Rear end swap question
#1
Rear end swap question
I tried searching and couldnt really find a match but I would like to know if a rear end out of an 89 s10 would fit my 96 4x4 blazer?
May be a stupid question but I can get it cheap so I was curious. Thanks
May be a stupid question but I can get it cheap so I was curious. Thanks
#2
Dang, 23 views and no response!?
#3
Have patience. The rules of the forum state to wait at least 24 hours to 'bump' a post.
Is the donor axle the same gear ratio?
Is the donor truck a 4wd like yours? The 2wd axle is narrower.
A quick glance at an interchange manual shows that '95-'97 will interchange given the same drivetrain & gear ratio, but it doesn't list what, if anything changed from the 1st to 2nd gens.
Is the donor axle the same gear ratio?
Is the donor truck a 4wd like yours? The 2wd axle is narrower.
A quick glance at an interchange manual shows that '95-'97 will interchange given the same drivetrain & gear ratio, but it doesn't list what, if anything changed from the 1st to 2nd gens.
#4
Wasnt really a bump, it was only two down. Was just surprised it wasnt answered by then, lol. So is there a chart on here I can look at, I may have missed it. Im not sure about gear ratio, he said it was in a s10 that had a v8 in it. I may just pass it up and wait till I find one thats an exact fit. Thanks
Thread
Thread Starter
Forum
Replies
Last Post
brino1
Steering, Suspension & Drivetrain
5
02-25-2011 08:05 PM
l3igl3ang
Steering, Suspension & Drivetrain
4
01-23-2009 08:08 PM