Help With Throttle Cable?
#1
Help With Throttle Cable?
I was replacing the FPR in my 1993 GMC Jimmy with the W code engine, and when I took off the throttle cable, a spring came out of nowhere. Now that I put everything back on, I just stuck the spring in a hole beside the throttle cable. When I cranked it up, it sounds like it's being held at full throttle. Anybody know of this is linked together and does anyoen know where the spring goes?
#2
RE: Help With Throttle Cable?
that was probably your throttle return spring, and it'll have to connect to the throttle cable assembly, as well as the throttle body
#3
RE: Help With Throttle Cable?
Where exactly does that spring go?
I took off the entire throttle cable and started it and it's at a lower RPM now, but still revving pretty high. On the Speedometer it actually shows that I'm going between 2-3 MPH while it's still in park and just sitting there. I don't get what the problem is. Anybody got any tips? It's so close to being fixed, damnit.
I took off the entire throttle cable and started it and it's at a lower RPM now, but still revving pretty high. On the Speedometer it actually shows that I'm going between 2-3 MPH while it's still in park and just sitting there. I don't get what the problem is. Anybody got any tips? It's so close to being fixed, damnit.
#4
RE: Help With Throttle Cable?
I'll try and snag a pic of it when I sober up a little bit, lol, had a good night last night... I'll do my best to grab one or two when I wake up, if'n nobody beats me to it before then...
Thread
Thread Starter
Forum
Replies
Last Post
TexasRider
Full Size K5 (1969-1991) GMT415 (1992-1994) Tech
8
05-30-2013 09:10 AM
Squad-6
1st Generation S-series (1983-1994) Tech
7
04-22-2013 02:19 PM
csteez
2nd Generation S-series (1995-2005) Tech
2
03-10-2011 08:25 PM