Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: s_stevens
Showing results 1 to 12 of 12
Search took 0.00 seconds.
Forum: General Tech Help
11-02-2006, 08:59 AM
Replies: 5
Views: 5,251
Posted By s_stevens

RE: Electrical, possibly fuses.

My GF's power locks quit working from the panel on the doors, had to use the remote all the time. There was a penny that fell in the cig lighter and blew a fuse. A friend of mines radio quit one...
Forum: Steering, Suspension & Drivetrain
11-02-2006, 08:57 AM
Replies: 5
Views: 19,866
Posted By s_stevens

RE: 4L60E Transmission won't shift

The 4l60E is electronically controlled. No cables. The computer gets information from the engine and decides what gear to go in. I would take it to the transmission shop and have them put in a...
Forum: General Tech Help
10-29-2006, 09:35 AM
Replies: 43
Views: 8,776
Posted By s_stevens

RE: Maybe Fuel Pump maybe Timing???

I am not sure if that truck has it or not, but a LOT of fuel injected cars have a collision detector that will turn off the fuel pump if it detects a collision. I get a lot of cars that just quit...
Forum: General Tech Help
10-25-2006, 08:48 AM
Replies: 4
Views: 1,394
Posted By s_stevens

RE: To fix or not to fix.

I wouldn't put stop leak in it. Ride it out until spring time then replace the front and rear main seal. If you are going to do it yourself without a lift, count on a weekend to do it in case you...
Forum: General Tech Help
10-23-2006, 08:48 AM
Replies: 3
Views: 4,448
Posted By s_stevens

RE: 93 jimmy code 43

Check your drivers side Knock sensor. That connector has a habit of getting old and cracking then the wire falls out. Also, if you "played" with the plug wires lately it could have been knocked...
Forum: General Tech Help
10-05-2006, 08:43 AM
Replies: 3
Views: 655
Posted By s_stevens

RE: 93 chevy blazer s-10

Mine did that one day. Got to work, went to make the bank deposit and it quit at a stop light. Luckily a friend of mine with the police department came by and helped me push it out of the road and...
Forum: General Tech Help
10-01-2006, 10:35 AM
Replies: 2
Views: 1,016
Posted By s_stevens

RE: SES flashing was bad cap/rotor/wires

Did you use spark plug wire grease in the boots? When I replace a set, sometimes it's hard to get the wires to SNAP on the cap becuase there's a good bit of grease in there. That keeps the...
Forum: General Tech Help
09-26-2006, 08:46 PM
Replies: 11
Views: 1,290
Posted By s_stevens

RE: 93 4.3L spededometer not working

If all those guages stopped when you did the transmission, check the guage fuse, and check to make sure you did not pinch any wires between the block and transmission bell housing.
Forum: General Tech Help
09-22-2006, 09:13 AM
Replies: 7
Views: 1,613
Posted By s_stevens

RE: I have a few questions on my 92 Blazer

1st thing, your sensor. That is the knock sensor. My plastic cover was broken and the wire fell out one day while driving along. Without the knock sensor you get 0 advance! The truck just felt...
Forum: General Tech Help
09-22-2006, 09:03 AM
Replies: 4
Views: 1,136
Posted By s_stevens

RE: vortec engine

I have a 93 blazer with the vortec and it has the 4l60e. Look at your throttle hookup. 1 cable goes to the gas peddle the other cable goes to the cruise control. I don't think there's room for the...
Forum: General Tech Help
09-13-2006, 09:10 AM
Replies: 16
Views: 2,167
Posted By s_stevens

RE: fluctuating idle.

Mine has been doing the same thing. Since I have extra parts laying around, I started throwing sensors at it. Serious waste of time (glad I had the parts off a dead engine I am replacing for...
Forum: General Tech Help
09-04-2006, 10:04 PM
Replies: 15
Views: 1,133
Posted By s_stevens

RE: 93 blazer tranny stuck PLz help

put your jack at the back of the transmission, jack it up (a little at a time) and let the jack on the engine down (a little at a time). That should split the bellhousing and engine. How many bolts...
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands