Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: 982DRBlack
Showing results 1 to 23 of 23
Search took 0.01 seconds.
Forum: Audio/Video Electronics
08-06-2007, 09:05 PM
Replies: 9
Views: 983
Posted By 982DRBlack

RE: Cannot Get Speakers To Fit

Yeah, i thought they were going to be easy until the speaker didnt freakin fit. So thanks for the ideas and tips, they are greatly appreciated.
Forum: Audio/Video Electronics
08-06-2007, 08:58 PM
Replies: 9
Views: 983
Posted By 982DRBlack

RE: Cannot Get Speakers To Fit

Yeah that would work fine. I shall be doing that. Need MDF for the rear anyways. Thanks Hillbilly.
Forum: Audio/Video Electronics
08-06-2007, 08:23 PM
Replies: 9
Views: 983
Posted By 982DRBlack

RE: Cannot Get Speakers To Fit

I would but there has to be something that sticks out about 2 or so inches so that the back of the speaker doesnt hit the window channel. Worst come to worst ill make something.
Forum: Audio/Video Electronics
08-06-2007, 08:12 PM
Replies: 9
Views: 983
Posted By 982DRBlack

Cannot Get Speakers To Fit

I purchased a set of MB Quart Component speakers for my door in my 98 2Dr Blazer and cannot get them to fit. The stock door brackets were of the wrong size and too flimsy, so I ordered these adapter...
Forum: 2nd Generation S-series (1995-2005) Tech
06-27-2007, 06:39 PM
Replies: 2
Views: 1,278
Posted By 982DRBlack

RE: Need Cruise Control Servo

Ok, sent him a message. Ill see. Thanks
Forum: 2nd Generation S-series (1995-2005) Tech
06-27-2007, 04:47 PM
Replies: 2
Views: 1,278
Posted By 982DRBlack

Need Cruise Control Servo

The servo on my Blazer is shot and its 600$ for a new one from the dealer, besides junkyarding and ebay (nothing there), does anyone know of a place where I could get one. Thx
Forum: Audio/Video Electronics
06-20-2007, 08:29 PM
Replies: 5
Views: 857
Posted By 982DRBlack

RE: Help With Wiring

Ok Thanks,my Blazer is a two door, the reason Im going w/ components in the rear is because I want something that will take handle the power of that Alpine amp. Im open to suggestions for the...
Forum: Audio/Video Electronics
06-20-2007, 07:48 PM
Replies: 5
Views: 857
Posted By 982DRBlack

RE: Help With Wiring

So I need no fuses and no capacitor? And if I do add a sub and amp later, will I need either of those then? Is that block that needs two grounds really a pain?
Forum: Audio/Video Electronics
06-18-2007, 08:24 PM
Replies: 5
Views: 857
Posted By 982DRBlack

Help With Wiring

Im putting a system in my truck and need help with wiring and electrical. I am using a pioneer 7800 HU. MB Quart RVF 216 Components front and rear. I will be buying an Alpine PDX4.150 amp to power...
Forum: Steering, Suspension & Drivetrain
04-16-2007, 06:53 PM
Replies: 3
Views: 2,984
Posted By 982DRBlack

RE: vibration between 40-45 mph

One of your wheels may have thrown a weight and be out of balance. Thats the only thing I can tell you it might be. Does it get worse as you continue to accellerate?

It could possibly be a bad...
Forum: Suspension Tech
04-16-2007, 06:40 PM
Replies: 2
Views: 802
Posted By 982DRBlack

RE: Lift Kit Options

I like my 2" Superlift. It gives you enough room to clear 30 inch tires and lifts the truck some but not so much that it makes it look like a rollerskate. For about 550-600$ its a nice kit. Just make...
Forum: Suspension Tech
04-16-2007, 06:26 PM
Replies: 3
Views: 706
Posted By 982DRBlack

RE: stock leafs

Will you be purchasing the stock leafs and then putting an Add-A-Leaf kit in to get you lift?
Forum: Lifting Tech
04-16-2007, 06:24 PM
Replies: 2
Views: 904
Posted By 982DRBlack

RE: lift question

Well Ive got a 2" Superlift on my 4x4 and Im running 30x10.5R15 BFG A/Ts The fronts when turned do rub on my fender flares.But if your going up another 1.5 inches ontop of a 2" body liftI would think...
Forum: Detailing
04-16-2007, 12:12 PM
Replies: 20
Views: 3,111
Posted By 982DRBlack

RE: getting mirrors black again...

Yeah Rustolium paint works terrible on plastic pieces. Been there done that, its a waste of money. However, if your not wanting to spend 100 or so to have the mirrors painted professionally you could...
Forum: Audio/Video Electronics
04-15-2007, 09:11 PM
Replies: 11
Views: 1,382
Posted By 982DRBlack

RE: Tweeter and Amp Placement

Yeah that makes sense, althought it seems like there wouldnt be a lot of room on the drivers side, but then again I havent popped the dash surround off and looked. Yeah I think ill go with your idea...
Forum: Audio/Video Electronics
04-15-2007, 08:57 PM
Replies: 11
Views: 1,382
Posted By 982DRBlack

RE: Tweeter and Amp Placement

Yeah, I know I could get speaker and power wire that long, but not so sure about the RCA cables. That could get expensive. I was also wondering, you said you put the tweeters in the stock location,...
Forum: Audio/Video Electronics
04-15-2007, 08:42 PM
Replies: 11
Views: 1,382
Posted By 982DRBlack

RE: Tweeter and Amp Placement

Yeah I would put them on those flaps that cover the rear seats, but I would like to still be able to use my cargo area and not have to worry about screwing up my amps in the process. Be nice...
Forum: Audio/Video Electronics
04-15-2007, 08:25 PM
Replies: 11
Views: 1,382
Posted By 982DRBlack

Tweeter and Amp Placement

I am going to be investing in a nice sound system for my truck sometime soon. I have settled on a set of MB Quart components for the front.However, Im curious as where to put the tweeters. Should I...
Forum: Audio/Video Electronics
04-10-2007, 01:31 PM
Replies: 25
Views: 2,684
Posted By 982DRBlack

RE: headlight bulbs

I just put Silverstar Ultra Low bulbs in my blazer. WOW! I love the white, they light up the road much further than my stock blubs. Well worth the 48 bucks I paid for them. Now Ive got to fork over...
Forum: Paint, Body, & Interior
04-09-2007, 12:18 PM
Replies: 8
Views: 1,305
Posted By 982DRBlack

RE: Rust Spots

Yes they can be buffed out. This happened to my dads 2002 F250. The harsh winter here in michigan made the spots tough to get off with a buffer. We ended up rubbing the entire truck down by hand. It...
Forum: Paint, Body, & Interior
04-05-2007, 10:51 PM
Replies: 4
Views: 895
Posted By 982DRBlack

RE: Jimmy Grille and Lights on Blazer

Can anyone help me?
Forum: Paint, Body, & Interior
03-29-2007, 11:08 PM
Replies: 4
Views: 895
Posted By 982DRBlack

RE: Jimmy Grille and Lights on Blazer

Well I searched 10 times with different combos trying to get that post and couldnt find anything asking what Im asking. So if you know it and could get me a link or something thatd be great. And if...
Forum: Paint, Body, & Interior
03-28-2007, 10:25 PM
Replies: 4
Views: 895
Posted By 982DRBlack

Jimmy Grille and Lights on Blazer

I am looking to replace some of the front clip components on my 98 Chevy Blazer. I will be getting a new bumper and lower valence, along with new parking lamps and possibly headlights and repainting...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands