Blazer Forum - Chevy Blazer Forums - Search Results

Community
Search
Search: Posts Made By: Bluesmoke99
Showing results 1 to 18 of 18
Search took 0.00 seconds.
01-26-2021, 03:30 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

no sir it nothing out of the ordinary not that i...

no sir it nothing out of the ordinary not that i can see anyways it was i 65 degree day here in ky i began pulling the fenders and front core support to get a better look and once again i didnt find...
01-24-2021, 03:43 AM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

Yes sir jumping it over with a 12v source works...

Yes sir jumping it over with a 12v source works good and kicking in the power through the relay also works flawless. Resistance checks are all either 0.000 and no more than 0.008, i can't seem to...
01-22-2021, 03:30 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

After 47 wires cut and put back together there...

After 47 wires cut and put back together there werent any that made a difference still blows the fuse im at a total loss at this point
01-19-2021, 04:36 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

So i re ran the half assed wire inside the dash...

So i re ran the half assed wire inside the dash and down the loom like it was from factory and fixed the trans issue it now has power and works to my knowledge lol im going today to buy 47 wire...
01-17-2021, 03:30 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

So apparently before i got the truck they had an...

So apparently before i got the truck they had an issue with the trans getting power, so from the back of the cluster fuse 11 on the side of the dash they placed a very half assed inline fuse a 20...
01-16-2021, 07:51 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

yes sir lol

yes sir lol
01-16-2021, 04:08 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

Yes 02 s10 4.3 2wd thats the charcoal box near...

Yes 02 s10 4.3 2wd thats the charcoal box near the fuel tank right? The canister purge solenoid?
01-16-2021, 03:35 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

Yes sir the only fuse i had in the under the hood...

Yes sir the only fuse i had in the under the hood block was the ecmb and it still poped
01-16-2021, 01:13 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

in an 02 it powers fuel pump, fp relay and oil...

in an 02 it powers fuel pump, fp relay and oil pressure sensor. Ive stripped all of the wires from the harness one by one the entire harness including behind the dash and have found nothing that...
01-15-2021, 03:07 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

I disconnected everything on the truck to the...

I disconnected everything on the truck to the point that the ecm b fuse was only connected to the ecm when i disconnected the injector plug it didnt make a difference and to be sure my ecm was good...
01-14-2021, 09:32 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

At this point i basically have a entire wiring...

At this point i basically have a entire wiring harness laying in my living room i have tested continuity on everything i possibley could test i havent found anything worse then a .08 from end to end...
01-14-2021, 07:40 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

At this point i basically have a entire wiring...

At this point i basically have a entire wiring harness laying in my living room i have tested continuity on everything i possibley could test i havent found anything worse then a .08 from end to end...
01-14-2021, 04:31 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

I got a little angry and yanked out the fuse box...

I got a little angry and yanked out the fuse box i pulled it apart and the inside is a mess on my 200ohm setting on my multimeter it shows .8 from the fuse holder to the pin on the bottom and its the...
01-14-2021, 02:07 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

So i did as you said disconnected ecm end unfused...

So i did as you said disconnected ecm end unfused the ecmb tested outgoing non hot and it did showed ol on the continuity i plugged the ecm back in and tested it shows 10.7 ohms i also checked the...
01-14-2021, 02:05 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

So i did as you said disconnected ecm end unfused...

So i did as you said disconnected ecm end unfused the ecmb tested outgoing non hot and it did showed ol on the continuity i plugged the ecm back in and tested it shows 10.7 ohms i also checked the...
01-13-2021, 10:21 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

Got home today and checked ecm wiring some more,...

Got home today and checked ecm wiring some more, all wires act as they should i figured ecm was bad so i made an inline fuse out of a 20 amp fuse and 2 wires tied the two orange 12v wires to it and...
01-13-2021, 11:30 AM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

Yes! I have checked each wire with a multi meter...

Yes! I have checked each wire with a multi meter and visually inspected them. everything points to the ecm or fuse box and i know the ecm is good, and have 0 idea on how to go about testing the fuse...
01-12-2021, 07:42 PM
Replies: 39
Views: 1,176
Posted By Bluesmoke99

Ecm is driving me nuts....

Soooooooooo. I have an 2002 4.3 s10 i was driving to work i pulled in and the truck died on me turns out the ecm b fuse popped no biggie, through another in there and it fired up and i drove home...
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands