Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Joshua1023
Showing results 1 to 34 of 34
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
07-24-2012, 06:07 AM
Replies: 5
Views: 886
Posted By Joshua1023

Do you actually have a spark at number three? Did...

Do you actually have a spark at number three? Did you change the plugs yourself? The only reason I ask is that number three is a bear to get to sometimes and someone may have skipped it, snapped it,...
Forum: 2nd Generation S-series (1995-2005) Tech
07-23-2012, 07:50 PM
Replies: 5
Views: 886
Posted By Joshua1023

Is it running rough? Any noticeable difference in...

Is it running rough? Any noticeable difference in idle when you pull number 3 wire?
Forum: 2nd Generation S-series (1995-2005) Tech
07-23-2012, 07:41 PM
Replies: 24
Views: 5,461
Posted By Joshua1023

So now I'm really kind of bummed out. I ran the...

So now I'm really kind of bummed out. I ran the check for pressure and bleed down at the filter and that was fine. Then I headed back up to the fuel rail to check the plenum again and that is...
Forum: 2nd Generation S-series (1995-2005) Tech
07-22-2012, 07:39 AM
Replies: 24
Views: 5,461
Posted By Joshua1023

Converter wouldn't cause the pressure to bleed...

Converter wouldn't cause the pressure to bleed out in the fuel system.
Forum: 2nd Generation S-series (1995-2005) Tech
07-21-2012, 06:54 PM
Replies: 24
Views: 5,461
Posted By Joshua1023

Thank you so much. I'll check back in w/ what I...

Thank you so much. I'll check back in w/ what I find tomorrow.
Forum: 2nd Generation S-series (1995-2005) Tech
07-21-2012, 06:27 AM
Replies: 24
Views: 5,461
Posted By Joshua1023

So the setup shown is so that you can hook up at...

So the setup shown is so that you can hook up at the fuel filter and check it for max pressure AND regulated pressure, but if I just dead ended it at the filter I could still check for my regulated...
Forum: 2nd Generation S-series (1995-2005) Tech
07-20-2012, 06:45 AM
Replies: 24
Views: 5,461
Posted By Joshua1023

I did, but I am a little confused as to the part...

I did, but I am a little confused as to the part w/ the T-shaped gauge. If I don't have the quick connect type of fuel lines, does that apply to me, or must I just find a way to adapt the gauge to...
Forum: 2nd Generation S-series (1995-2005) Tech
07-20-2012, 05:43 AM
Replies: 24
Views: 5,461
Posted By Joshua1023

Hey thanks guys. To dead end the fuel at the...

Hey thanks guys. To dead end the fuel at the filter do I just unhook the fuel filter and attach the gauge to the line? Is there a special adapter available just for this application?
Forum: 2nd Generation S-series (1995-2005) Tech
07-19-2012, 09:31 PM
Replies: 24
Views: 5,461
Posted By Joshua1023

Am I allowed to bump my own thread?:icon_razz:

Am I allowed to bump my own thread?:icon_razz:
Forum: 2nd Generation S-series (1995-2005) Tech
07-17-2012, 07:22 PM
Replies: 24
Views: 5,461
Posted By Joshua1023

2000 Jimmy Fuel Pressure Question

My truck has a mild rough idle. Recently it has started fairly regularly showing a lack of power on the low end. Every once in a while if you start it up from a cold start and pull out right away,...
Forum: Audio/Video Electronics
06-13-2012, 05:44 PM
Replies: 4
Views: 785
Posted By Joshua1023

No problem. I've been a member on a lot of...

No problem. I've been a member on a lot of different forums. I know how it works.
Forum: Audio/Video Electronics
06-13-2012, 06:34 AM
Replies: 4
Views: 785
Posted By Joshua1023

Sure I'm using the harness. It only ever makes...

Sure I'm using the harness. It only ever makes sense. I haven't butchered a factory harness since I was 16. I learned my lesson real quick on that one.

After I posted yesterday I did some more...
Forum: Audio/Video Electronics
06-12-2012, 06:23 PM
Replies: 3
Views: 905
Posted By Joshua1023

I just got these. They dropped right in, easy.

I just got these. They dropped right in, easy.
Forum: Audio/Video Electronics
06-12-2012, 05:26 PM
Replies: 4
Views: 785
Posted By Joshua1023

Wiring help

This may sound like a silly question, but here it goes anyway,

I just purchased a Clarion NX501 (http://www.sonicelectronix.com/item_35578_Clarion-NX501-NX-501.html) head unit for my 2000 jimmy....
Forum: 2nd Generation S-series (1995-2005) Tech
06-10-2012, 09:00 PM
Replies: 2
Views: 723
Posted By Joshua1023

I found this to be really helpful....

I found this to be really helpful. (http://www.handymanlyness.com/archives/auto/repair/engine_mech/intake_manifold/GM_truck/gasket_replace_99_Jimmy.html) I just did mine this weekend. Wasn't too bad...
Forum: 2nd Generation S-series (1995-2005) Tech
06-10-2012, 07:24 AM
Replies: 11
Views: 3,169
Posted By Joshua1023

I've been doing a bunch of research on it, since...

I've been doing a bunch of research on it, since I saw the issue. I saw a ton of pics on the internet that were way worse than mine. Although the LIM and the inside of the valve cover gaskets were...
Forum: 2nd Generation S-series (1995-2005) Tech
06-08-2012, 09:04 PM
Replies: 11
Views: 3,169
Posted By Joshua1023

OH,,,OK. That's a great idea. You've probably...

OH,,,OK. That's a great idea. You've probably given that advise dozens of times.

I was just gonna take off the lower radiator hose and put a garden hose in the top of the radiator and turn the...
Forum: 2nd Generation S-series (1995-2005) Tech
06-08-2012, 07:44 PM
Replies: 11
Views: 3,169
Posted By Joshua1023

So of course you guys were right. It was the LIM...

So of course you guys were right. It was the LIM gasket. Thanks.

I changed it today w/ the recommended FelPro.

Once I got the LIM off, I was really surprised by the amount of gunk in the...
Forum: 2nd Generation S-series (1995-2005) Tech
05-31-2012, 09:00 PM
Replies: 11
Views: 3,169
Posted By Joshua1023

Crap!! I was really hoping it was the water pump....

Crap!! I was really hoping it was the water pump. What's the average shop bill for this repair?
Forum: 2nd Generation S-series (1995-2005) Tech
05-31-2012, 08:05 PM
Replies: 11
Views: 3,169
Posted By Joshua1023

Antifreeze dumping after parked

I just bought this truck a couple of weeks ago. Slowly I've been working through any perceived issues I have w/ it.

I have been getting a really slight antifreeze smell outside of the vehicle but...
Forum: 2nd Generation S-series (1995-2005) Tech
05-30-2012, 08:37 PM
Replies: 8
Views: 1,069
Posted By Joshua1023

Does your right turn signal work in the front of...

Does your right turn signal work in the front of the truck? If so, you probably have corrosion in the sockets due to water getting in the rear housing.
Forum: 2nd Generation S-series (1995-2005) Tech
05-30-2012, 08:18 PM
Replies: 8
Views: 19,062
Posted By Joshua1023

I'd start w/ a multi meter. Should be pretty self...

I'd start w/ a multi meter. Should be pretty self evident if the motor runs, but doesn't power the arm.

First check the wires at the wiper motor. If you've got power, its not a fuse.

If no...
Forum: 2nd Generation S-series (1995-2005) Tech
05-29-2012, 04:59 PM
Replies: 4
Views: 724
Posted By Joshua1023

I've had the belt deal happen to several vehicles...

I've had the belt deal happen to several vehicles where I couldn't seem to quite it down. Had it to the mechanic to check that all pulleys are in line. 2 months later it would start squeaking again....
Forum: Audio/Video Electronics
05-29-2012, 04:45 PM
Replies: 71
Views: 49,152
Posted By Joshua1023

Thanks, that kind of sets my mind at ease if you...

Thanks, that kind of sets my mind at ease if you have one at the exact same spot. It does look like a solder point or something. Time will tell.
Forum: Audio/Video Electronics
05-29-2012, 10:20 AM
Replies: 4
Views: 1,943
Posted By Joshua1023

Nice,,,, so no mounting kit needed?

Nice,,,, so no mounting kit needed?
Forum: Audio/Video Electronics
05-29-2012, 10:16 AM
Replies: 71
Views: 49,152
Posted By Joshua1023

I just got back from my local U-Pull-It w/ an...

I just got back from my local U-Pull-It w/ an upgraded overhead display. I'm gonna be doing the double din upgrade for the truck here in the next few weeks and will do the overhead display at the...
Forum: 2nd Generation S-series (1995-2005) Tech
05-28-2012, 09:53 PM
Replies: 5
Views: 1,369
Posted By Joshua1023

Hey thanks. I have manual then. Apparently it...

Hey thanks. I have manual then. Apparently it makes a difference when ordering the blower motor.
Forum: 2nd Generation S-series (1995-2005) Tech
05-28-2012, 05:07 AM
Replies: 33
Views: 69,462
Posted By Joshua1023

I had one right there that turned out to be the...

I had one right there that turned out to be the line that delivers windshield washer fluid the the sprayer on the hood that fell out and was just sitting there.
Forum: 2nd Generation S-series (1995-2005) Tech
05-28-2012, 05:03 AM
Replies: 5
Views: 1,369
Posted By Joshua1023

I'm gonna change out the motor this week and see...

I'm gonna change out the motor this week and see if that is the ticket. I went for the first semi long ride in the truck since I bought it and it turns out the noise stops every once in a while and...
Forum: 2nd Generation S-series (1995-2005) Tech
05-26-2012, 04:59 PM
Replies: 26
Views: 42,232
Posted By Joshua1023

$8 with free shipping from Amazon....

$8 with free shipping from Amazon. (http://www.amazon.com/gp/product/B003ELVHT0/ref=oh_details_o00_s00_i00)
Forum: 2nd Generation S-series (1995-2005) Tech
05-24-2012, 09:08 PM
Replies: 5
Views: 1,369
Posted By Joshua1023

I know its not a big deal to get to the motor on...

I know its not a big deal to get to the motor on these trucks. I think maybe an hour. More than likely I will open her up just to see what I can see.

Anyone know if there is a way to test the...
Forum: 2nd Generation S-series (1995-2005) Tech
05-24-2012, 08:20 PM
Replies: 5
Views: 1,369
Posted By Joshua1023

Blower Noise on Max AC

I have a 2000 Jimmy SLT,

My blower always makes a mild, barely noticeable, "ticking" sound when you turn on the heat and on standard AC. When you turn the control to "Max AC" it gets noticeably...
Forum: Paint, Body, & Interior
05-22-2012, 04:49 AM
Replies: 2
Views: 3,008
Posted By Joshua1023

I called all the scrap yards in my area up to an...

I called all the scrap yards in my area up to an hour away yesterday. I was looking for the whole door panel. None had any in my color. The only other alternative would be to buy one of a different...
Forum: Paint, Body, & Interior
05-21-2012, 08:13 PM
Replies: 2
Views: 3,008
Posted By Joshua1023

Drivers Door Arm Rest All Busted and What Not

Hello All. First Post here. I've already gained tons of info from this site just by lurking for the last week or so.

I bought a 2000 Jimmy SLT for my wife. It is in overall good shape, but there...
Showing results 1 to 34 of 34


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands