Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: cannibal440
Showing results 1 to 14 of 14
Search took 0.00 seconds.
Forum: The Lounge
04-22-2008, 09:24 AM
Replies: 516
Views: 39,683
Posted By cannibal440

RE: What Does Everyone Do For a Living??

i am in maintenance/engineering for cummins. part time i am starting an aerial photography business using radio controlled helicopters.
Forum: Performance & Brainstorming
03-18-2008, 10:47 AM
Replies: 4
Views: 3,706
Posted By cannibal440

RE: performance ignition control module icm replacement

i just got back from autozone and the icm tested good. before it died on me i had the airbox off but ive doublechecked and dont see any loose wires.
Forum: Performance & Brainstorming
03-17-2008, 06:58 PM
Replies: 4
Views: 3,706
Posted By cannibal440

RE: performance ignition control module icm replacement

http://static.summitracing.com/global/images/prod/large/acc-35362_w.jpg

yup sure enough accel makes an ICM. heres some info i found about it. when i go to autozone tomorrow if it is indeed bad i...
Forum: Performance & Brainstorming
03-17-2008, 01:30 PM
Replies: 4
Views: 3,706
Posted By cannibal440

performance ignition control module icm replacement

the ignition control module went bad on my bravada and i got a $35 replacement from autozone. i think the new one has went bad after a few days. im going to have it checked tomorrow and if it is bad...
Forum: Steering, Suspension & Drivetrain
03-06-2008, 10:30 AM
Replies: 4
Views: 4,744
Posted By cannibal440

RE: how to figure out gear ratio for front axle

that sticker was gone. guy at the salvage yard said its somewhere in the back as well.

i looked on the original window sticker from the dealer and it says RR 3.73
i need the front assembly.
...
Forum: Steering, Suspension & Drivetrain
03-06-2008, 09:59 AM
Replies: 4
Views: 4,744
Posted By cannibal440

how to figure out gear ratio for front axle

i have a 93 oldsmobile bravada and i need to replace the axle assembly. anyone got any pointers on where that information is located? it should be identical to the gearing in the rear end right?
Forum: Steering, Suspension & Drivetrain
03-04-2008, 11:55 AM
Replies: 4
Views: 16,297
Posted By cannibal440

RE: front end binding up in 4WD while turning?

if they bind up can you go in reverseto prevent damage?
Forum: Engine & Transmission
03-03-2008, 01:43 PM
Replies: 10
Views: 3,760
Posted By cannibal440

RE: 1993 bravada 4.3 w CPI MAJOR engine issues???

i found the idling problem. while troubleshooting it i was monkeying with this collar under the distributor cap. i accidently retarded the timing of the motor. after turning that collar about 6 or 7...
Forum: Engine & Transmission
03-02-2008, 11:34 AM
Replies: 10
Views: 3,760
Posted By cannibal440

RE: 1993 bravada 4.3 w CPI MAJOR engine issues???

the icm was located under the distributor cap. i took it out and took it to autozone. they tested it and it was bad.
i bought a replacement and installed it. now the vehicle will start if i push...
Forum: Engine & Transmission
03-01-2008, 05:01 PM
Replies: 10
Views: 3,760
Posted By cannibal440

RE: 1993 bravada 4.3 w CPI MAJOR engine issues???

i replaced the cv joints. only thing removed is the front driveshaft. everything else is in place. oil is clean with no gas in it

where is the icm located? do i take it to autozone and can they...
Forum: Engine & Transmission
03-01-2008, 03:35 PM
Replies: 10
Views: 3,760
Posted By cannibal440

RE: 1993 bravada 4.3 w CPI MAJOR engine issues???

today it iswarmer outside and i bought a fuel pressure gauge and engine compression gauge. i went outside and hooked the fuel pressure gauge up and turned the car on and it charged up to a little...
Forum: Engine & Transmission
02-26-2008, 01:40 PM
Replies: 10
Views: 3,760
Posted By cannibal440

RE: 1993 bravada 4.3 w CPI MAJOR engine issues???

when an engine backfires like that can it damage the valves? i know valves are spring return and pressure buildup of that magnitude would make me believe that it could force the valves open. this...
Forum: Engine & Transmission
02-26-2008, 12:36 PM
Replies: 10
Views: 3,760
Posted By cannibal440

RE: 1993 bravada 4.3 w CPI MAJOR engine issues???

this weekend i was planning on buying a fuel pressure gauge. ill get a compression gauge as well. exactly what numbers should i look for psi wise? for fuel and rings.
Forum: Engine & Transmission
02-26-2008, 10:38 AM
Replies: 10
Views: 3,760
Posted By cannibal440

1993 bravada 4.3 w CPI MAJOR engine issues???

I bought an oldsmobile bravada from someone i know. they bought it brand new back in 92 and they drove it until it had 219,000 miles on it. it started making a popping noise in the drivetrain and...
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands