Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Ted
Showing results 1 to 13 of 13
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
12-07-2008, 04:08 PM
Replies: 1
Views: 857
Posted By Ted

Courtesy light mounting location

So I spent the afternoon replacing the combo switch on my daughter's 98 Blazer. A couple of great tips from this forum made the job easier and saved my hunting down some sockets for the single...
Forum: 2nd Generation S-series (1995-2005) Tech
08-16-2007, 09:37 AM
Replies: 3
Views: 3,637
Posted By Ted

RE: ABS Speed Sensor Wire

Note that if you don't have exact match wire you can go larger for the extra piece. I would not go smaller.
Forum: 2nd Generation S-series (1995-2005) Tech
08-11-2007, 11:47 AM
Replies: 18
Views: 14,491
Posted By Ted

RE: 98 Blazer 4.3 11 mpg Is that Normal?

You didn't ask for advice...you asked if it was normal mpg.

Focus on things that would cause an over rich condition, like coolant temp sensor, O2S or leaking injectors. If you had a miss, was it...
Forum: 2nd Generation S-series (1995-2005) Tech
08-10-2007, 08:52 PM
Replies: 18
Views: 14,491
Posted By Ted

RE: 98 Blazer 4.3 11 mpg Is that Normal?

This question is a joke, right?

You were getting 22 mpg.
You get a tune up.
Now you're getting 11 mpg.
You ask if that's normal mpg.
Which would make your pre tune-up...
Forum: 2nd Generation S-series (1995-2005) Tech
08-08-2007, 10:23 AM
Replies: 7
Views: 1,110
Posted By Ted

RE: 200 miles to a tank

Also, have you switched from gasoline to E-85? It's got significantly less stored energy, so you'll use more.
Forum: 2nd Generation S-series (1995-2005) Tech
08-08-2007, 09:51 AM
Replies: 7
Views: 1,110
Posted By Ted

RE: 200 miles to a tank

I'd guess a problem with either the coolant temp sensor or the O2 sensor in the manifold (upstream).

If either one is sending incorrect readings, it can run much richer.

You want to see...
Forum: 2nd Generation S-series (1995-2005) Tech
08-08-2007, 07:57 AM
Replies: 3
Views: 5,777
Posted By Ted

RE: R134a how much "psi"

The low pressure reading will vary second to second with where you are in the compressor on/off cycle, as well as other factors.

Best bet for getting it right is to remove all refrigerant,...
Forum: 2nd Generation S-series (1995-2005) Tech
08-07-2007, 03:20 PM
Replies: 235
Views: 68,807
Posted By Ted

RE: WHO'S HAD GOOD LUCK WITH DEX-COOL

Wisdomracing said:
Water Pump went about 7 weeks ago...changed it and put in radiator cleaner to get rid of the heavy coating of brown **** in the system...ran it like that for about 500 miles when...
Forum: 2nd Generation S-series (1995-2005) Tech
08-07-2007, 08:38 AM
Replies: 2
Views: 991
Posted By Ted

RE: BRAKES! need help, don't know what to replace

Did you allow the fluid to drain while you were changing the calipers? Completebleeding can be a problem without power bleeding equip., especially if you have ABS.

You make no mention of...
Forum: 2nd Generation S-series (1995-2005) Tech
08-07-2007, 08:31 AM
Replies: 2
Views: 1,961
Posted By Ted

RE: Rear Brake Caliper Brackets

Just had to replace rear calipers on my daughter's '98 Blazer. The NAPA remans came with brackets and all HW (pins, boots, etc.) for $40 per side. Just something to keep in mind when checking...
Forum: 2nd Generation S-series (1995-2005) Tech
08-06-2007, 02:43 PM
Replies: 4
Views: 16,499
Posted By Ted

RE: Removing parking brake handle

Not vehicle specific, as I don't know yours, but:

I'm not sure you want to remove it from the "shaft" (usually a cable). What makes you think you want to? Removing the bracket that holds it in...
Forum: 2nd Generation S-series (1995-2005) Tech
08-06-2007, 01:23 PM
Replies: 2
Views: 761
Posted By Ted

RE: Need some diagnostic ideas

Clean the TB and IAC.
Forum: 2nd Generation S-series (1995-2005) Tech
08-05-2007, 08:10 PM
Replies: 7
Views: 5,781
Posted By Ted

Caliper pistons won't go back

I ran into a problem this weekend that was a first for me in my 40+ years of DIY auto repairs. I was wondering if anyone has any insight.

My daughter's 98 Blazer needed new rear pads, so I got...
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands