Blazer Forum - Chevy Blazer Forums - Search Results

Community
Search
Search: Posts Made By: J_man01
Showing results 1 to 43 of 43
Search took 0.00 seconds.
09-25-2012, 02:39 PM
Replies: 0
Views: 688
Posted By J_man01

Lazy dealership????

I've been playing with my 99 S-10 p/u. I added the switch wiring harness and the other parts needed off of my doner 2000 blazer. So all I needed to do was go to my local dealership to get the BCM...
01-12-2012, 08:37 PM
Replies: 1
Views: 2,299
Posted By J_man01

Po446

I was getting a PO446 code I changed the vent on the cross memeber under the truck few days later the code came back. I didnt mess with it for a while do to the fact the motor in my daughters car...
10-21-2011, 08:05 PM
Replies: 2
Views: 1,784
Posted By J_man01

p0507

Fixed my evap codes today up until no was the only code i was getting. Now I got the p0507 code. I was looking around the intake and on the driver side of the intake next to the upper radiator hose...
10-18-2011, 04:54 PM
Replies: 0
Views: 2,124
Posted By J_man01

RKE Module

I'm battin 1000 here. Got the passlock problem fixed, poor heat issue is being addressed this weekend, and got the evap prob taken care of. Now for fun Im gonna see if I can get the RKE working. I'm...
10-18-2011, 04:46 PM
Replies: 9
Views: 1,252
Posted By J_man01

Bad Radiator, and the heater core was restricted....

Bad Radiator, and the heater core was restricted. Found a gm tech that will reconfig my bcm for a case of beer one day after work.
10-14-2011, 08:11 PM
Replies: 9
Views: 1,252
Posted By J_man01

ok Ill start there. Thanks

ok Ill start there. Thanks
10-14-2011, 07:58 PM
Replies: 9
Views: 1,252
Posted By J_man01

Thats what I though. Can this BCM be reprogrammed...

Thats what I though. Can this BCM be reprogrammed to the correct heating system?
10-14-2011, 07:50 PM
Replies: 9
Views: 1,252
Posted By J_man01

No Heat

Ok with the passlock problems behind me on to the next adventure. My 2000 blazer has poor to no heat. The BCM is out of a 2001 blazer with climate control where my 2000 just has standard a/c and heat...
10-14-2011, 02:06 PM
Replies: 8
Views: 1,763
Posted By J_man01

I'm geting no bcodes ive got a scanner that will...

I'm geting no bcodes ive got a scanner that will read them. I replaced the passlock sensor again it working fine for now so im getting rid of it before this crap happens again out of all the blazers...
10-04-2011, 04:31 PM
Replies: 8
Views: 1,763
Posted By J_man01

Im getting no b codes The 3 wires were part if...

Im getting no b codes The 3 wires were part if the ign switch the module is what the 3 wires plug into correct?
09-23-2011, 08:02 PM
Replies: 8
Views: 1,763
Posted By J_man01

Isnt that part of the ign switch?

Isnt that part of the ign switch?
09-23-2011, 07:17 PM
Replies: 8
Views: 1,763
Posted By J_man01

Passlock

Ok I've finally had it with my blazer and this stupid passlock. I've changed everything the pcm the bcm the ign switch the multifunction switch and I'm still having a no start situation once and a...
09-21-2011, 04:07 PM
Replies: 2
Views: 4,392
Posted By J_man01

Thanks Ill look into it this weekend.

Thanks Ill look into it this weekend.
09-19-2011, 05:20 PM
Replies: 2
Views: 4,392
Posted By J_man01

p0446 2000 2 dr blazer

This blazer has been an adventure. New bcm new pcm new knock sensor twice (cuz the dealer forgot to take the chip from the old pcm to the new pcm). Took a week for the computer to set so i could take...
05-01-2011, 03:34 PM
Replies: 0
Views: 611
Posted By J_man01

no start

OK my 2000 blazer has been a nightmare after taking ownership of it I chased down a number of problems the largest being replacing the BCM and PCM. After that everything was fine. Now in the last few...
01-18-2011, 04:53 PM
Replies: 1
Views: 2,831
Posted By J_man01

Po453

Got a code PO453 on my kids 98 Blazer. I haven't checked the harness yet. I'm just wondering where the sensor itself is. Thanks.
10-03-2010, 01:22 PM
Replies: 0
Views: 663
Posted By J_man01

no key pad

A friend of mine just bought a 2000 blazer. It doesn't have the key pad but if you lock it and open the door with the key the lights and horn go off. Is there anyway to disable this?
09-29-2010, 06:10 PM
Replies: 3
Views: 660
Posted By J_man01

I replaced the mutifunction and the ign switch....

I replaced the mutifunction and the ign switch. before i got the BCM figured out. The part that sucks is the BCM in my other blazer that im parting out was perfectly fine and couldn't use it.
09-13-2010, 08:41 PM
Replies: 3
Views: 660
Posted By J_man01

Problem solved the BCM was bad

Problem solved the BCM was bad
09-10-2010, 10:45 AM
Replies: 3
Views: 660
Posted By J_man01

Noticed other probs

I thought i stole my 2000 blazer for the price i paid for it starting to realize why i got it so cheap. First the lowbeams headlights will not shut off drls have been disabled at the relay. Auto on...
09-08-2010, 06:29 PM
Replies: 4
Views: 1,936
Posted By J_man01

ok i found the relay that controls the head...

ok i found the relay that controls the head lights with my test light i have found 2 wires in the same terminal both green with black tracers have constant power there is a black wire a yellow wire...
09-08-2010, 04:03 PM
Replies: 4
Views: 1,936
Posted By J_man01

No i havent checked the head light switch ill get...

No i havent checked the head light switch ill get back to you on that. yes these problems were there before i changed both switches. Could the problem be in the headlight relays that are in the dash?...
09-06-2010, 09:47 PM
Replies: 5
Views: 784
Posted By J_man01

replace multifunction and ign switch still have...

replace multifunction and ign switch still have the headlight issue ive read other posts about lights not working the cause has been an under the dash relay could i have the same issue
09-06-2010, 04:54 PM
Replies: 4
Views: 1,936
Posted By J_man01

Dash Cluster?

On my 2000 blazer i replaced the multifunction and ignition switches. I did the PASSLOCK relearn. I still have the problem with the speedo, trip, temp, fuel gauge, and the lights for the gear...
08-31-2010, 10:52 AM
Replies: 0
Views: 672
Posted By J_man01

Electrical issues

My 2000 blazer has me puzzled. The battery drains over night the highbeam indicator is always on. When its running the airbag security abs and the low fuel lights are on. The fuel gauge sits at empty...
08-29-2010, 10:57 AM
Replies: 2
Views: 549
Posted By J_man01

Ok Ill look into that. I got to change the...

Ok Ill look into that. I got to change the multifunction switch anyway so the ign switch ill do since im right there
08-28-2010, 09:48 AM
Replies: 2
Views: 549
Posted By J_man01

working out the bugs

got the alt replaced on my 2000 blazer had bat tested it was good. now that the alt charges the security light on the dash the battery light and the airbag light are on. I know i need a multifunction...
08-26-2010, 08:33 PM
Replies: 5
Views: 784
Posted By J_man01

Yea I kinda thought so too. Was hoping for a...

Yea I kinda thought so too. Was hoping for a simpler fix lol
08-26-2010, 08:24 PM
Replies: 5
Views: 784
Posted By J_man01

Yes i know i have drls ive had several blazers...

Yes i know i have drls ive had several blazers drls do not stay on when the truck is off. its just the headlights that stay on. The lights are on even when the truck is off. I have to pull the relay...
08-26-2010, 06:31 PM
Replies: 5
Views: 784
Posted By J_man01

New Blazer to the collection

Just bought a 2000 blazer 2 dr. Stole it for what i paid for it. Only prob i found so far is the headlights will not shut off unless the relay is pulled then they obviously dont come on at all. Im...
06-06-2010, 04:56 PM
Replies: 0
Views: 583
Posted By J_man01

Installing Axel shaft

My sons 98 blazer i changed the wheel bearing and the upper and lower ball joints the axel shaft needed to be changed on the right side. I cannot get it back in and seated all the way. there is about...
10-10-2009, 01:37 PM
Replies: 0
Views: 7,787
Posted By J_man01

ABS Code CO265

Have a 2001 Blazer 4x4 Im getting the CO265 brake code I know its the EBCM relay. The Problem im having goes away when the abs light come on. Can I replace the EBCM relay with out changeing the the...
09-25-2009, 08:16 PM
Replies: 7
Views: 4,290
Posted By J_man01

Problem fixed and wasnt as hard as i thought it...

Problem fixed and wasnt as hard as i thought it would be
09-07-2009, 11:51 AM
Replies: 7
Views: 4,290
Posted By J_man01

OK where is the Multi-switch located. I'll start...

OK where is the Multi-switch located. I'll start there
09-06-2009, 01:50 PM
Replies: 7
Views: 4,290
Posted By J_man01

Smoke from steering column

ok I posted about my right blinker staying on typed left but meant right. My brake lights would come on by themselves. I looked around at other postings to get some ideas. Well then the column...
09-05-2009, 05:40 PM
Replies: 2
Views: 1,023
Posted By J_man01

OK I think I found where my prob is cuz now when...

OK I think I found where my prob is cuz now when I turn the ign on smoke comes from the steering wheel also I found in the back where the computer and the onstar crap is the previous own tapped into...
09-05-2009, 03:30 PM
Replies: 2
Views: 1,023
Posted By J_man01

Turn signal doesnt blink

My 01 blazer the left turn signal does not blink when turned on it just stays on. the blubs are fine. and once in a while the brakes lights come on when the truck is in park. Obviously a short...
05-28-2009, 06:08 PM
Replies: 1
Views: 757
Posted By J_man01

SES codes

I got a 01 Chevy Blazer 175k miles. The other day the SES light came on. I stopped at the local Autozone I got a code P0410 and P0101. I checked all my vaccum and electrical lines and connections. I...
01-13-2007, 09:40 PM
Replies: 1
Views: 839
Posted By J_man01

Still have rough idle

New EGR cleaned the throttle body real good still idles up and down and dies when coming to a stop. When its parked facing up hill it wont start at all Im thinking fuel pump or fuel pressure...
01-04-2007, 09:48 PM
Replies: 2
Views: 653
Posted By J_man01

Another Problem

On my 93 blazer the same one with the idle prob the 4X4 indictor light is lit even when the truck is in 2WDit is manual shift not electronic. How Do I fix ?
Forum: General Chat
01-04-2007, 06:06 PM
Replies: 575
Views: 64,808
Posted By J_man01

RE: How many miles you got?

169,215 on my 93 blazer and 72,136 on my 01 Sonoma and building motor for my 88 Monte SS
01-04-2007, 05:47 PM
Replies: 2
Views: 749
Posted By J_man01

RE: EGR

I'll try that im getting a code 45 too and i believe thats a rich exhaust gas from the o2 sensor and a bad hesitation
01-04-2007, 04:18 PM
Replies: 2
Views: 749
Posted By J_man01

EGR

I just spent $205 on a new EGR valve for my 93 blazer CPI 4.3. it runs somewhat better but is now hard to start it runs rough for a few mins i smell gas then it smooths out when i drop it in gear the...
Showing results 1 to 43 of 43


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands