Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: vracer99
Showing results 1 to 10 of 10
Search took 0.00 seconds.
Forum: Paint, Body, & Interior
01-28-2012, 10:50 PM
Replies: 31
Views: 27,133
Posted By vracer99

interior rattle & removing panel to get at it

I have the same problem with my 04 Extreme. It has developed a bad rattle somewhere in the piller or overhead section just behind my ear on the drivers side. It's been awhile since your post, but I...
Forum: Paint, Body, & Interior
05-01-2011, 10:09 PM
Replies: 4
Views: 10,036
Posted By vracer99

Thanks this helps. I wasn't sure where to start...

Thanks this helps. I wasn't sure where to start popping the trim off. Also didn't know if it was held on with metal clips or plastic. I'm sure you still have to be very careful and easy to keep from...
Forum: 2nd Generation S-series (1995-2005) Tech
04-28-2011, 08:54 PM
Replies: 0
Views: 1,340
Posted By vracer99

Question Floor Shift Center Console

Can anyone tell me where I can find detail instructions on how to remove the center floor console in my 2004 Extreme.
Forum: Paint, Body, & Interior
04-28-2011, 08:36 PM
Replies: 4
Views: 10,036
Posted By vracer99

A further question to this thread. I have the...

A further question to this thread. I have the same issue with my Blazer. Can anyone instruct on how to remove the inside plastic trim around the big side window so I can pull the carpet back? There...
Forum: 2nd Generation S-series (1995-2005) Tech
04-25-2011, 09:16 PM
Replies: 4
Views: 14,009
Posted By vracer99

ignition lock won't release key

2004 Blazer Extreme with console shifter. A couple weeks ago started randomly not being able to remove key from ignition switch after put in Park. Could shift up and down a few times and eventually...
Forum: 1st Generation S-series (1983-1994) Tech
03-27-2011, 07:58 PM
Replies: 3
Views: 1,359
Posted By vracer99

Thanks for the suggestions. This seems to be a...

Thanks for the suggestions. This seems to be a problem no one has encountered. I've used this method a couple times in the past, ( probably the last time about 1 year ago ), and each time it worked...
Forum: 1st Generation S-series (1983-1994) Tech
03-25-2011, 10:13 PM
Replies: 3
Views: 1,359
Posted By vracer99

Question SES Light doesn't flash codes

My 92 S10 Blazer 4.3 "W" engine has taken spells running very rough, cuts off, and will not idle. I can hold the engine at high revs and it will smooth out some. When it gets really bad the SES light...
Forum: 1st Generation S-series (1983-1994) Tech
03-20-2011, 11:30 AM
Replies: 0
Views: 1,703
Posted By vracer99

Fan speed switch connector

Had to replace the A/C & Heater Fan Speed Switch on my 92 s10 Blazer. When I pulled the control unit out of the dash to replace the switch, the brown "hot" wire pulled out of the black plastic...
Forum: 1st Generation S-series (1983-1994) Tech
11-28-2010, 08:44 AM
Replies: 4
Views: 894
Posted By vracer99

Thanks robertr 728. That's what I thought, but I...

Thanks robertr 728. That's what I thought, but I just wanted to get someone elses opinion just to be sure. What would have been the purpose of it anyway. Because it was on a 4x4 maybe to seal the...
Forum: 1st Generation S-series (1983-1994) Tech
11-27-2010, 09:57 PM
Replies: 4
Views: 894
Posted By vracer99

Question Starter motor seal question

Replacing the starter motor on my 1992 S10 Blazer 4x4 with the 4.3 engine. Finally got it out - what a terrible job. My problem is that the original starter had a dense foam seal around the nose,...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands