Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: roycet4
Showing results 1 to 23 of 23
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
01-14-2013, 11:06 AM
Replies: 3
Views: 2,512
Posted By roycet4

Me too.....

I'd be interested in what you find. I had to have my '97 towed last night, started coughing and stumbling up a storm last night, finally died but I was able to restart and keep the engine going long...
Forum: 2nd Generation S-series (1995-2005) Tech
01-09-2013, 02:02 PM
Replies: 2
Views: 5,496
Posted By roycet4

Diagnostic help with P0446

My Blazer, like others here has been giving off P0446, I have checked for rusted lines, broken hoses and replaced the gas cap and the evap solenoid, reset the computer and after about 200 miles P0446...
Forum: 2nd Generation S-series (1995-2005) Tech
08-13-2012, 09:33 AM
Replies: 8
Views: 10,641
Posted By roycet4

Thanks for the reply, I will check this for...

Thanks for the reply, I will check this for sure... I also have to check my temp sending unit as the guage is swinging all over the place...

good thing its a winter vehicle and not an every day...
Forum: 2nd Generation S-series (1995-2005) Tech
08-08-2012, 08:00 AM
Replies: 8
Views: 10,641
Posted By roycet4

I am very interested in this post... I have been...

I am very interested in this post... I have been chasing a vibration in my '97 since I bought it 3 years ago... its nice under 50mph, but over that I have a loud vibration sound coming from the...
Forum: 2nd Generation S-series (1995-2005) Tech
06-01-2011, 02:22 PM
Replies: 11
Views: 1,172
Posted By roycet4

Perfect timing for this thread

I just had a rear shackle let go too... thank you rustbelt of NH....

Rob44_90, if HondaOverCHEVY does not want yours I am interested...
Forum: 2nd Generation S-series (1995-2005) Tech
12-07-2010, 01:30 PM
Replies: 7
Views: 1,265
Posted By roycet4

try this site

http://www.bodyshopzone.com/archives/mechanical/door/hinge/pin_replace_1.html

its a nice tutorial.

Royce in NH
Forum: 2nd Generation S-series (1995-2005) Tech
10-19-2010, 06:38 PM
Replies: 4
Views: 16,591
Posted By roycet4

been there, done that..

12x1.75 50mm long Hardened bolts. The originals are 18mm hex head, I too needed to use a 17mm to take off a few of mine. My dealer did not have the bolts in stock but I was able to buy the bolts at a...
Forum: Steering, Suspension & Drivetrain
10-16-2010, 07:33 AM
Replies: 31
Views: 25,724
Posted By roycet4

my 97 blazer w/95K miles on it vibrates between...

my 97 blazer w/95K miles on it vibrates between 50-70mph and is LOUD, seems to be coming from the front end. I just replaced balljoints, drive axles, hubs to try to eliminate this and also because...
Forum: 2nd Generation S-series (1995-2005) Tech
10-05-2010, 04:46 AM
Replies: 32
Views: 14,505
Posted By roycet4

wrong hubs and dust shields

Might as well answer my own question.. The Chevy dealer had sold me dust shields for a AWD (either Blazer or Olds Bravada). A different parts guy noticed it right away. the correct dust shields have...
Forum: 2nd Generation S-series (1995-2005) Tech
10-04-2010, 12:57 PM
Replies: 32
Views: 14,505
Posted By roycet4

New Hub does not fit

I figured I would reply to this post and maybe get some advice. I have a 97 Blazer and am replacing the original hub bearings and dust shields. I bought new dust shield from my local Chevy dealer,...
Forum: 2nd Generation S-series (1995-2005) Tech
09-21-2010, 05:19 PM
Replies: 1
Views: 1,116
Posted By roycet4

Removing front drive axles

I have a '97 Blazer and have a very load humming vibration like noise from the front end over 60 mph and I suspect the hub bearings. I intend on replacing the hub bearings but also wanted to check...
Forum: 2nd Generation S-series (1995-2005) Tech
02-02-2010, 06:06 PM
Replies: 20
Views: 6,284
Posted By roycet4

go here.. ...

go here..

http://www.bodyshopzone.com/archives/mechanical/door/hinge/pin_replace_1.html

Royce.
Forum: 2nd Generation S-series (1995-2005) Tech
10-20-2009, 07:30 PM
Replies: 9
Views: 2,842
Posted By roycet4

I'm interested in this thread...

The front end on my '97 makes a humming too.. not too bad though until 60-70mph when it gets really loud in the passenger compartment. I've been thinking that its a wheel bearing.
Forum: Engine & Transmission
08-31-2009, 05:09 AM
Replies: 4
Views: 4,153
Posted By roycet4

Smile Perfect

SwartlkkThanks

I will go for either the GM or the Timken seal, too bad these autopart stores do not have this kind of information or if they do, know how to look it up..After this its on to...
Forum: Engine & Transmission
08-30-2009, 06:15 PM
Replies: 4
Views: 4,153
Posted By roycet4

opps..

4.3 liter 4wd Auto.

I went to VIP auto and the counter guy says the p/n of the Timken seal that I have when I told him what vehicle it was for...Maybe I take the original one off and the smaller...
Forum: Engine & Transmission
08-30-2009, 01:09 PM
Replies: 4
Views: 4,153
Posted By roycet4

RearTransmission output/driveshaft seal

My '97's output shaft/driveshaft seal is leaking. I purchased a new one from Autozone but the one I pruchased is too small. The original one is about 3" OD (flange) and has a rubber boot. I have been...
Forum: 2nd Generation S-series (1995-2005) Tech
07-10-2009, 01:42 PM
Replies: 50
Views: 112,976
Posted By roycet4

just replaced the starter in my '97

Just put a new starter in my '97 4x4 yesterday. had to cut the nuts off the old one (rusted), took off the right fron tire to get to the wires. Was not too bad but putting the new one in was much...
Forum: 2nd Generation S-series (1995-2005) Tech
06-30-2009, 04:39 AM
Replies: 17
Views: 6,210
Posted By roycet4

Unhappy My '97 will not start too..

Was it a full moon.. (or, too much rain in NE..)

History, '97 Blazer with 93K showing, purchased last November for a winter car and has been fine. Decided to drive it last night as its been...
Forum: 2nd Generation S-series (1995-2005) Tech
06-09-2009, 04:56 AM
Replies: 27
Views: 11,671
Posted By roycet4

more scanner info?

Sears is selling two scan tools, a Innova and a Actron (only have Sears p/n's). They both are $99 (reg $129).

They both seem like the will do the same thing, is one manufacturer better than the...
Forum: Engine & Transmission
01-20-2009, 07:20 PM
Replies: 6
Views: 9,097
Posted By roycet4

RE: Thermostat replacement...

Hi

I recently purchased a 97 Blazer with 90k miles for a winter vehicle, it has seems to run cool with my wife complaining that the heat was not hot enough, especially compared to my 1500HD, the...
Forum: 2nd Generation S-series (1995-2005) Tech
11-19-2008, 09:48 AM
Replies: 5
Views: 11,358
Posted By roycet4

RE: Service Manual

Thanks Kyle,

Yes, the link you just provided worked great. I just brought a 97 Monday night, was in one family, went from father to son and the son traded it in, I bought off a used dealer.. 90K...
Forum: 2nd Generation S-series (1995-2005) Tech
11-19-2008, 09:11 AM
Replies: 5
Views: 11,358
Posted By roycet4

RE: Service Manual

Kyle,
I'm on the GM site now trying to get an owners manual for a 1997 and cannot see any "link" or other way to get to download a manual. I am logged in and have entered my VIN number.

Do you...
Forum: 2nd Generation S-series (1995-2005) Tech
11-15-2008, 03:31 PM
Replies: 3
Views: 19,807
Posted By roycet4

RE: Blower Relay (With PIC)

What was your original issue?? I am looking to purchase a '97 and the fan does not come on at all. The guy selling it (buys them wholesale, fixed and resells) says its the relay. So I am now guessing...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands