Blazer Forum - Chevy Blazer Forums - Search Results

Community
Search
Search: Posts Made By: midnightryder
Showing results 1 to 14 of 14
Search took 0.01 seconds.
12-29-2009, 02:43 PM
Replies: 2
Views: 7,267
Posted By midnightryder

it is the non vortec motor. it doesnt appear to...

it is the non vortec motor. it doesnt appear to have any vaccum leaks i did look for that. what is the iac valve an how do you check if its doing its job?
12-29-2009, 02:40 PM
Replies: 3
Views: 5,679
Posted By midnightryder

need wiring diagram for radio

92 blazer need wiring diagram for radio... last owner cut all wires and wired radio to cig lighter causing dead battery
12-29-2009, 02:35 PM
Replies: 2
Views: 7,267
Posted By midnightryder

4.3 high idle how do you adjust it?

92 s-10 blazer 4.3 high idle how do you adjust this?
08-08-2009, 12:09 AM
Replies: 1
Views: 894
Posted By midnightryder

Cool 98 blazer help with hook up for amp an subs

98 blazer trying to hook up factory radio to amp and subs I have a hi/lo line converter and all wires have been ran correctly, but i need help with what speaker wires are what, colors (-) (+) wires,...
12-28-2008, 10:26 AM
Replies: 3
Views: 1,227
Posted By midnightryder

RE: belt squeal

New tensioner pully 2 moths ago as well
12-28-2008, 10:08 AM
Replies: 3
Views: 1,227
Posted By midnightryder

belt squeal

new gator belt 2 months ago been good since until yesterday when it hit 60 and melted all of our snow and created alot of condisation now my belt is back to squealing, anyone have any tips on making...
11-25-2008, 06:48 PM
Replies: 17
Views: 9,996
Posted By midnightryder

RE: 4x4 vacuum actuator

i replaced the vacuum switch and it works great now the pressure ball was stuck all the way in it, thanks for your fast help!
11-25-2008, 03:54 PM
Replies: 1
Views: 682
Posted By midnightryder

4x4 vacuum to manuel cable

for a back up plan can i get the methods on going manuel pull cable with pics if poss for the 4x4 on a 98 s-10 blazer? thanks all
11-25-2008, 03:33 PM
Replies: 17
Views: 9,996
Posted By midnightryder

RE: 4x4 vacuum actuator

I followed them down pulled em off of the switch and it is on it and fully lined up on the pin, would you say the switch is bad causing it to have constiant vacuum or is that a guess
11-25-2008, 03:18 PM
Replies: 17
Views: 9,996
Posted By midnightryder

RE: 4x4 vacuum actuator

98 s-10 blazer, 3 switch and yes its constant vacuum pressure.
11-25-2008, 03:07 PM
Replies: 17
Views: 9,996
Posted By midnightryder

4x4 vacuum actuator

i took my battery tray out and noticed my actuator is staying sucked in and not releasing to dis eng front diff. and the line has continious vacuum? help please bad actuator or somthing else?
11-24-2008, 06:26 PM
Replies: 9
Views: 3,134
Posted By midnightryder

RE: 98 S-10 Blazer not engaging in 4wd.

had the same problem with my 98 follow the vac line from the pod down to the trans on the driver side of the trans is three vac lines that go into a triangle shaped rubber plug that plugs into the...
11-24-2008, 06:19 PM
Replies: 2
Views: 1,025
Posted By midnightryder

RE: 98 s-10 blazer front diff does not diseng

thanks for fast reply! the cable moves just fine when the 4x4 button is pushed, I tried to remove the front diff actuator but cant get it to come out it just pulls on the cable from inside and dont...
11-24-2008, 03:39 PM
Replies: 2
Views: 1,025
Posted By midnightryder

98 s-10 blazer front diff does not diseng

my blazer has a problem with the front diff not dis eng sometimes the right front grinds and its a pain to make it stop. 4x4 locks in great just wont unlock in front. I tried to pull front diff act...
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands