
Posted By 95POSmoneypit

Well, I guess the plus side is it is on the other...

Well, I guess the plus side is it is on the other side, so all I have to pull off it the little latch point where the door closes... Still, ouch! Thanks for the reply!
09-20-2009, 08:53 AM
Replies: 3
Views: 2,343
Posted By 95POSmoneypit

Exclamation The ugly duckling: 1995 S10 Blazer

I am hoping to get a few people to chime in, I am primarily irritated about the transmission in the truck right now, but there are other things. I have been reading posts, threads, and discussions...
09-20-2009, 07:02 AM
Replies: 25
Views: 44,475
Posted By 95POSmoneypit

To lift the transmission, you do just as you...

To lift the transmission, you do just as you said. Put a bottle jack on the back end of it and push it up a bit. You do not need to unbolt anything, the motor mounts will give you a little play,...
09-20-2009, 03:06 AM
Replies: 6
Views: 1,524
Posted By 95POSmoneypit

Exclamation Body cracked where door latch pin is mounted...

I just bought a new rig and was looking at the door hardware to see what needs replaced for the door to fully close. I noticed there is a few large cracks in the metal behind the latch pin to the...
09-19-2009, 04:19 AM
Replies: 0
Views: 725
Posted By 95POSmoneypit

Tranny Swap + Questions

All,

I recently picked up another 95 blazer for $600 b/c it is in a LOT better condition mine is in. The only real problem it has at the moment is the transmission is out. I picked it up...
09-19-2009, 02:29 AM
Replies: 14
Views: 10,331
Posted By 95POSmoneypit

Just a thought, I had a issue similar and it...

Just a thought, I had a issue similar and it turned out to be my trailer lights had rubbed against the frame and grounded out. Not sure why the center would work though... Good luck!
08-17-2009, 03:32 AM
Replies: 0
Views: 660
Posted By 95POSmoneypit

Question 95 blz 4x4 Front End Advice...

:icon_smallest:
Issues...

Everything that goes wrong with this truck end up worse case scenario so here goes...

Front end is having issues. Popping, rattling, clunking, squeaking, if you can...
08-17-2009, 02:42 AM
Replies: 4
Views: 2,585
Posted By 95POSmoneypit

Not sure what the LT means, and don't have much...

Not sure what the LT means, and don't have much to say about the Monroes, but I replaced my front shocks on my 95 Blazer 4x4 a few months ago with the AZ Gabreils and would not suggest them. They...
07-05-2009, 02:22 AM
Replies: 7
Views: 3,167
Posted By 95POSmoneypit

It may sound like something from the south, but I...

It may sound like something from the south, but I would try wrapping a bit of Teflon tape around it, then splice a piece of vacuum line (and put it around the fuel line) and clamping the crap out of...
06-27-2009, 04:31 AM
Replies: 4
Views: 1,395
Posted By 95POSmoneypit

When you replaced the IAC, did you clean the port...

When you replaced the IAC, did you clean the port it sits in? I pulled mine a few days ago and it fell out in 3 pieces. Put it all back together and cleaned the sensor and the whole and mine quit...
06-27-2009, 04:22 AM
Replies: 6
Views: 795
Posted By 95POSmoneypit

Is your truck running erratically? Try cleaning...

Is your truck running erratically? Try cleaning the contacts between the wire and the sensor? Maybe a lil electrical grease? That would be my first attempt...
06-27-2009, 03:30 AM
Replies: 11
Views: 1,993
Posted By 95POSmoneypit

Yes, ICM is the ignition control module mounted...

Yes, ICM is the ignition control module mounted on the distributor. I fixed the similar problem I had by replacing the coil a few days ago. Never really seen one act like that, but not really...
06-22-2009, 09:24 AM
Replies: 7
Views: 3,167
Posted By 95POSmoneypit

Wouldn't be the first time i've heard of a...

Wouldn't be the first time i've heard of a doa/short life fuel pump... Where are you testing your fuel pressure? I've read other threads that talk about capping it off at the intake and taking a...
06-22-2009, 09:04 AM
Replies: 11
Views: 1,993
Posted By 95POSmoneypit

This seems a bit odd.. I am having a similar...

This seems a bit odd.. I am having a similar problem with my rig, difference is my truck hates me at all speeds. Once I get over 20 or so you can feel the truck surge like it is trying to die, but...
06-22-2009, 08:01 AM
Replies: 17
Views: 1,622
Posted By 95POSmoneypit

I picked up a switch from the local junk yard for...

I picked up a switch from the local junk yard for $35. Had to pull it out of a same year van, but works great. My haz switch was a goner too, but the switch did not fix the problem. The wires for...
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands