Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Johnnyboy
Showing results 1 to 12 of 12
Search took 0.00 seconds.
Forum: 1st Generation S-series (1983-1994) Tech
10-07-2011, 10:23 PM
Replies: 28
Views: 4,037
Posted By Johnnyboy

Great I missed that part ?? LOL

Great I missed that part ?? LOL
Forum: 1st Generation S-series (1983-1994) Tech
10-06-2011, 11:14 PM
Replies: 16
Views: 14,781
Posted By Johnnyboy

If your label is intact it will state R-12 or...

If your label is intact it will state R-12 or R134. I have a 94 S-10 with an R-12 system. As Dmorse87 says they started fazing R12 out in some 94 & later models. You would need to convert to R12 &...
Forum: 1st Generation S-series (1983-1994) Tech
10-06-2011, 10:45 PM
Replies: 11
Views: 2,349
Posted By Johnnyboy

Try this link Truck Repair: 94 S-10 Blazer won't...

Try this link Truck Repair: 94 S-10 Blazer won't start, reading postings, side firewall (http://en.allexperts.com/q/Truck-Repair-2233/94-S-10-Blazer-1.htm)

If the fuel line is not clogged up...
Forum: 1st Generation S-series (1983-1994) Tech
10-06-2011, 09:58 PM
Replies: 4
Views: 1,408
Posted By Johnnyboy

Had the same problem. As Magmotor says the...

Had the same problem. As Magmotor says the Encoder Switch might forget what position it's in. Try his fix first. Unfortunately it's not a servicable Part if it is bad. My Codes kept showing an...
Forum: 1st Generation S-series (1983-1994) Tech
10-06-2011, 09:45 PM
Replies: 28
Views: 4,037
Posted By Johnnyboy

FYI if you jacked up the front and tryed to moved...

FYI if you jacked up the front and tryed to moved the tire in, out, up, down with very minimal play I would look elseware. I just replaced my Torson bar mounts the left side was clunking & I would...
Forum: General Tech Help
10-16-2006, 11:32 PM
Replies: 14
Views: 1,647
Posted By Johnnyboy

RE: Need suggestions for body decal removal

3-M sells a decal remover pad. It attaches to a drill & rubs the decal off without damaging the paint. Works great. It's called Scotch-Brite Molding Adhesive & Stripe Removal Disk. It comes in 4" &...
Forum: General Tech Help
03-21-2006, 12:41 AM
Replies: 2
Views: 761
Posted By Johnnyboy

RE: Wiper, radio Question

If you can hear your wiper motor running then it's just a fluke because you removed the fuse. That would have nothing to do with the wipers not working if the motor is running. Look through the cowl...
Forum: 2nd Generation S-series (1995-2005) Tech
03-20-2006, 03:09 PM
Replies: 9
Views: 1,347
Posted By Johnnyboy

RE: Best FIX IT book

Helm is the best. You need two, one for emission/electrical & one for general service. They are expensive around $80.00 ea. But well worth it if your going to keep the vehicle for any length of time...
Forum: General Tech Help
03-20-2006, 02:47 PM
Replies: 14
Views: 21,110
Posted By Johnnyboy

RE: ABS light?

Just my 2 cents worth. Like all computer controlled stuff on the vehicle, you can check for any error codes stored in the BPMV (brake pressure modulator valve) located on the inside left side of the...
Forum: 2nd Generation S-series (1995-2005) Tech
03-20-2006, 01:54 PM
Replies: 5
Views: 1,261
Posted By Johnnyboy

RE: 4X4 question?

On my 94 when you jump the DLC plug, the 4x4 lights on your selector switch will flash, just like the check engine service light for the engine when checking engine codes. Again I'm not sure on the...
Forum: 2nd Generation S-series (1995-2005) Tech
03-19-2006, 09:31 PM
Replies: 5
Views: 1,261
Posted By Johnnyboy

RE: 4X4 question?

First you need to know if the 4x4 is engaging. Both lights should not be on together. After you push 4 wheel high & both lights are on. Is it in 4 wheel drive? If not put the transmission in nuetral...
Forum: General Tech Help
03-18-2006, 01:24 PM
Replies: 5
Views: 1,624
Posted By Johnnyboy

RE: 95 blazer 4x4 problem

I have a 94 Blazer w/an automatic & 233 transfer case. I assume your 95 has an electronic shift 4x4. If so they should be the same. If you get a trouble code 2 when you ground pins J & A then code #2...
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands