Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: bhorn
Showing results 1 to 27 of 27
Search took 0.00 seconds.
Forum: 1st Generation S-series (1983-1994) Tech
07-26-2020, 08:57 PM
Replies: 5
Views: 1,162
Posted By bhorn

Okay, I solved it, and I feel quite dumb lol. ...

Okay, I solved it, and I feel quite dumb lol.

The connector in the previous post is the factory dash speaker wire that I unplugged and left there when I ran new wires from the amps. It was a...
Forum: 1st Generation S-series (1983-1994) Tech
07-25-2020, 03:40 PM
Replies: 5
Views: 1,162
Posted By bhorn

Earlier this week I found a loose connector with...

Earlier this week I found a loose connector with a tan and brown wire, I'm sure this must be the issue. I'm kind of baffled though as to how it became loose since the door locks were working...
Forum: 1st Generation S-series (1983-1994) Tech
07-19-2020, 10:34 PM
Replies: 5
Views: 1,162
Posted By bhorn

Here's one thing I just noticed. This is a 140...

Here's one thing I just noticed.
This is a 140 page diagram for 89 Chevy Trucks: http://www.73-87chevytrucks.com/techinfo/7387CKMans/Wiring/ST_350_89_1989_GM_RV-P_Light_Trucks.pdf
This is page 70 -...
Forum: 1st Generation S-series (1983-1994) Tech
07-19-2020, 09:56 PM
Replies: 5
Views: 1,162
Posted By bhorn

Here's some references, I hope someone can chime...

Here's some references, I hope someone can chime in.

Autozone replacement power door lock relay showing a straight 6 pin connection...
Forum: 1st Generation S-series (1983-1994) Tech
07-19-2020, 03:15 PM
Replies: 5
Views: 1,162
Posted By bhorn

Question 89 S10 Blazer Power Door Locks Issue

Hey all, there are a ton of threads on this subject but I wanted to post this as I didn't find a solution yet and it would be good to have on the forum.

Currently my passenger door lock works...
Forum: 1st Generation S-series (1983-1994) Tech
07-19-2020, 03:02 PM
Replies: 4
Views: 302
Posted By bhorn

Yes it was quite easy once taking it apart and as...

Yes it was quite easy once taking it apart and as long as you are organized and keep track of how everything goes in. The videos and writeups I shared are very helpful in making sure it's done...
Forum: 1st Generation S-series (1983-1994) Tech
07-12-2020, 06:33 PM
Replies: 4
Views: 302
Posted By bhorn

Found it! It goes on the bottom of the small...

Found it! It goes on the bottom of the small white plastic piece with two copper contacts, the key warning buzzer, to hold it in place. Here’s a pic for reference, it must’ve fallen off and just been...
Forum: 1st Generation S-series (1983-1994) Tech
07-12-2020, 05:36 PM
Replies: 4
Views: 302
Posted By bhorn

Sorry for the double post Whoever owned this...

Sorry for the double post

Whoever owned this car before me took the column apart at one point and didn't put it back together correctly. The retaining ring wasn't even installed on the shaft.

I...
Forum: 1st Generation S-series (1983-1994) Tech
07-12-2020, 05:28 PM
Replies: 4
Views: 302
Posted By bhorn

Question 89 S10 Blazer Tilt Wheel Disassembly - Where do these two pieces go??

Hey all. I found a number of very helpful threads on this subject, and there's a 3 part youtube video someone made a while back going through the whole disassembly on a first generation tilt wheel....
Forum: 1st Generation S-series (1983-1994) Tech
03-07-2020, 01:11 PM
Replies: 4
Views: 740
Posted By bhorn

Thanks for your responses. Spent a lot of the...

Thanks for your responses. Spent a lot of the afternoon yesterday doing more digging too. I'm taking the heads to my machine shop this morning and am just going to stay with the current setup. If...
Forum: 1st Generation S-series (1983-1994) Tech
03-06-2020, 05:31 PM
Replies: 4
Views: 740
Posted By bhorn

96+ Vortec Heads, Edelbrock 2114 Intake, Carb-TBI adapter plate

I have an 89 4.3 4x4 that I just took the heads off of and was planning to send in. I remember first getting the truck a few years back and seeing that a "common mod" was to swap the heads for newer...
Forum: Steering, Suspension & Drivetrain
02-26-2020, 01:29 PM
Replies: 2
Views: 275
Posted By bhorn

Thanks swartllk, you're always the most helpful! ...

Thanks swartllk, you're always the most helpful!

For anyone else reading this, AutoZone seems to recently have picked up another supplier for their loan-a-tools, and the newer one is called...
Forum: Steering, Suspension & Drivetrain
02-25-2020, 06:43 PM
Replies: 2
Views: 275
Posted By bhorn

Power Steering Pulley - 1st Gen 4.3

Howdy y’all. I have seen many threads addressing this but nobody seemed to have this issue. From all the other posts I’ve seen, it’s as easy as “put the autozone rental tool on the pulley and pull it...
Forum: 1st Generation S-series (1983-1994) Tech
05-19-2019, 04:49 PM
Replies: 1
Views: 948
Posted By bhorn

I should also mention, I just cleaned the EGR...

I should also mention, I just cleaned the EGR valve, and did a seafood treatment. Poured some slowly into the tbi, let the brake booster vacuum line suck some up, and put a full 20oz can into 20...
Forum: 1st Generation S-series (1983-1994) Tech
05-19-2019, 02:04 PM
Replies: 1
Views: 948
Posted By bhorn

Hesitation, Idle, Power Issues

Strange issue with my blazer. 89 4.3 4x4.

When starting cold, it rarely idles for more than 30-45 seconds before dying. I can give it the slightest amount of throttle for about 60 seconds or so...
Forum: Lifting Tech
12-18-2018, 06:28 PM
Replies: 2
Views: 1,160
Posted By bhorn

Problem Leveling Suspension after 2.5" RC Lift Kit - 89 S10 Blazer 4x4

Hey guys, I'm having a problem with my torsion bar adjustment and wanted to see if someone might be able to help. My front end is over 1" higher than the rear, but I cannot go any lower up front. ...
Forum: 1st Generation S-series (1983-1994) Tech
06-29-2018, 10:17 PM
Replies: 0
Views: 309
Posted By bhorn

Engine Mount Issue 89 4.3 4x4

I’m having an issue getting the long bolt hole that links the actual mount and the frame mount bracket to line up. The mount doesn’t seem to want to sink into the bracket enough, even with the whole...
Forum: 1st Generation S-series (1983-1994) Tech
06-01-2018, 03:15 PM
Replies: 1
Views: 1,359
Posted By bhorn

Question What size wrench needed for Lower Control Arm mounts?

I'm installing the 2.5" RC Suspension Lift and don't have the correct size socket or wrench for the LCA mounts (the largest of the other bolts are 19mm) I'm guessing it's a 21mm and need to go get...
Forum: Builds
12-26-2017, 04:35 PM
Replies: 9
Views: 4,358
Posted By bhorn

Driving home from a local brewery a few weeks ago...

Driving home from a local brewery a few weeks ago with some friends in the car, my service engine soon light popped on, and I could feel a loss of power, and a hesitation at lower rpms. I pull the...
Forum: Builds
12-19-2017, 11:58 AM
Replies: 9
Views: 4,358
Posted By bhorn

https://i.imgur.com/Q3uWSXE.jpg The pupper...

https://i.imgur.com/Q3uWSXE.jpg

The pupper already loves it

The rear window shocks hold maybe 1/20 times lol
Forum: Builds
12-13-2017, 03:14 PM
Replies: 29
Views: 2,341
Posted By bhorn

Awesome find! I too just bought mine, its a 4x4...

Awesome find! I too just bought mine, its a 4x4 89. Do you know what wheels those are?
Forum: General Chat
12-13-2017, 03:10 PM
Replies: 6
Views: 397
Posted By bhorn

Mine is an 89!

Mine is an 89!
Forum: Builds
12-13-2017, 03:09 PM
Replies: 9
Views: 4,358
Posted By bhorn

Talking BHorn's 1989 S10 Blazer 4x4 Build Thread

I should probably start one of these, before I get too far ahead of myself :icon_wink:
First S10 Blazer! 4.3L TBI V6 - 139xxx mi
The first focus will be on the interior and audio (the stereo is...
Forum: General Chat
12-13-2017, 02:46 PM
Replies: 6
Views: 397
Posted By bhorn

General Availability of Used Parts?

Hey folks!

New Blazer owner but old car enthusiast. For the first gen s10 blazer, how easy is it to find good used parts? Whether it is on this forum or online (I can't use the forum's classified...
Forum: New Member Area
12-13-2017, 02:22 PM
Replies: 6
Views: 545
Posted By bhorn

Thanks! I am so stoked about it. How are...

Thanks! I am so stoked about it.

How are the classified sections in this forum? I can already tell that some parts for this car are not super easily available, but have been able to track down...
Forum: The Lounge
12-12-2017, 03:18 PM
Replies: 1
Views: 275
Posted By bhorn

Any Homebrewers Here?

I brew at least once a week and am working on opening a brewery myself here in southern california :icon_toast:

Anybody else mess around with brewing?? I will probably be using the Blazer for keg...
Forum: New Member Area
12-11-2017, 01:04 PM
Replies: 6
Views: 545
Posted By bhorn

Thumbs up New S10 Blazer Owner from California - '89 4.3 4x4

https://i.imgur.com/ceDAFKb.jpg

Hey Blazer Forum users, my name is Brad from Southern California and I picked up this beauty a few months back. It needs just a little bit of TLC, but it seems to...
Showing results 1 to 27 of 27


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands