Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: MABlazin
Showing results 1 to 8 of 8
Search took 0.00 seconds.
Forum: Steering, Suspension & Drivetrain
03-23-2013, 03:30 AM
Replies: 6
Views: 1,125
Posted By MABlazin

I'm getting another 2 quarts of fluid in the...

I'm getting another 2 quarts of fluid in the morning, getting use to swimming in it. I gave up on the bleeding tube and just let it run on the floor. At least you don't have to jack up a Blazer to...
Forum: Steering, Suspension & Drivetrain
03-22-2013, 03:08 PM
Replies: 6
Views: 1,125
Posted By MABlazin

How effective are Blazer brakes

How good is the stopping power of 96 Blazer brakes? On a scale of 1 to 10 with 1 being non-pwr manual brakes and 10 throwing you thru the windshield, mine are around a 5. If a deer ran out in front...
Forum: Steering, Suspension & Drivetrain
03-22-2013, 12:00 AM
Replies: 4
Views: 18,900
Posted By MABlazin

I bought a cheap vacuum bleeder which sucked out...

I bought a cheap vacuum bleeder which sucked out a lot of air. Looking okay.
Forum: Steering, Suspension & Drivetrain
03-20-2013, 01:04 PM
Replies: 4
Views: 18,900
Posted By MABlazin

Scratch that...brakes go to the floor. I must...

Scratch that...brakes go to the floor. I must have some massive air pocket. I had put clear hoses over the brakeline ends at the ABS but only pumped until bubble cleared, shaky set-up. I'm going to...
Forum: Steering, Suspension & Drivetrain
03-20-2013, 03:32 AM
Replies: 4
Views: 18,900
Posted By MABlazin

I had bled the master cylinder extensively. I...

I had bled the master cylinder extensively. I ended up intercepting the brake lines at the ABS unit and wrapping them back to the master cylinder reservoir. I got some air out and now the brakes...
Forum: Steering, Suspension & Drivetrain
03-18-2013, 08:50 PM
Replies: 4
Views: 18,900
Posted By MABlazin

Bleeding/resetting a proportioning valve

I just installed a new master cylinder and proportioning valve. The master cylinder was extensively bled but the prop valve was not, I was hoping to just blow thru it. It is difficult to get fluid to...
Forum: New Member Area
03-03-2013, 09:30 AM
Replies: 6
Views: 456
Posted By MABlazin

96 Blazer 4WD proud owner

I recently purchased my 96 Blazer from a friend who was leaving the country just because it was in good shape with low milage. I had no idea that I'd obtained a 4WD classic. There were a few issues...
Forum: Engine & Transmission
02-10-2013, 08:12 AM
Replies: 2
Views: 21,476
Posted By MABlazin

96 4.3L spark plug gap mystery

I gapped the new sparkplugs at .045 according to the maint section of the original manual in the glove box. Then I saw that the sticker under the hood shows .060 The GM service manual says .060. The...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands