Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: litterbox99
Showing results 1 to 27 of 27
Search took 0.01 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
01-06-2020, 01:39 PM
Replies: 0
Views: 166
Posted By litterbox99

Rear glass unlocks all the time.

I recently replaced my rear glass with one that has a working defroster grid.
Now every time I unlock the truck, the rear glass pops open.

Is this normal behavior ? I have been driving this truck...
Forum: 2nd Generation S-series (1995-2005) Tech
08-13-2019, 07:02 PM
Replies: 8
Views: 1,174
Posted By litterbox99

My 98 Blazer does this all the time in the...

My 98 Blazer does this all the time in the winter.

I get up in the morning as I look out the window, and
remote start the truck. It lurches forward a bit and stops.

I never noticed it when I...
Forum: 2nd Generation S-series (1995-2005) Tech
05-28-2019, 06:31 PM
Replies: 3
Views: 657
Posted By litterbox99

No recall, I think that was 1997. I'm going...

No recall, I think that was 1997.

I'm going to grab a MasterPro from O'Reilly's $100 plus I have a coupon.
Free time is short and the part store is a block away from my work.
Forum: 2nd Generation S-series (1995-2005) Tech
05-27-2019, 06:18 PM
Replies: 3
Views: 657
Posted By litterbox99

98 blazer multifunction switch

I need to replace this switch assembly.

Prices varies from $50 to $300.

I prefer to buy genuine AC Delco, but that's on the high side @ $271, but
others are selling for less. Should I buy...
Forum: 2nd Generation S-series (1995-2005) Tech
03-16-2019, 09:04 AM
Replies: 6
Views: 2,066
Posted By litterbox99

No word confusion, the factory manual calls it a...

No word confusion, the factory manual calls it a inadvertent power relay.

It's a protection circuit so you don't run down the battery by accidentally
leaving the interior lights on when you park...
Forum: 2nd Generation S-series (1995-2005) Tech
03-15-2019, 07:27 PM
Replies: 6
Views: 2,066
Posted By litterbox99

Part Number for inadvertent power relay

I'm chasing some intermittent electrical issues. Hitting bumps and pot holes causes my interior lights to flicker
and I can hear a relay clicking behind the instrument panel as it happens. The...
Forum: 2nd Generation S-series (1995-2005) Tech
12-24-2018, 04:19 PM
Replies: 4
Views: 591
Posted By litterbox99

Yes, I'm doing the big three, just wanted to fuse...

Yes, I'm doing the big three, just wanted to fuse the alt.
I had read about fuse-able material but I may as well
fuse it like mentioned 125a. My fuse holder came
with a 150a, but I'd be more...
Forum: 2nd Generation S-series (1995-2005) Tech
12-22-2018, 08:19 PM
Replies: 4
Views: 591
Posted By litterbox99

98 blazer alternator output

My Blazer has a 105A alternator. The alternator is PCM controlled, just one wire.

The stock alternator output wire looks to be 10 gauge. From the charts, a 10 gauge
cable, less that 4 feet is...
Forum: 2nd Generation S-series (1995-2005) Tech
09-24-2018, 06:29 PM
Replies: 19
Views: 1,387
Posted By litterbox99

I have a 98 Blazer LT and I just replaced the...

I have a 98 Blazer LT and I just replaced the fuel filler neck
all the way down to the tank. Both the original and the
replacement had a 'ping pong ball check valve' that would
make siphoning...
Forum: 2nd Generation S-series (1995-2005) Tech
03-31-2018, 05:18 PM
Replies: 4
Views: 550
Posted By litterbox99

I crawled underneath and only saw a few tabs at...

I crawled underneath and only saw a few tabs at each end.
I'd rather tap the tabs out from the back side, but my view
to the rest of bumper is blocked by what looks like a factory
trailer hitch...
Forum: 2nd Generation S-series (1995-2005) Tech
03-29-2018, 06:43 PM
Replies: 4
Views: 550
Posted By litterbox99

Rear Bumper pad removal

I have a 98 4dr 4WD Blazer, the rear bumper needs replaced.

The top pad has to be removed to access the mounting bolts.

Pics of the replacement bumper looks like slots are cut in the bumper ...
Forum: 2nd Generation S-series (1995-2005) Tech
01-27-2015, 05:53 PM
Replies: 13
Views: 6,288
Posted By litterbox99

You could identify the memory device on the...

You could identify the memory device on the cluster PCB. Use an Eprom reader
and dump the contents. Convert contents from HEX to Decimal. Search the dump
and look for a string that matches your...
Forum: 2nd Generation S-series (1995-2005) Tech
01-15-2015, 05:39 PM
Replies: 5
Views: 3,320
Posted By litterbox99

True, sorry I missed that part.

True, sorry I missed that part.
Forum: 2nd Generation S-series (1995-2005) Tech
01-14-2015, 08:19 PM
Replies: 5
Views: 3,320
Posted By litterbox99

'Clicking' sounds could be the CV joints on the...

'Clicking' sounds could be the CV joints on the front shafts.
Forum: 2nd Generation S-series (1995-2005) Tech
12-25-2014, 01:50 PM
Replies: 4
Views: 792
Posted By litterbox99

No type of DTC codes were detected according to...

No type of DTC codes were detected according to my Innova 3100 ABS
scanner.

I did jumper pins 13 & 5 on the OBD2 connector and the leds on the
shift buttons blink once every three seconds. As I...
Forum: 2nd Generation S-series (1995-2005) Tech
12-24-2014, 04:00 PM
Replies: 4
Views: 792
Posted By litterbox99

Another three button 4wd issue.

I bought a 98 Blazer 4wd LT this summer, the 4wd didn't work.
I read all the posts and then some... I ended up replacing the vacuum
actuator, cable and switch (at the end of the cable)

The 4wd...
Forum: 2nd Generation S-series (1995-2005) Tech
12-17-2014, 06:35 PM
Replies: 121
Views: 78,212
Posted By litterbox99

My Blazer did this yesterday :-( When I put it...

My Blazer did this yesterday :-( When I put it on floor, it goes
to the windshield.

It has auto climate, but I noticed my feet were cold so I checked all
modes. Everything else works fine. ...
Forum: 2nd Generation S-series (1995-2005) Tech
09-22-2014, 08:36 PM
Replies: 5
Views: 2,958
Posted By litterbox99

Remote oil filter block bypass for cooling.

I've read the threads about removing the remote oil filter/cooler lines from S10's and installing the filter on the block. In my case, the oil lines running to the radiator are a bit wet. From what...
Forum: 2nd Generation S-series (1995-2005) Tech
09-22-2014, 03:44 PM
Replies: 1
Views: 1,789
Posted By litterbox99

Rear Wiper motor struggles on 98 Blazer

I replaced my rear wiper motor with a NEW unit from Oreilly's $78.00

If the rear window is DRY, the wiper struggles to start a sweep.
After a few seconds, I hit the wiper fluid so I don't burn...
Forum: 2nd Generation S-series (1995-2005) Tech
07-20-2014, 02:46 PM
Replies: 3
Views: 850
Posted By litterbox99

Well that was easy, went smooth. I did end up...

Well that was easy, went smooth. I did end up removing
the lower ball joint (it was bolted on) I was worried about
nothing !
Forum: 2nd Generation S-series (1995-2005) Tech
07-19-2014, 06:19 PM
Replies: 3
Views: 850
Posted By litterbox99

98 4WD Blazer Right Front CV Shaft

I'm replacing my right front CV axle.

I just replaced both upper control arms
so I have some experience here.

As I see it, I need to remove the following;

Wheel, rotor, caliper, backing...
Forum: 2nd Generation S-series (1995-2005) Tech
07-18-2014, 07:42 PM
Replies: 6
Views: 3,364
Posted By litterbox99

I finally got around to replacing the upper...

I finally got around to replacing the upper control arms, shocks,
camber bolts and sway bar bushings.

I took it to a local shop to have it aligned. The tech thanked
me for the new cam bolts,...
Forum: 2nd Generation S-series (1995-2005) Tech
07-07-2014, 06:26 PM
Replies: 2
Views: 2,528
Posted By litterbox99

Weather was good so I took some more time and...

Weather was good so I took some more time and replaced the front
sway bar bushings, 4WD vacuum actuator, cable & switch.

Good news ! 4WD works now.

Now I have to drive it to look for leaks.
Forum: 2nd Generation S-series (1995-2005) Tech
07-05-2014, 05:46 PM
Replies: 2
Views: 2,528
Posted By litterbox99

Front of motor oil leak.

I removed the front plastic skid plate from my recently
purchased 98 4WD Blazer. I wanted to get a look at
my suspension as I bought new sway bar bushings.

What a wonderful view and better...
Forum: 2nd Generation S-series (1995-2005) Tech
06-27-2014, 07:02 PM
Replies: 6
Views: 3,364
Posted By litterbox99

Upper Control Arms 98 blazer 4WD

I took the truck to get some new tires put on.

Wrangler Radials 235/75/15 installed for $450.
Competitively priced for my area....

They told me I needed both upper control arms w/ball
joints....
Forum: 2nd Generation S-series (1995-2005) Tech
06-17-2014, 06:09 PM
Replies: 7
Views: 1,271
Posted By litterbox99

Steel is half the price of aluminum (I want to...

Steel is half the price of aluminum (I want to keep costs down) and
considering I park outside year around, steel would be easier to maintain.
With all the salt & chemicals used here in the...
Forum: 2nd Generation S-series (1995-2005) Tech
06-15-2014, 08:20 PM
Replies: 7
Views: 1,271
Posted By litterbox99

Shorter Wheel backspace - neg affects

I bought a 98 4WD Blazer LT a few months ago.
It needs wheels and tires.

As I understand; stock wheel is 15x7 5x4.75 6" backspace.

I can't find a cheep wheel in this configuration. I'm not...
Showing results 1 to 27 of 27


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands