Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: jfrust64
Showing results 1 to 26 of 26
Search took 0.00 seconds.
Forum: 1st Generation S-series (1983-1994) Tech
08-06-2013, 07:55 PM
Replies: 4
Views: 1,150
Posted By jfrust64

So we replaced the throttle position sensor, the...

So we replaced the throttle position sensor, the idle air sensor and the ECM and no change. We just had it out and the exhaust manifolds on both cylinder banks are glowing red. I don't think it...
Forum: 1st Generation S-series (1983-1994) Tech
05-26-2013, 11:06 AM
Replies: 4
Views: 1,150
Posted By jfrust64

Idle issue, delayed downshifts

Happy Memorial Day all and thank you vets!
I have a 94 S-10 W code and it has started to idle higher than normal and will cruise at 40 mph without touching the gas. The tranny won't kick down to...
Forum: 1st Generation S-series (1983-1994) Tech
02-11-2013, 01:14 PM
Replies: 7
Views: 11,340
Posted By jfrust64

OK, so I found a Delphi HP10005 and HP10004 are...

OK, so I found a Delphi HP10005 and HP10004 are supposed to fit the application. DOes it matter?
Forum: 1st Generation S-series (1983-1994) Tech
02-11-2013, 11:47 AM
Replies: 7
Views: 11,340
Posted By jfrust64

Thanks...it warmed up yesterday and the car...

Thanks...it warmed up yesterday and the car started right up!. I was able to move it into the garage and it worked again. I still suspect the pump is faulty but at least I can get under the car in...
Forum: 1st Generation S-series (1983-1994) Tech
02-09-2013, 03:59 PM
Replies: 7
Views: 11,340
Posted By jfrust64

That's why he is my former mechanic. My guy sold...

That's why he is my former mechanic. My guy sold his shop so I tried this new guy who was close. I have voltage for 2-3 seconds out of the FP relay when you turn the key but the pump doesn't...
Forum: 1st Generation S-series (1983-1994) Tech
02-09-2013, 08:14 AM
Replies: 7
Views: 11,340
Posted By jfrust64

Thanks, would that keep the fuel pump from...

Thanks, would that keep the fuel pump from priming after you turn the key?
Forum: 1st Generation S-series (1983-1994) Tech
02-08-2013, 07:00 PM
Replies: 7
Views: 11,340
Posted By jfrust64

94 s10 blazer cranks but won't start

Hi all and thanks in advance for any advice. 4.3 CPI had the fuel pump replaced last summer and, spider was replaced last year. Had no issues until this weekend when the engine cranks but won't...
Forum: 2nd Generation S-series (1995-2005) Tech
07-29-2012, 01:37 PM
Replies: 1
Views: 620
Posted By jfrust64

Going 2wd to 4wd?

Hi all,

My 96 4wd has a rotten frame but otherwise is in great shape. I found a 2001 2wd with a bad motor cheap. I was thinking of swapping the motor, tranny and transfer case, etc into the...
Forum: 1st Generation S-series (1983-1994) Tech
07-21-2012, 05:21 PM
Replies: 7
Views: 1,647
Posted By jfrust64

replaced the valve stem and everything seems to...

replaced the valve stem and everything seems to be fine...thanks again for your help.

You got me back on the road!!!
Forum: 1st Generation S-series (1983-1994) Tech
07-21-2012, 03:24 PM
Replies: 7
Views: 1,647
Posted By jfrust64

Thanks...I tried to tighten up the valve stem but...

Thanks...I tried to tighten up the valve stem but that didn't help either. The auto parts store didn't have the part. Can I replace the stem or is it keyed to a particular pressure?

This...
Forum: 1st Generation S-series (1983-1994) Tech
07-21-2012, 02:32 PM
Replies: 7
Views: 1,647
Posted By jfrust64

Where can I get this?

Where can I get this?
Forum: 1st Generation S-series (1983-1994) Tech
07-21-2012, 02:19 PM
Replies: 7
Views: 1,647
Posted By jfrust64

Getting Frustrated - Fuel Leaking from relief valve

Hi all,

I posted last week about fuel pump issues on my 94 4.3 CPI. Got everything back together, turned the key, the car started and fuel started pouring out of the pressure relief valve.
...
Forum: 1st Generation S-series (1983-1994) Tech
07-15-2012, 06:41 PM
Replies: 0
Views: 5,810
Posted By jfrust64

94 s10 blazer-no fuel, no power to fuel pump

I have power through the fuel pump relay but nothing back at the harness by the fuel pump although the guage works. No fuses appear to be blown and although the check engine light is on it is only...
Forum: 1st Generation S-series (1983-1994) Tech
07-30-2011, 10:56 AM
Replies: 0
Views: 1,064
Posted By jfrust64

Climate control vacuum actuator

I have a 94 S10 Blazer and I have already determined that the lower door actuator is bad. I did find a replacement and looks like it snaps onto the vent box. The trouble is that the bad one doesn't...
Forum: 1st Generation S-series (1983-1994) Tech
03-20-2011, 07:42 AM
Replies: 2
Views: 4,567
Posted By jfrust64

Cruise Control Throttle cable - 94 4wd

I have a 94 w/4.3/4wd and the cable from the cruise control module to the throttle broke. anyone know where I can find a replacement?

thanks for your help
Forum: 2nd Generation S-series (1995-2005) Tech
01-05-2011, 07:12 PM
Replies: 0
Views: 1,131
Posted By jfrust64

Blower Motor issues on 96

OK, I've replaced the blower motor (tested), the blower motor resistor, and about to change the blower switch tonight. Funny thing is my voltmeter shows current to the blower motor but it won't...
Forum: 1st Generation S-series (1983-1994) Tech
12-26-2010, 05:39 PM
Replies: 1
Views: 732
Posted By jfrust64

4wd not engaging -94 blazer

Wanted to play in the snow today but when we pushed it into 4 wheel (hi or low) it sounded like the front engaged but did not. Any ideas what this could be?

Thanks
Forum: Nitrous, Super Chargers, & Turbos
07-11-2010, 09:47 PM
Replies: 8
Views: 8,373
Posted By jfrust64

turbo or supercharger

i have a 1994 s10 blazer with the stock 4.3L cpi and i wanted to know if there are any kits out there and what i would have to do to put on the kit any changes or modification i would have to make
Forum: 1st Generation S-series (1983-1994) Tech
05-19-2010, 09:20 AM
Replies: 1
Views: 752
Posted By jfrust64

Electrical Problem - 94 4.3

Got past intake issues...driving the car today and the voltmeter is running around 16-17 volts then drops below 14 and the battery light comes on. Battery is less than a month old. Is there a...
Forum: 1st Generation S-series (1983-1994) Tech
05-19-2010, 09:16 AM
Replies: 13
Views: 3,154
Posted By jfrust64

Cleaned out the EGR...piece of charcoal blocking...

Cleaned out the EGR...piece of charcoal blocking the valve return. Car running good now. Thanks to all who helped out!
Forum: 1st Generation S-series (1983-1994) Tech
05-16-2010, 04:15 PM
Replies: 13
Views: 3,154
Posted By jfrust64

So the voltage on the TPS is 4.98. I removed the...

So the voltage on the TPS is 4.98. I removed the fuel cap and started the car and it started idling normally (and the SES light went out) so I took it out for about 15 minutes after I replaced the...
Forum: 1st Generation S-series (1983-1994) Tech
05-16-2010, 03:13 PM
Replies: 13
Views: 3,154
Posted By jfrust64

I will definitely check that. I just took the...

I will definitely check that. I just took the fuel cap off (thinking I might relieve any excess pressure) and replaced it. It started idling normally and the SES cleared. I took the car out for...
Forum: 1st Generation S-series (1983-1994) Tech
05-16-2010, 02:16 PM
Replies: 13
Views: 3,154
Posted By jfrust64

OK so I jumpered the OBD (A to B) and got the...

OK so I jumpered the OBD (A to B) and got the following codes:
22- TPS 32 - EGR 34 - MAF ?(didn't think it had one) 45 - Rich Exhaust

I also felt a small amount of gas around the fuel...
Forum: 1st Generation S-series (1983-1994) Tech
05-15-2010, 08:55 PM
Replies: 13
Views: 3,154
Posted By jfrust64

Haven't had the reader on it yet but as soon as I...

Haven't had the reader on it yet but as soon as I got it back together it ran fine until it warmed up. That's when the light came on and started running rough again. From what I've read it could be...
Forum: 1st Generation S-series (1983-1994) Tech
05-15-2010, 08:15 PM
Replies: 13
Views: 3,154
Posted By jfrust64

So I replaced the spider and the nut kit, still...

So I replaced the spider and the nut kit, still runs rough, SES light is on and seems to be running real hot after only a few minutes. No more gas smell in exhaust but a lot of sulpher. Any more...
Forum: 1st Generation S-series (1983-1994) Tech
05-04-2010, 08:29 PM
Replies: 13
Views: 3,154
Posted By jfrust64

94 4.3 Fuel Injection issues - confused

My son just bought this 94 as his first car and we are having many of the symptoms indicative of a bad FPR. I've also read several posts on the FPR and the spider assembly. I have the upper plenum...
Showing results 1 to 26 of 26


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands