Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: sprbld417
Showing results 1 to 24 of 24
Search took 0.00 seconds.
Forum: General Chat
07-20-2011, 06:20 AM
Replies: 2
Views: 1,192
Posted By sprbld417

pulled a durango out of ditch

So just came back from a trip that I think you guys may enjoy. I have a '91 s10 blazer 4x4, 4.3 tbi that just turned 225,000. This blazer is rusted thoroughly (both front body mounts rusted through)...
Forum: 1st Generation S-series (1983-1994) Tech
06-12-2011, 03:32 PM
Replies: 0
Views: 829
Posted By sprbld417

extreme vibrations with my blazer at all speeds!

hey guys i've got a 91 s10 blazer 4x4. I get extreme vibrations driving at any speeds above 10-15 mph. I do not think it is bearings or anything like that, I believe my 4wd drive is stuck on. There...
Forum: 1st Generation S-series (1983-1994) Tech
05-01-2011, 09:21 PM
Replies: 1
Views: 559
Posted By sprbld417

clicking in left turns..?

hey guys I've got a 91 s10 blazer 4x4 4.3. I have a problem where I have an inner axle click in certain situations. It is best heard in left turns at around 10-45 mph and will click 1-3 times a...
Forum: 1st Generation S-series (1983-1994) Tech
04-25-2011, 04:24 PM
Replies: 4
Views: 24,697
Posted By sprbld417

EMERGENCY: Hood release cable broken; hood won't open

I have a '91 S10 Blazer 4x4 4.3 TBI. The hood is stuck and the hood release cable is broken. The truck burns oil and it's too low so I can't move until I open the hood.

I need to find a way to get...
Forum: Steering, Suspension & Drivetrain
04-20-2011, 05:52 PM
Replies: 3
Views: 507
Posted By sprbld417

are there any fuses I need to check? I looked for...

are there any fuses I need to check? I looked for a TCCM fuse but didnt find it
Forum: Steering, Suspension & Drivetrain
04-19-2011, 12:34 PM
Replies: 3
Views: 507
Posted By sprbld417

thank you very much. will begin working on it....

thank you very much. will begin working on it. thanks!
Forum: 1st Generation S-series (1983-1994) Tech
04-19-2011, 12:25 PM
Replies: 1
Views: 533
Posted By sprbld417

funny oil pressure?

hey guys, i've got a 91 s10 blazer, 4.3. my oil pressure shows over 40 when I first start it up cold. after 10 seconds it divebombs down to 0 and stays there throughout the whole driving range. I...
Forum: Steering, Suspension & Drivetrain
04-19-2011, 12:09 PM
Replies: 3
Views: 507
Posted By sprbld417

no 4wd at all, ever

hey guys, ive got a '91 s10 blazer, 4.3. I've tried shifting my truck into 4wd but has never engaged. Where should I begin diagnosing? Thank you guys.
Forum: 1st Generation S-series (1983-1994) Tech
03-06-2011, 06:38 AM
Replies: 7
Views: 45,254
Posted By sprbld417

Okay thank you guys. Everything works again. I...

Okay thank you guys. Everything works again. I would have never checked that fuse mainly because of the radio situation. For some reason the radio also works, which I'm curious about. The radio has...
Forum: 1st Generation S-series (1983-1994) Tech
03-05-2011, 07:54 PM
Replies: 7
Views: 45,254
Posted By sprbld417

Okay, will check. My radio still does not work...

Okay, will check. My radio still does not work though. I've pulled everything out of my radio space, but will check that 20A fuse. Thank you.
Forum: 1st Generation S-series (1983-1994) Tech
03-05-2011, 05:09 PM
Replies: 7
Views: 45,254
Posted By sprbld417

EDIT: Radio does not work, and dome light doesn't...

EDIT: Radio does not work, and dome light doesn't work either (may have just burned out, but I can't tell if it is in the same circuit or not). Fuse is good. I'm thinking bad grounds. Gonna start...
Forum: 1st Generation S-series (1983-1994) Tech
03-04-2011, 04:30 PM
Replies: 7
Views: 45,254
Posted By sprbld417

very quick question (cigarette lighter)

hey guys, just wondering where the fuse is for my cigarette lighter. I checked my fuse box and can't find cigar ltr. I pulled out every 15A fuse for the hell of it and they were all fine. thank you....
Forum: 1st Generation S-series (1983-1994) Tech
01-27-2011, 09:18 AM
Replies: 2
Views: 5,320
Posted By sprbld417

"Check Gages" light is always on, shows low oil pressure

I have a quick question. My check gauges light is always on and my oil pressure is always at 0. Do you guys think that maybe this is a problem with the gauge or with my engine not getting enough...
Forum: General Chat
01-27-2011, 08:56 AM
Replies: 2
Views: 1,681
Posted By sprbld417

Thank you very much. I unclipped the power to the...

Thank you very much. I unclipped the power to the blower motor, first things first. Checked for power..none. Dead. Went to my fuse box and pulled out that blown 30A and replaced it. Works like a...
Forum: General Chat
01-26-2011, 09:22 PM
Replies: 2
Views: 1,681
Posted By sprbld417

How to diagnose heat problems?

I've read alot on what goes wrong, blower motor stops working, heater core gets clogged, and even the switch on the dash itself craps out after a while. When I try to turn on my fan, basically...
Forum: 1st Generation S-series (1983-1994) Tech
09-28-2010, 10:25 PM
Replies: 3
Views: 5,435
Posted By sprbld417

yes I mean throttle body injection. and also the...

yes I mean throttle body injection. and also the connectors are actually fine, its just the tiny little plastic piece on the bottom that broke off. looks like I'm getting the whole connector though,...
Forum: 1st Generation S-series (1983-1994) Tech
09-27-2010, 06:28 PM
Replies: 3
Views: 5,435
Posted By sprbld417

Huge problem with fuel injector electrical connector!!

hey guys i've got a '91 s10 blazer, 4x4 with 4.3l (no vortec). last night driving home my truck was barely drivable and would want to stall out. It would drive just fine until out of nowhere it would...
Forum: 1st Generation S-series (1983-1994) Tech
08-27-2010, 07:08 AM
Replies: 6
Views: 1,899
Posted By sprbld417

1991 s10 blazer 4x4. 2 door. I believe my...

1991 s10 blazer 4x4. 2 door.

I believe my thermostat is broken because nothing displays on my temperature gauge and my rad is stuck on all the time. No air blows out of the vents at all.
Forum: 1st Generation S-series (1983-1994) Tech
08-25-2010, 01:08 PM
Replies: 6
Views: 1,899
Posted By sprbld417

my blazer blows no hot or cold air!

hey guys whats going on. my blazer blows no hot or cold air. what should I check and look at to make at least the hot air work? My thermostat is broken. When thermostats break they usually stay stuck...
Forum: 1st Generation S-series (1983-1994) Tech
08-22-2010, 01:02 PM
Replies: 0
Views: 663
Posted By sprbld417

91 s10 blazer..no wipers! cold solder joints? could use some help!

I traded a bike for a '91 s10 blazer. I had to do a little brake work and other little things. When I first received the truck the wipers did not work at all. One day after a couple of weeks I turned...
Forum: 1st Generation S-series (1983-1994) Tech
08-03-2010, 11:34 AM
Replies: 7
Views: 1,446
Posted By sprbld417

aand also how can I tell if my truck has ABS?

aand also how can I tell if my truck has ABS?
Forum: 1st Generation S-series (1983-1994) Tech
08-03-2010, 11:12 AM
Replies: 7
Views: 1,446
Posted By sprbld417

when I flared it there was plenty of fluid coming...

when I flared it there was plenty of fluid coming out. That makes me doubtful that the other part of the line is bad but I will definately have to look over it again when I have it on the lift.
Forum: 1st Generation S-series (1983-1994) Tech
08-02-2010, 09:23 PM
Replies: 7
Views: 1,446
Posted By sprbld417

'91 s10 blazer 4x4.. and I cut off the part...

'91 s10 blazer 4x4..

and I cut off the part of the line that rusted and leaked, got a new one, flared it, and put it on. still no pressure. My fronts work great but I don't like skidding...
Forum: 1st Generation S-series (1983-1994) Tech
08-02-2010, 09:09 PM
Replies: 7
Views: 1,446
Posted By sprbld417

No rear brake pressure...at all!

tried bleeding the brakes and nothing came out. The brake line is fine. Any suggestions as to what is wrong?
Showing results 1 to 24 of 24


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands