Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Eric D
Showing results 1 to 13 of 13
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
08-23-2012, 10:08 AM
Replies: 40
Views: 38,293
Posted By Eric D

Sure, send me a PM with your email address.

Sure, send me a PM with your email address.
Forum: 2nd Generation S-series (1995-2005) Tech
08-04-2011, 08:43 AM
Replies: 40
Views: 38,293
Posted By Eric D

Yes, I would definitly replace the orifice tube. ...

Yes, I would definitly replace the orifice tube. They are very inexpensive.

Also, you always want to replace the accumulator every time you open up the system. It has a desicant bag inside that...
Forum: 2nd Generation S-series (1995-2005) Tech
08-03-2011, 02:29 PM
Replies: 40
Views: 38,293
Posted By Eric D

The soft rubber is on the outside. Mine was...

The soft rubber is on the outside. Mine was actually a little dried out as well and it crumbled in a few places, but I just used some duct tape over those spots and along the line I cut when I put it...
Forum: 2nd Generation S-series (1995-2005) Tech
06-27-2011, 05:03 PM
Replies: 1
Views: 4,553
Posted By Eric D

Well, having no idea what it invloved, I decided...

Well, having no idea what it invloved, I decided to pay I guy at the junk yard to remove my old glass and install the new (old) glass. The junk yard charged me $50 for the glass and $35 to remove it...
Forum: 2nd Generation S-series (1995-2005) Tech
06-25-2011, 07:54 PM
Replies: 9
Views: 5,131
Posted By Eric D

Yes, often when the compressor fails, it is a...

Yes, often when the compressor fails, it is a "catostrophic" failure. Small metal particles from the inside of the compressor will cirulate through the system. I replaced every component in the...
Forum: 2nd Generation S-series (1995-2005) Tech
06-25-2011, 07:40 PM
Replies: 1
Views: 4,553
Posted By Eric D

Replacing Rear Quarter Glass (4-Door)

Has anyone replaced the rear quarter glass?

I can get the glass from a junk yard; I'm looking for tips on installing it.
Forum: 2nd Generation S-series (1995-2005) Tech
06-21-2011, 04:35 PM
Replies: 40
Views: 38,293
Posted By Eric D

I re-inserted the link

Welcome to Kodak Gallery!...
Forum: 2nd Generation S-series (1995-2005) Tech
06-20-2011, 08:05 AM
Replies: 40
Views: 38,293
Posted By Eric D

I used a utility knife and razor blade to cut the...

I used a utility knife and razor blade to cut the soft rubber outer housing, and attached a bungie cord to the hard plastic inner case to pull the side facing the engine apart. In one of the pics you...
Forum: 2nd Generation S-series (1995-2005) Tech
11-21-2010, 06:55 PM
Replies: 40
Views: 38,293
Posted By Eric D

I did this job without removing a lot of the...

I did this job without removing a lot of the things the service manual says, but I did cut the soft rubber outer housing in one place to get it out of the way. I used a bugie cord to hold the hard...
Forum: 2nd Generation S-series (1995-2005) Tech
11-05-2010, 07:42 AM
Replies: 40
Views: 38,293
Posted By Eric D

Anybody?

Anybody?
Forum: 2nd Generation S-series (1995-2005) Tech
11-02-2010, 05:39 PM
Replies: 7
Views: 2,198
Posted By Eric D

It looks like a previous owner may have put a...

It looks like a previous owner may have put a "stop leak" in the system. That is the brown "gunk" you are talking about. By flushing the system, you removed some of it and got the leak back.
Forum: 2nd Generation S-series (1995-2005) Tech
11-02-2010, 05:32 PM
Replies: 2
Views: 2,704
Posted By Eric D

I have a 97 Blazer LT. I get the tone when the...

I have a 97 Blazer LT. I get the tone when the driver door is open and the key is in the ignition, whether it is off, accessory, or on.
Forum: 2nd Generation S-series (1995-2005) Tech
11-01-2010, 11:54 PM
Replies: 40
Views: 38,293
Posted By Eric D

1997 Blazer A/C Evaporator Replacement

I need to replace the evaporator. There is a soft rubber outer case, and a hard plastic inner case that surrounds it.

Can I get the soft rubber case out of the way and spilt the hard plastic...
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands