Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: DannyTheVito
Showing results 1 to 28 of 28
Search took 0.01 seconds.
Forum: Engine & Transmission
08-28-2020, 08:51 PM
Replies: 5
Views: 336
Posted By DannyTheVito

Thanks for the reply! This is really just me...

Thanks for the reply! This is really just me trying to find what is going to break next. Really didn't want to change a fuel pump on the side of the road. If you say I don't have a problem I'll...
Forum: Engine & Transmission
08-28-2020, 08:12 PM
Replies: 5
Views: 336
Posted By DannyTheVito

Thanks for the advice. Engine performance is...

Thanks for the advice.

Engine performance is fine for the most part. A bit slower to react to the pedal than my other Blazer.
I will get sparkplug pictures when I change the oil here before long....
Forum: Engine & Transmission
08-28-2020, 12:46 PM
Replies: 5
Views: 336
Posted By DannyTheVito

2002 2WD 4.3 Lean Condition (No vacuum leak)

Greetings friends,
My Blazer is running a bit lean and doesn't appear to be a vacuum leak. The lean condition isn't bad enough to fire a CEL, but I want to resolve this issue before it gets worse.
...
Forum: 2nd Generation S-series (1995-2005) Tech
03-15-2020, 02:45 AM
Replies: 3
Views: 458
Posted By DannyTheVito

I'm still not sure if they are the right gaskets....

I'm still not sure if they are the right gaskets. The wobble sockets I got aren't deep enough to get the studs off. I'm really at a loss of how to get the passenger side studs loose. They are tucked...
Forum: 2nd Generation S-series (1995-2005) Tech
03-08-2020, 12:26 PM
Replies: 3
Views: 458
Posted By DannyTheVito

Exhaust gasket part numbers

Hey guys,
I have a 2002 2WD Blazer with an exhaust leak at the flange where the y-pipe meets the manifold. I want to go ahead and get the gaskets (and probably new studs/nuts) ahead of time. A quick...
Forum: Engine & Transmission
07-26-2019, 12:19 AM
Replies: 6
Views: 2,308
Posted By DannyTheVito

Hey everyone, I found the crankcase vent tube...

Hey everyone,
I found the crankcase vent tube sort of came undone. I'm not sure if that was the cause or I did that when I was checking fuel pressure. It seems to be running a lot better now since...
Forum: Engine & Transmission
07-17-2019, 06:56 PM
Replies: 6
Views: 2,308
Posted By DannyTheVito

Hey everyone, Sorry to keep posting, but I just...

Hey everyone,
Sorry to keep posting, but I just wanna get all this information out there in case someone else ever has the same problem. The information on this forum has proved invaluable so I'd...
Forum: Engine & Transmission
07-15-2019, 07:56 PM
Replies: 6
Views: 2,308
Posted By DannyTheVito

Went ahead and logged what the fuel trim was...

Went ahead and logged what the fuel trim was doing while sitting in the drive way. I got it into closed loop then revved up the engine from idle. I wasn't logging misfires as I wanted to be sure to...
Forum: Engine & Transmission
07-14-2019, 12:32 AM
Replies: 6
Views: 2,308
Posted By DannyTheVito

Single cylinder misfire when merging

Hey everyone,
My 02 2WD 4.3L Blazer is experiencing a single cylinder misfire on cylinder #5 when I'm merging onto the interstate and feel a noticeably loss in power. Usually when I hit about 60 mph...
Forum: Engine & Transmission
07-10-2019, 07:23 PM
Replies: 8
Views: 1,247
Posted By DannyTheVito

Hey everyone, Finally got around to messing...

Hey everyone,
Finally got around to messing with this Blazer again. I couldn't convince anyone with a scanner to come out here to the boonies and scan it and I didn't wanna drive it too far. So it...
Forum: Engine & Transmission
05-05-2019, 06:07 PM
Replies: 8
Views: 1,247
Posted By DannyTheVito

I pulled the valve and spring out, they both...

I pulled the valve and spring out, they both looked good. The wire harness is brand new.

I acquired a used PCM, had it key'd to my VIN and slapped it in real quick. After the 10-10-10 relearn I...
Forum: Engine & Transmission
05-05-2019, 03:53 PM
Replies: 8
Views: 1,247
Posted By DannyTheVito

Sorry for the multiposting. Just wanted to update...

Sorry for the multiposting. Just wanted to update with what I've tried lately.

I gave all the wires a good tug coming from the PCM to maybe knock loose a short or broken wire causing the...
Forum: Engine & Transmission
05-03-2019, 10:59 PM
Replies: 8
Views: 1,247
Posted By DannyTheVito

Well, I replaced all the solenoids and the...

Well, I replaced all the solenoids and the harness. Bolted it back up and went for a drive. All was looking good after a few miles at operating temp 1-2-3-4 and back down no problem. Parked it for a...
Forum: Engine & Transmission
05-03-2019, 12:44 PM
Replies: 8
Views: 1,247
Posted By DannyTheVito

Hey Transman304, thanks for the reply. I triple...

Hey Transman304, thanks for the reply. I triple checked I was testing the correct solenoid and I will put the new one in once I figure out the problem. The A&B will also be replaced along with the...
Forum: Engine & Transmission
05-02-2019, 07:18 PM
Replies: 8
Views: 1,247
Posted By DannyTheVito

Went ahead and pulled the pan off. Checked the...

Went ahead and pulled the pan off. Checked the ohms on the 3-2 shift solenoid and get 22.8 ohms which I believe in in spec, so I connected it back for the time being.

I pulled the PCM out and used...
Forum: Engine & Transmission
04-26-2019, 05:32 PM
Replies: 8
Views: 1,247
Posted By DannyTheVito

1999 P0785 after reaching operating temperature

Hey all,
I have a 1999 Blazer that is popping a P0785 after it warms up. During warm up it shifts fine, 1-2,3-4 then back down no problem. After reaching operating temp (~195) it will pop this code,...
Forum: 2nd Generation S-series (1995-2005) Tech
10-13-2018, 02:53 PM
Replies: 17
Views: 1,106
Posted By DannyTheVito

Well, I'm not sure what to say now. Mike, if...

Well, I'm not sure what to say now. Mike, if you're ever in my neck of the woods I owe you a steak dinner. :icon_imnotworthy:
...
Forum: 2nd Generation S-series (1995-2005) Tech
10-06-2018, 07:50 PM
Replies: 17
Views: 1,106
Posted By DannyTheVito

I've got some googling to do to figure out how to...

I've got some googling to do to figure out how to read a schematic. :icon_user:

I was searching around to find any info I could about this issue. I started playing around with the multifunction...
Forum: 2nd Generation S-series (1995-2005) Tech
10-04-2018, 04:25 PM
Replies: 17
Views: 1,106
Posted By DannyTheVito

The cheapest bulb I can find is $13, hardly...

The cheapest bulb I can find is $13, hardly peanuts :icon_cry:. But at this point it's a worthy investment, next time I head out I'll pick one up. This old Blazer has made me good friends with the...
Forum: 2nd Generation S-series (1995-2005) Tech
10-04-2018, 09:51 AM
Replies: 17
Views: 1,106
Posted By DannyTheVito

I'll check the highbeam voltage this afternoon. I...

I'll check the highbeam voltage this afternoon. I don't have a regular lightbulb to test with. I've tried several different bulbs, even the known good one from the passenger side.

So something...
Forum: 2nd Generation S-series (1995-2005) Tech
10-03-2018, 06:33 PM
Replies: 17
Views: 1,106
Posted By DannyTheVito

Went ahead and voltage tested. I connected the...

Went ahead and voltage tested. I connected the negative probe to the negative terminal and back-probed positive probe to the positive line going into the HID ballast and got 12.5 volts. I then...
Forum: 2nd Generation S-series (1995-2005) Tech
10-03-2018, 04:24 PM
Replies: 17
Views: 1,106
Posted By DannyTheVito

I just took another look for the grounding wire....

I just took another look for the grounding wire. I pushed the air filter box a little bit and sure enough there it is, under a ton of rust and corrosion. I guess the best way to get down to it is...
Forum: 2nd Generation S-series (1995-2005) Tech
10-03-2018, 03:39 PM
Replies: 17
Views: 1,106
Posted By DannyTheVito

Mike, I looked up and down for a grounding wire...

Mike,
I looked up and down for a grounding wire near the front drivers side headlight and came up empty. I searched google images for the location and I still don't have a clue.

As for testing...
Forum: 2nd Generation S-series (1995-2005) Tech
10-03-2018, 12:33 PM
Replies: 17
Views: 1,106
Posted By DannyTheVito

Hi Mike, Thanks for the reply. I believe this...

Hi Mike,
Thanks for the reply. I believe this doesn't have much to do with the HID kit, as the DRLs and highbeams aren't part of the HID install, they have a separate plug.

Here is the kit I...
Forum: 2nd Generation S-series (1995-2005) Tech
10-02-2018, 06:46 PM
Replies: 17
Views: 1,106
Posted By DannyTheVito

Lightbulb Only one headlight working

Hi,
Let me start by saying I bought this blazer and it had a HID kit installed. The drivers side went out, after some investigating it looked like some water made it into the connector that...
Forum: Lighting & Electrical
02-14-2018, 04:04 PM
Replies: 4
Views: 3,409
Posted By DannyTheVito

Mini update: I tried starting it in Drive and it...

Mini update: I tried starting it in Drive and it cranked right up. Instrument cluster even said it was in drive when it cranked. NSS must be out of whack. I tried adjusting it up/down as much as she...
Forum: Lighting & Electrical
02-14-2018, 01:16 PM
Replies: 4
Views: 3,409
Posted By DannyTheVito

Thank you for the replies. I tried starting it in...

Thank you for the replies. I tried starting it in Neutral and it would not. I didn't notice this before, but when shifted into Neutral, the instrument cluster doesn't light up the N. If I'm in Park,...
Forum: Lighting & Electrical
02-13-2018, 04:14 PM
Replies: 4
Views: 3,409
Posted By DannyTheVito

Reverse lights turn on in Neutral

I have a RWD 2002 4-door LS automatic that I recently purchased. The previous owner has done some work to it, new radio/speakers, headlights, alarm system with remote start. I've been doing some...
Showing results 1 to 28 of 28


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands