Community
Search
1st Generation S-series (1983-1994) Tech Discuss 1st generation S-series (1983-1994) general tech topics here.

92 s10 no power to cpi

Thread Tools
 
Search this Thread
 
  #1  
Old 06-17-2013, 08:25 PM
New Member
Thread Starter
Join Date: Jan 2013
Posts: 4
rrm40 is on a distinguished road
Default 92 s10 no power to cpi

I have been replacing everything that checks bad o a 92 4.3 w vin. cannot get car to start runs when fuel is sprayed in to intake then shuts off . No power is getting to fuel spider. Any thoughts out there on this. Next I was going to pull the pcm. My fuel pressure is 64 psi, all sensors have been replaced even if they checked good.
RRm40
 

Last edited by rrm40; 06-17-2013 at 09:32 PM.
  #2  
Old 10-17-2013, 09:29 PM
1965Chevy's Avatar
Beginning Member
Join Date: Dec 2012
Location: mcminnville, OR
Posts: 31
1965Chevy is on a distinguished road
Default

Im having the same problem in my 93 4.3 vin w was hoping to get some ideas as to where i should be looking
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
HIALEAHCHIKO305
Engine & Transmission
14
02-03-2014 09:00 PM
prbjeepin
1st Generation S-series (1983-1994) Tech
0
04-08-2013 10:14 PM
1993 S10 BLAZER 4X4 CPI
1st Generation S-series (1983-1994) Tech
5
09-16-2012 11:28 AM
tg22ar
1st Generation S-series (1983-1994) Tech
17
07-01-2011 02:50 PM
catdrugn
1st Generation S-series (1983-1994) Tech
9
10-10-2009 06:50 PM



Quick Reply: 92 s10 no power to cpi


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands