Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: JeremyNYR
Showing results 1 to 28 of 28
Search took 0.01 seconds.
Forum: Paint, Body, & Interior
09-02-2010, 01:21 PM
Replies: 17
Views: 1,541
Posted By JeremyNYR

kenny, your thread gave me a headache. I...

kenny, your thread gave me a headache. I should've known when even the subject looked to make no sense.
Forum: 2nd Generation S-series (1995-2005) Tech
07-09-2010, 06:55 AM
Replies: 37
Views: 23,348
Posted By JeremyNYR

I tried a T47 and a T50 and found that the T50...

I tried a T47 and a T50 and found that the T50 fit better.
Forum: Audio/Video Electronics
06-23-2010, 03:11 PM
Replies: 15
Views: 1,311
Posted By JeremyNYR

that's crazy huge. I'm not loving the mixing of...

that's crazy huge. I'm not loving the mixing of red and black as positive or negative on the battery setup though, seems like a mistake/ accident waiting to happen.
Forum: Paint, Body, & Interior
06-10-2010, 10:57 AM
Replies: 1
Views: 822
Posted By JeremyNYR

the rear seats are a direct swap. The front seats...

the rear seats are a direct swap. The front seats are close to a direct swap. In the 97, you will have your front seats held in with 4 15mm bolts and a separate mount for the seat belt receiver that...
Forum: 2nd Generation S-series (1995-2005) Tech
06-08-2010, 03:24 PM
Replies: 37
Views: 23,348
Posted By JeremyNYR

The drivers side torx bolt goes through the...

The drivers side torx bolt goes through the floorboard so you can hit it with PBlaster from below. The passenger side goes to an enclosed area of the floor board with no access from underneath.
Forum: Paint, Body, & Interior
06-03-2010, 02:37 PM
Replies: 2
Views: 710
Posted By JeremyNYR

Have you checked with any local salvage yards...

Have you checked with any local salvage yards yet? The yards here are littered with Blazers, which is a good thing when you're looking for parts like I am.
Forum: Paint, Body, & Interior
05-26-2010, 11:30 AM
Replies: 12
Views: 19,047
Posted By JeremyNYR

It took me a while to find them on their page, so...

It took me a while to find them on their page, so I figured i'd give a direct link here for others:
http://www.shop.synergyoffroad.com/S-Series-Receiver-Tubes-RcvrTubes.htm
Forum: Paint, Body, & Interior
05-26-2010, 11:15 AM
Replies: 8
Views: 3,871
Posted By JeremyNYR

No, it's impossible.

No, it's impossible.
Forum: General Chat
05-19-2010, 07:27 AM
Replies: 51
Views: 7,719
Posted By JeremyNYR

I hear you, but I'm just being honest about my...

I hear you, but I'm just being honest about my reaction. I'm used to seeing teenagers and guys in their early 20s having the riced out/ tasteless/ pep boys special cars, not an average looking 50 or...
Forum: General Chat
05-19-2010, 07:23 AM
Replies: 14
Views: 2,013
Posted By JeremyNYR

I'd like to help contribute to the site like I...

I'd like to help contribute to the site like I have on others, so if I do the swap (which I'm still debating), I'll be sure to put together a detailed thread with pictures.
Forum: General Chat
05-18-2010, 03:23 PM
Replies: 14
Views: 2,013
Posted By JeremyNYR

I have to agree that the link to that other forum...

I have to agree that the link to that other forum was more informative in one thread than what I've found here, mostly due to the pictures included. Not that it couldn't still be done better. That's...
Forum: Tires and Wheels
05-18-2010, 03:16 PM
Replies: 4
Views: 1,412
Posted By JeremyNYR

That is correct, the bolt pattern is 4.75" x 5....

That is correct, the bolt pattern is 4.75" x 5. The offset is different for 4wd Blazers and 2wd Blazers. As far as other GM wheels that would swap over, the 1970-1992 Camaros and Firebirds (2nd and...
Forum: General Chat
05-18-2010, 03:09 PM
Replies: 51
Views: 7,719
Posted By JeremyNYR

There's a black 2nd gen s10 around here that's...

There's a black 2nd gen s10 around here that's worse than all posted so far... and what's been posted has been bad! I didn't even recognize it as an S10 until like the 5th time I saw it. It's black...
Forum: Paint, Body, & Interior
05-17-2010, 02:03 PM
Replies: 32
Views: 3,253
Posted By JeremyNYR

They look pretty good in black. I probably...

They look pretty good in black. I probably would've removed the center cap and painted them separately though. Is that a gloss black or satin? Also, I really love how your grille looks in black and...
Forum: General Chat
05-12-2010, 02:23 PM
Replies: 3
Views: 12,376
Posted By JeremyNYR

Think of it this way. There are two types of...

Think of it this way. There are two types of vehicles, Body-on-Frame vehicles and Unibody vehicles.

Blazers and all trucks that I can think of are Body-on-Frame construction. Some older cars are...
Forum: Builds
05-11-2010, 05:41 PM
Replies: 13
Views: 9,316
Posted By JeremyNYR

Cool idea. Is the piece you made completely flat?...

Cool idea. Is the piece you made completely flat? Would there be any downside to just using a piece of sheetmetal or flat abs plastic rather than fiberglass? That way you'd have a nice uniform finish...
Forum: New Member Area
04-27-2010, 07:27 PM
Replies: 16
Views: 1,012
Posted By JeremyNYR

I picked up the Blazer last weekend and spend...

I picked up the Blazer last weekend and spend some time the past two evenings cleaning the interior. It was very messy inside! Just vacuuming and cleaning the dash/center console made a big...
Forum: Paint, Body, & Interior
04-27-2010, 11:08 AM
Replies: 1
Views: 1,273
Posted By JeremyNYR

I'm thinking about the same thing and figured I'd...

I'm thinking about the same thing and figured I'd bump this thread. I've swapped dash shells before in my firebird that didn't require any new wiring, but since this would require an instrument...
Forum: Engine & Transmission
04-07-2010, 08:53 AM
Replies: 3
Views: 1,203
Posted By JeremyNYR

Can the engine and tranny be pulled together from a 96 Blazer?

I'm looking at a 96 Blazer owned by a friend and I would be pulling the engine and tranny because the engine appears to have a rod knock and the tranny is worn out at 140k miles. I plan to do a...
Forum: New Member Area
04-06-2010, 12:32 PM
Replies: 16
Views: 1,012
Posted By JeremyNYR

Well I checked it out this past weekend, but...

Well I checked it out this past weekend, but didn't snap any pictures. The body is completely solid, I couldn't find a spot of rust on or under it! The only surface rust was on the door hinges and I...
Forum: Paint, Body, & Interior
03-30-2010, 02:52 PM
Replies: 11
Views: 1,211
Posted By JeremyNYR

I've seen this in a few threads on this topic...

I've seen this in a few threads on this topic now. What is the split between Blazers that have a welded in and bolted in support? Was it split by model years? Assembly plant?
Forum: Paint, Body, & Interior
03-30-2010, 02:38 PM
Replies: 6
Views: 2,325
Posted By JeremyNYR

yeah, i guess that's what we have to assume to be...

yeah, i guess that's what we have to assume to be the reason unless we hear otherwise from someone within GM familiar with the change. I'm glad that the Blazer I'm about to get is a 96 with the...
Forum: Paint, Body, & Interior
03-30-2010, 02:18 PM
Replies: 6
Views: 2,325
Posted By JeremyNYR

I'm curious to know the history and reason behind...

I'm curious to know the history and reason behind GM making this change from 96 to 97. Did they do it to just to match the Explorer or was there more behind it? That's a pretty big change for them to...
Forum: Engine & Transmission
03-26-2010, 01:58 PM
Replies: 7
Views: 24,209
Posted By JeremyNYR

i'm about to face almost the same situation as...

i'm about to face almost the same situation as you, so I figured I'd post here for clarification. If I'm replacing the 4L60E on a 96 Blazer with a 1-piece case, is there anything preventing a direct...
Forum: The Lounge
03-26-2010, 12:43 PM
Replies: 25
Views: 2,155
Posted By JeremyNYR

For college, I'd have to say either Calculus (1...

For college, I'd have to say either Calculus (1 or 2, take your pick), Chemistry or Differential Equations. I actually did pretty decent in Differential Equations, but I could barely tell you what...
Forum: New Member Area
03-26-2010, 07:36 AM
Replies: 16
Views: 1,012
Posted By JeremyNYR

Thanks guys! I love the international...

Thanks guys! I love the international participation here. Foxxie, your sig pic is awesome.

I can't believe how excited I'm getting about picking up and fixing this Blazer! I used to drive my...
Forum: New Member Area
03-25-2010, 11:16 AM
Replies: 15
Views: 961
Posted By JeremyNYR

Checking in from Buffalo. I think we have most of...

Checking in from Buffalo. I think we have most of NY covered now, just need Binghamton and Albany. I just joined and am about to pick up a 1996 Blazer too. Have any pictures to share?
Forum: New Member Area
03-25-2010, 10:28 AM
Replies: 16
Views: 1,012
Posted By JeremyNYR

New guy in Buffalo, NY

Hey everyone!
I've been checking out your forum for the past week or two and have learned some good stuff so far. I currently drive a G6 but have been thinking about making the switch to an SUV for...
Showing results 1 to 28 of 28


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands