Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: xAnarChisTx
Showing results 1 to 22 of 22
Search took 0.01 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
07-23-2014, 06:38 PM
Replies: 3
Views: 4,483
Posted By xAnarChisTx

So I brought the Jimmy to a mechanic to have it...

So I brought the Jimmy to a mechanic to have it checked out, and so far he replaced the plugs, wires, cap and rotor. He said he also added a second shim to the crankshaft sensor, and said he checked...
Forum: 2nd Generation S-series (1995-2005) Tech
06-29-2014, 01:54 PM
Replies: 3
Views: 4,483
Posted By xAnarChisTx

P0300/P0304 Flashing SES Issue

Hi everyone! I know there are a plethora of posts about this, and have researched a lot so far, but I figure I would tell my story so that I can get a better focus on what I should do next.

My...
Forum: Audio/Video Electronics
05-02-2012, 12:19 PM
Replies: 4
Views: 6,681
Posted By xAnarChisTx

Try this to see if it helps: ...

Try this to see if it helps:

https://blazerforum.com/forum/audio-video-electronics-8/stereo-wiring-install-parts-11284/
Forum: Audio/Video Electronics
05-02-2012, 12:04 PM
Replies: 4
Views: 2,368
Posted By xAnarChisTx

And be prepared to have some epoxy resin or an...

And be prepared to have some epoxy resin or an ABS glue just in case any of the clip holders are cracked or broken. I had that issue when I tried to carefully take one of my door panels off.
Forum: General Chat
05-02-2012, 11:02 AM
Replies: 13,744
Views: 1,069,751
Posted By xAnarChisTx

I'll be taking my Jimmy to the mechanic to have...

I'll be taking my Jimmy to the mechanic to have the transfer case seal and vacuum switch swapped out, as well as the 4WD actuator. Most of the vacuum lines have been replaced or cleaned. The mechanic...
Forum: Audio/Video Electronics
05-01-2012, 07:19 AM
Replies: 5
Views: 2,228
Posted By xAnarChisTx

If you can't find one locally, just wait for a...

If you can't find one locally, just wait for a deal on eBay. I nabbed one for $60 when I was looking but I had to wait a bit as well. You'll fine one for a good price, just need to be patient. ;)
Forum: New Member Area
04-26-2012, 03:09 PM
Replies: 6
Views: 426
Posted By xAnarChisTx

Hello from the Capital District!

I'm not really a new member but I haven't really introduced myself before. I come from Albany, NY and started off with a '93 Chevy S10 4.3L pickup given to me by my dad but moved on to an '01 GMC...
Forum: General Chat
04-26-2012, 02:47 PM
Replies: 360
Views: 72,826
Posted By xAnarChisTx

2001 Jimmy 4DR, bought it in 2005 at around 70K...

2001 Jimmy 4DR, bought it in 2005 at around 70K miles for about $10,000. Now has almost 180K. Let's see what I went through so far:

Alternator
Starter
Fuel pump
2 fuel filters
Battery
Plugs...
Forum: 2nd Generation S-series (1995-2005) Tech
04-17-2010, 06:16 AM
Replies: 6
Views: 2,814
Posted By xAnarChisTx

Everything is now taken care of. Turns out it...

Everything is now taken care of. Turns out it was the fuel filter, which was plugged up big time. Put a new one on, and the truck drives like a dream.
Forum: 2nd Generation S-series (1995-2005) Tech
03-19-2010, 05:06 PM
Replies: 6
Views: 2,814
Posted By xAnarChisTx

lol, MAF has already been cleaned. And I made...

lol, MAF has already been cleaned. And I made sure to be careful with the wires, lol.

Anything else? :)
Forum: 2nd Generation S-series (1995-2005) Tech
03-19-2010, 11:54 AM
Replies: 6
Views: 6,549
Posted By xAnarChisTx

Here you go: ...

Here you go:

http://files.automotiveforums.com/gallery/watermark.php?file=/500/116754All_Zerk_Fittings_1_-med.JPG
Forum: 2nd Generation S-series (1995-2005) Tech
03-19-2010, 09:35 AM
Replies: 6
Views: 2,814
Posted By xAnarChisTx

When my SES light was on before, I had 2 codes. ...

When my SES light was on before, I had 2 codes. One was P0101 (MAF), and I believe the second was P0446. For the P0446, I replaced the gas cap, because I had a old locking gas cap that I have had...
Forum: 2nd Generation S-series (1995-2005) Tech
03-19-2010, 08:22 AM
Replies: 6
Views: 2,814
Posted By xAnarChisTx

Hesitation, and What I Have Done So Far

I have a 2001 GMC Jimmy that has 143,000 miles on it. I am currently experiencing hesitation and slipping either from take off or when I am on the highway going 70MPH, and around 2000-2400 RPMs. It...
Forum: 2nd Generation S-series (1995-2005) Tech
01-08-2010, 06:30 PM
Replies: 2
Views: 2,621
Posted By xAnarChisTx

Alright, to add to the list I already have, when...

Alright, to add to the list I already have, when I went to start my truck, the battery was dead. After I jump started it, drove it around, and turned it off, the smaller headlights, the taillights,...
Forum: 2nd Generation S-series (1995-2005) Tech
01-08-2010, 01:54 PM
Replies: 2
Views: 2,621
Posted By xAnarChisTx

Rear Washer Pump and Right Flash Issues

Hey all. I have a 2001 GMC Jimmy, and the issues that I am having are as follows:

- For some reason out of nowhere, my rear washer pump would not stop running and drained out all of the fluid. I...
Forum: 2nd Generation S-series (1995-2005) Tech
06-04-2008, 07:54 AM
Replies: 10
Views: 3,226
Posted By xAnarChisTx

RE: Won't Hot Start, Maybe Bad Fuel Pump?

I'll have to get a hold of a fuel presure gauge somewhere, but there wouldn't be any pressure if the fuel pump doesn't prime for 3-4 seconds when I turn the key to the ON position, correct?
Forum: 2nd Generation S-series (1995-2005) Tech
06-03-2008, 07:34 PM
Replies: 10
Views: 3,226
Posted By xAnarChisTx

RE: Won't Hot Start, Maybe Bad Fuel Pump?

Alright, I installed the ICM, but I am still having problems starting. I now believe that it is the fuel pump. I sprayed some starter fluid into the intake, and when I attempted to start it, it...
Forum: 2nd Generation S-series (1995-2005) Tech
06-03-2008, 05:48 PM
Replies: 10
Views: 3,226
Posted By xAnarChisTx

RE: Won't Hot Start, Maybe Bad Fuel Pump?

Well, I went to get the ICM tested, and on the first 3 times it tested bad. Hopefully this is the cause of my problems.
Forum: 2nd Generation S-series (1995-2005) Tech
06-03-2008, 04:56 PM
Replies: 10
Views: 3,226
Posted By xAnarChisTx

RE: Won't Hot Start, Maybe Bad Fuel Pump?

Well, like i said, there is no sound coming from the fuel pump, so is that related to the ICM?

I am going today to get the ICM tested, so well see what happens with that.

I have a 2001 GMC...
Forum: 2nd Generation S-series (1995-2005) Tech
06-03-2008, 02:25 PM
Replies: 10
Views: 3,226
Posted By xAnarChisTx

RE: Won't Hot Start, Maybe Bad Fuel Pump?

Now, where abouts is the ICM located? I don't have my manual at the moment. Oh, and I have a 2001 GMC Jimmy.
Forum: 2nd Generation S-series (1995-2005) Tech
06-03-2008, 01:45 PM
Replies: 10
Views: 3,226
Posted By xAnarChisTx

Won't Hot Start, Maybe Bad Fuel Pump?

Hey all,

My Jimmy will cold start just fine, but after driving around for a while, then turn the engine off, it doesn't want to start. It cranks, just doesn't start.

Now, one thing that...
Forum: 2nd Generation S-series (1995-2005) Tech
04-23-2007, 12:02 AM
Replies: 1
Views: 7,105
Posted By xAnarChisTx

CTSY LP Fuse Keeps Blowing Out. Please Help!!!

Hey everyone. I am having problems with my CTSY LP fuse (10A) blowing out. When this happens, my reading lights, dome lights, 4x4 buttons, and keyless entry goes out. Now, I have tried to figure out...
Showing results 1 to 22 of 22


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands