Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: jnail
Showing results 1 to 23 of 23
Search took 0.01 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
02-24-2013, 10:21 AM
Replies: 1
Views: 2,858
Posted By jnail

1998 chevy blazer transmission help

Hi, I posted on this before, but my issue is still not resolved because it has been cold, and the blazer has been sitting since my first attempt. I'll give you a run down of what I have done so far....
Forum: 2nd Generation S-series (1995-2005) Tech
01-06-2013, 08:27 PM
Replies: 3
Views: 1,156
Posted By jnail

The filter hasn't been changed since I have owned...

The filter hasn't been changed since I have owned it. That has been about 4 years now. No idea before that. The check engine light is not on, but I don't have access to a scanner, so I don't know of...
Forum: 2nd Generation S-series (1995-2005) Tech
01-06-2013, 07:02 PM
Replies: 3
Views: 1,156
Posted By jnail

98' blazer shifting issues after replacing transfer case switch

Hi, 2 days ago I posted about ATF in the vacuum line to the front axle actuator. I went ahead and replaced that yesterday, and that part is good. the axle locks now like it should. At the same time...
Forum: 2nd Generation S-series (1995-2005) Tech
01-04-2013, 09:53 PM
Replies: 3
Views: 3,684
Posted By jnail

Thanks, the leaky switch is kind of what I...

Thanks, the leaky switch is kind of what I thought after searching some other threads, so i will go get a new one in the morning. As far as the HVAC, I haven't had any problems with it yet. I will...
Forum: 2nd Generation S-series (1995-2005) Tech
01-04-2013, 04:19 PM
Replies: 3
Views: 3,684
Posted By jnail

'98 blazer front axle actuator full of atf.

Hi. I have been having problems with the front axle not always wanting to lock, especially when it is really cold out on my '98 blazer. So I took out the actuator that locks the front axle this...
Forum: 2nd Generation S-series (1995-2005) Tech
10-09-2012, 06:35 PM
Replies: 2
Views: 2,999
Posted By jnail

98 blazer P0300 and P1345 help

Hi, I have a 98 blazer that has had alot of engine noise for several years now, but usually runs fairly well. The other night I was driving, and it started misfiring pretty badly, and started...
Forum: 2nd Generation S-series (1995-2005) Tech
01-12-2012, 01:31 PM
Replies: 2
Views: 1,115
Posted By jnail

98 blazer...what does the door pin do?

I have a 98 blazer, and when I got in and drove off this morning, the interior lights did'nt go off. So thinking that the problem might be with the driver's door pin switch, I pulled it out. Well,...
Forum: 2nd Generation S-series (1995-2005) Tech
07-13-2011, 04:44 PM
Replies: 4
Views: 2,598
Posted By jnail

This didn't really address my question about why...

This didn't really address my question about why the ACT fuse is blowing, and what it is actually connected to.
Forum: 2nd Generation S-series (1995-2005) Tech
07-12-2011, 10:32 PM
Replies: 4
Views: 2,598
Posted By jnail

'98 4wd problems

I have a '98 blazer that has had some issues with the 4wd shifting that have seem to have gotten worse today. The problem started with the lights on the buttons just turning off (all of them) after...
Forum: 2nd Generation S-series (1995-2005) Tech
01-27-2011, 02:59 PM
Replies: 1
Views: 642
Posted By jnail

98 blazer fuel guage help

Hi, I read the sticky post on the 98+ fuel guage problems, and do not have all the equipment to preform all the tests listed. My fuel guage is pinned passed full, so I am hoping that It is just a...
Forum: 2nd Generation S-series (1995-2005) Tech
06-14-2010, 04:29 PM
Replies: 2
Views: 904
Posted By jnail

trailer wiring problems

I have the factory installed trailer wiring hooked up on my 98 blazer. But I lost the left turn signal, and there is no power to the yellow wire when the turn signal is on. I tried tracing the wires...
Forum: 2nd Generation S-series (1995-2005) Tech
10-14-2009, 03:25 PM
Replies: 3
Views: 11,925
Posted By jnail

checking codes without scan tool?

Is there a way to check the trouble codes on these blazers without having a scan tool?

with the jeep I used to have, you could turn the key off and on a certain number of times, and it would flash...
Forum: 2nd Generation S-series (1995-2005) Tech
10-14-2009, 03:22 PM
Replies: 0
Views: 1,646
Posted By jnail

'98 blazer coming out of overdrive

My 98 blazer recently started shifting in and out of overdrive below 60mph. It seems like it doesn't know if it wants to be in that gear or not. Doesn't feel like slipping, fluid is ful and good...
Forum: 2nd Generation S-series (1995-2005) Tech
09-05-2009, 10:13 AM
Replies: 10
Views: 8,986
Posted By jnail

the jb weld didn't work, the gear cracked again...

the jb weld didn't work, the gear cracked again when I pressed it on to the metal part.
I am going to try something else.

as far as getting the actuator out, I found a great tool at a car swap...
Forum: 2nd Generation S-series (1995-2005) Tech
09-02-2009, 11:46 PM
Replies: 10
Views: 8,986
Posted By jnail

Ok, your ring Idea got my wheels turning. Here...

Ok, your ring Idea got my wheels turning. Here is where I'm at right now, I will keep you updated and let you know if it works.

1.got a hose clamp, crazy glued the gear back together. hose clamp...
Forum: Engine & Transmission
09-02-2009, 11:35 PM
Replies: 4
Views: 3,077
Posted By jnail

how do I unstick lifters?

how do I unstick lifters?
Forum: Engine & Transmission
09-01-2009, 08:15 PM
Replies: 4
Views: 3,077
Posted By jnail

98 blazer, valve noise?, low oil pressure?

I have a 98 blazer that had the engine replaced about 35,000 miles ago. Now it is making some noise that sounds to me like the noise that valves make when you run them with too little oil. BUT only...
Forum: 2nd Generation S-series (1995-2005) Tech
09-01-2009, 07:42 PM
Replies: 10
Views: 8,986
Posted By jnail

heat blend actuator help

I have a 98 blazer, and I tracked my heating problem to a busted gear in the actuator that controls the temperator door. I have the computer controlled system, which (figures) has an actuator that...
Forum: 2nd Generation S-series (1995-2005) Tech
03-04-2009, 11:15 AM
Replies: 2
Views: 1,238
Posted By jnail

brake bleeding

I am going to replace a stuck rear caliper on my 98 blazer. Will I need to bleed all 4 brake calipers or only the one I am replacing?
Forum: 2nd Generation S-series (1995-2005) Tech
12-30-2008, 07:52 PM
Replies: 12
Views: 3,752
Posted By jnail

RE: Heater/A/C question

Ok, thanks, If I only have lukewarm air coming out all the time,both my heater hoses are hot, and the rest of the controls seem to do what they are suppose to, is this the part I should look at next?...
Forum: 2nd Generation S-series (1995-2005) Tech
12-29-2008, 07:13 PM
Replies: 12
Views: 3,752
Posted By jnail

RE: Heater/A/C question

Is this the thing that operates the temp control door? If it is, where is it on my blazer....
Forum: 2nd Generation S-series (1995-2005) Tech
12-27-2008, 09:16 PM
Replies: 3
Views: 15,518
Posted By jnail

RE: Electronic Air/Heat Control Continous Cycling

can someone describe to me what the b+ fuse is, and what how to do this procedure?
Forum: 2nd Generation S-series (1995-2005) Tech
12-27-2008, 08:57 PM
Replies: 12
Views: 60,567
Posted By jnail

RE: 2001 Chev. Blazer No heat!!!

that hose that was unhooked on yours was pretty rotted on mine, so i replaced it, but where does it go after it disapears into the fender? I also have very little heat, but both my hoses are hot, and...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands