Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: ATP
Showing results 1 to 33 of 33
Search took 0.01 seconds.
Forum: 1st Generation S-series (1983-1994) Tech
01-16-2009, 03:51 PM
Replies: 2
Views: 727
Posted By ATP

RE: Tailgates Universal?

Sweet good to know. I do have the spare tire deal on my truck, worst case scenario, I take it off. I do like the sporty look of it. Thanks.
Forum: 1st Generation S-series (1983-1994) Tech
01-13-2009, 08:11 PM
Replies: 2
Views: 727
Posted By ATP

Tailgates Universal?

Are all first generation tail gates universal? I need a new one from the Pick N Pull but am not sure what years I should be safe installing.


Thank you.
Forum: 1st Generation S-series (1983-1994) Tech
10-26-2008, 03:41 AM
Replies: 1
Views: 1,132
Posted By ATP

Kill Switch and Oil question!

(94 S10 Blazer 4X4)

Have not been on here in a little while hope everyone's doing well. I have a simple question, and would like some opinions if there are any.

I figure a kill switch is...
Forum: 1st Generation S-series (1983-1994) Tech
05-28-2008, 02:39 AM
Replies: 1
Views: 1,709
Posted By ATP

RE: 4L60E wiring

ECM is behind the dash on the passenger side. It's paired with the TCCM.
Forum: 1st Generation S-series (1983-1994) Tech
05-16-2008, 02:54 PM
Replies: 11
Views: 2,553
Posted By ATP

RE: Vacuum/Brake/Idle Question

Welp, I got it off in like 10 minutes today. The bottom right nut on the firewall wasn't as bad as it seemed. Instead of dropping the steering column completely, I just took off te Neutral Safety...
Forum: 1st Generation S-series (1983-1994) Tech
05-16-2008, 04:11 AM
Replies: 11
Views: 2,553
Posted By ATP

RE: Vacuum/Brake/Idle Question

Update:

Got the right tools for booster removal...
15mm Deep socket and regular socket (Booster nuts/master cylinder nuts and push rod bolt)
Extension
Socket Wrench
Phillips Screwdriver...
Forum: 2nd Generation S-series (1995-2005) Tech
05-15-2008, 09:42 PM
Replies: 18
Views: 16,109
Posted By ATP

RE: 95 Blazer Won't Start

Are all fuses good? Mainly the ECM fuses?
Forum: 1st Generation S-series (1983-1994) Tech
05-14-2008, 06:28 PM
Replies: 4
Views: 601
Posted By ATP

RE: is this a good deal?

I'd buy it depending on the exterior, its hard to find them with under 100k miles now because theyre getting pretty old.
Forum: 1st Generation S-series (1983-1994) Tech
05-14-2008, 12:34 PM
Replies: 11
Views: 2,553
Posted By ATP

RE: Vacuum/Brake/Idle Question

Well I tried getting my leaking booster off before I went to the yard, I cannot for the life of me figure out how to get the top two firewall nuts off without removing most of the dash area around...
Forum: 1st Generation S-series (1983-1994) Tech
05-14-2008, 02:44 AM
Replies: 6
Views: 729
Posted By ATP

RE: what to look for

Well commonly the 4X4 models 4WD is buggy and has problems, so check for that. Also electrical problems are common it seems like. The rest of the problems you want to look for are the ones youd look...
Forum: 2nd Generation S-series (1995-2005) Tech
05-13-2008, 11:43 PM
Replies: 4
Views: 830
Posted By ATP

RE: dash lights

Replaced my dimmer switch today, all problems gone. Give it a try!
Forum: 1st Generation S-series (1983-1994) Tech
05-13-2008, 08:53 PM
Replies: 11
Views: 2,553
Posted By ATP

RE: Vacuum/Brake/Idle Question

I'm picking a new one up tomorrow from the pick n pull. $13 half price :]

Not looking forward to the four bolts on the firewall, the top two are a pain it looks like.

Deep sockets and an...
Forum: 2nd Generation S-series (1995-2005) Tech
05-11-2008, 11:00 PM
Replies: 4
Views: 830
Posted By ATP

RE: dash lights

I have this problem, my dimmer switch doesnt even work at all, my fuse is fine, so I blame the fuse. They try to come on sometimes but it doesnt work in the end. :[

Let me know if you get a...
Forum: 1st Generation S-series (1983-1994) Tech
05-11-2008, 10:47 PM
Replies: 1
Views: 840
Posted By ATP

RE: stuck in 4 lo

Try resetting the TCCM by pulling the TCCM fuse for a while (< 30) minutes an put it back in, and see if it will shift out.
Forum: 1st Generation S-series (1983-1994) Tech
05-11-2008, 03:56 PM
Replies: 11
Views: 2,553
Posted By ATP

RE: Vacuum/Brake/Idle Question

Mine is doing the EXACT same thing. I narrowed it down to the booster but I'm reinvestigating today.
Forum: 1st Generation S-series (1983-1994) Tech
05-10-2008, 10:52 AM
Replies: 11
Views: 1,154
Posted By ATP

RE: Not starting

It's setup for no A/C. But I need a new belt aanyways so I am just going to pick up a A/C length belt and route it right.
Forum: 1st Generation S-series (1983-1994) Tech
05-09-2008, 02:49 PM
Replies: 11
Views: 1,154
Posted By ATP

RE: Not starting

Got it started today, problem was the ECM fuse was blown, I missed it when I checked the important fuses because I'm an idiot.

Runs solid, still have to track down a cheap brake booster (leaks...
Forum: 1st Generation S-series (1983-1994) Tech
05-09-2008, 12:07 AM
Replies: 11
Views: 1,154
Posted By ATP

RE: Not starting

Terminals are perfect, and yes it is hooked up as pictured. I bought a 6 guage wire to ground the alternator to the block 20 minutes ago, think that is what the problem is?

Remember it cranks...
Forum: 1st Generation S-series (1983-1994) Tech
05-08-2008, 10:34 PM
Replies: 11
Views: 1,154
Posted By ATP

RE: Not starting

Okay battery is 100% charged still cranks but no start.

Charging System and Check Guages lights are on, I have my new alternator setup like so:

On main lug:
Red wire going to battery
2...
Forum: 1st Generation S-series (1983-1994) Tech
05-08-2008, 07:53 PM
Replies: 11
Views: 1,154
Posted By ATP

Not starting

My Blazer wont start suddenly, it happened after I pulled the alternator to put a new one in and after I pulled ALL the fuses as well, so I'm guessing fuse problem?

It cranks, just doesn't fire...
Forum: 1st Generation S-series (1983-1994) Tech
03-16-2008, 01:42 PM
Replies: 6
Views: 990
Posted By ATP

RE: Loose belt causing problems or am I crazy

The draw is my alternator, I did some tests with a test light, the only thing drawing power ismy ECM obviously, and my alternator. Woohoo more crap to get replaced.
Forum: 1st Generation S-series (1983-1994) Tech
03-14-2008, 07:13 PM
Replies: 6
Views: 990
Posted By ATP

RE: Loose belt causing problems or am I crazy

My belt isdeff the wrong length, and it doesnt even fit the routing for "With A/C" thanks to my dad buying te wrong size a while back. I also found that the belt tensioner itself, is absolutely...
Forum: 1st Generation S-series (1983-1994) Tech
03-13-2008, 12:29 AM
Replies: 5
Views: 8,012
Posted By ATP

RE: 1994 s10 Blazer->Float fuel gauge and temp gauge not moving!

I have the same problem with my temp guage, it doesnt seem to move, and my fuel guage is kinda unreliable as well. Damn you GM.
Forum: 1st Generation S-series (1983-1994) Tech
03-12-2008, 08:07 PM
Replies: 6
Views: 990
Posted By ATP

RE: Loose belt causing problems or am I crazy

It feels pretty loose, not tight at all. Like theres a good maybe 1.5inches of play in some parts...

It does squeal sometimes when it is first put in gear and drives for a few minutes.
Forum: 1st Generation S-series (1983-1994) Tech
03-12-2008, 07:29 PM
Replies: 6
Views: 990
Posted By ATP

Loose belt causing problems or am I crazy

Okay, thanks in advance.

My batteries have been draining over a period of a few days (starts over the span of the battery life), and my first hunch was somethings draining the battery, but...
Forum: 1st Generation S-series (1983-1994) Tech
01-20-2008, 02:32 PM
Replies: 7
Views: 1,479
Posted By ATP

RE: 1992 Blazer has some issues, Plz Help

4. Pop the lock cylinder out ig it doesnt work. Then use a screw driver and feel around in the hole until you find the release, that's what I had to do on mine. Same exact problem you have. m going...
Forum: 1st Generation S-series (1983-1994) Tech
01-18-2008, 03:18 PM
Replies: 13
Views: 1,536
Posted By ATP

RE: Need help so bad

Never knew that either...makes sense though. But I got the test light anyways and it's quite simple. I just need to buy a battery. You don't have to be 18 or anything to buy a battery right? The...
Forum: 1st Generation S-series (1983-1994) Tech
01-17-2008, 02:39 PM
Replies: 9
Views: 13,187
Posted By ATP

RE: Bent Frame. Suggestions???

Mine has the same bend if I am not mistaken, a light impact to the front bumper bent it back and upwards a little bit making my bumper crooked and whatnot.

You guys think heating up the bracket...
Forum: 1st Generation S-series (1983-1994) Tech
01-15-2008, 08:31 PM
Replies: 13
Views: 1,536
Posted By ATP

RE: Need help so bad

That sounds a lot simpler, so I'll do it that way. I might go to Wal-Mart tonight and pickup the light and a cheap battery. Not buying a decent battery until I solve the problem. Suppose to be warm...
Forum: 1st Generation S-series (1983-1994) Tech
01-13-2008, 04:04 AM
Replies: 13
Views: 1,536
Posted By ATP

RE: Need help so bad

It does not have the trailer package as far as I know...

Im waiting on some more cash so I can get a multimeter to find the drain, battery, and booster. Cant wait to get workin on it, hopefully...
Forum: 1st Generation S-series (1983-1994) Tech
01-08-2008, 01:51 AM
Replies: 13
Views: 1,536
Posted By ATP

RE: Need help so bad

^^Thanks:eek:


I found where to buy the test light for a few dollars, Im going to grab a new battery and find the drain, if I fail, we have a mechanic in the family who can pinpoint it. Ill...
Forum: 1st Generation S-series (1983-1994) Tech
01-07-2008, 04:14 PM
Replies: 13
Views: 1,536
Posted By ATP

RE: Need help so bad

Thanks for the help. Can you explain how to do a test light? I get what I'm supposed to do with it, I just need the test light first ha. Im going to try getting to the TCCM again too, I tried a while...
Forum: 1st Generation S-series (1983-1994) Tech
01-07-2008, 11:36 AM
Replies: 13
Views: 1,536
Posted By ATP

Need help so bad

Firstly, thanks for reading this....


I'm 17, jobless, typical lazy teenager. I have a handed down 1994 S10 Blazer 4X4 that is nothing but trouble.

It was super nice when my brother fist...
Showing results 1 to 33 of 33


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands