Blazer Forum - Chevy Blazer Forums - Search Results

Community
Search
Search: Posts Made By: livinterror
Showing results 1 to 15 of 15
Search took 0.00 seconds.
01-15-2009, 12:25 PM
Replies: 5
Views: 8,282
Posted By livinterror

01-15-2009, 12:18 PM
Replies: 5
Views: 8,282
Posted By livinterror

RE: HELP ASAP.. Torque specs...

I also need to know how tight do I tighten the tie rods? Please help me so I can get this finished!!
THANKS in advance!
01-15-2009, 12:10 PM
Replies: 5
Views: 8,282
Posted By livinterror

HELP ASAP.. Torque specs...

I need to know what is the torque for upper and lower control arms, upper and lower ball joints and the half shafts on a 1999 Blazer 4wd. Thanks Help me ASAP THANKS!!
12-28-2008, 09:41 PM
Replies: 11
Views: 16,240
Posted By livinterror

RE: Front end Squeal/Squeak/Sqwak

Did you ever find out what all the squeaks were?
12-28-2008, 08:50 PM
Replies: 5
Views: 2,855
Posted By livinterror

RE: 99 blazer 4wd steering shaft with rag joint

Well I will tell you why I think I need a new one... I took the drivers wheel off and the wheel well liner was ripped so I stuck my hand in there and tryed to move the steering shaft and rag joint...
12-28-2008, 07:54 PM
Replies: 4
Views: 7,924
Posted By livinterror

RE: Noise and vibration from drive shaft or rear end

You just said in your post that you like to "push" and "beat up" your vehicle, Then your gonna sit there and complain about putting money in to it when it breaks...
12-28-2008, 07:49 PM
Replies: 5
Views: 2,855
Posted By livinterror

RE: 99 blazer 4wd steering shaft with rag joint

I have 244k miles on my 99. I am sure I need a new one. I am rebuilding the whole front end this week. It also needs a heater core. factory engine and tranny too! I have a about a quarter turn in the...
12-28-2008, 07:07 PM
Replies: 7
Views: 1,037
Posted By livinterror

RE: How do I check to see if I have a bad cv axle?

Do I have to jack the blazer up and then try to move the cv axle? I am just wondering because I took off both my front wheels today and when I spun the rotor and stuff around the cv axle spun with it...
Forum: General Chat
12-28-2008, 05:26 PM
Replies: 85
Views: 6,591
Posted By livinterror

RE: Who is the high miles champ

1999 Blazer... 244k miles. Still kickin. All original. Just getting ready to rebuild the front end this week.
12-28-2008, 03:06 PM
Replies: 3
Views: 967
Posted By livinterror

RE: no heat 99 blazer

Correction*** The hose that's warm is the hose coming from the thermostat housing not the water pump... So if the hose going from the thermostat housing to the heat core is warm/hot and the hose...
12-28-2008, 02:56 PM
Replies: 3
Views: 967
Posted By livinterror

no heat 99 blazer

I have no heat. Its a 99 blazer. The heater core is not leaking. I took off both hoses and blew out the heater core. It was pretty dirty. I got the blazer up to operating tempurture and there it only...
12-28-2008, 01:44 PM
Replies: 5
Views: 2,855
Posted By livinterror

99 blazer 4wd steering shaft with rag joint

Where can I find a steering shaft with the rag joint??? I cant find one anywhere.. Also does anyone have a picture of the steering shaft with the rag joint? Thanks
Tristan
12-28-2008, 01:22 PM
Replies: 7
Views: 1,037
Posted By livinterror

How do I check to see if I have a bad cv axle?

Just like the title says.. 1999 Blazer 4wd.
Thanks
12-28-2008, 01:21 PM
Replies: 1
Views: 736
Posted By livinterror

How do I know what suspension I have?

How do I know what suspension I have? I am trying to find some parts for my blazer and they are asking me if its a zr2 or zm6... How do I find out thanks? I have a 99 blazer 4wd.
Thanks
Showing results 1 to 15 of 15


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands