Installed amp wires, now ful pump doesn't run unless jumped!?
Thread Starter
|
Starting Member
Joined: Jul 2010
Posts: 158
From: Omaha, NE
Installed amp wires, now ful pump doesn't run unless jumped!?
I just got done running amp wires from the battery and the stereo back thru the passenger side. Now the fuel pump isn't working... Is there anything I might of messed up?
Power wire from battery on passenger side thru the antenna groomet at floor of passenger at firewall. Then back onder the carpet. I pulled the trim strip from the floor board on the passenger side where the door goes to conceal the wires. Also, I ran the 2 rca wires and amp lead from the radio to beheind the glove box and then down along with the power wire.
The fuel pump does run when I jump it in the engine bay.
Power wire from battery on passenger side thru the antenna groomet at floor of passenger at firewall. Then back onder the carpet. I pulled the trim strip from the floor board on the passenger side where the door goes to conceal the wires. Also, I ran the 2 rca wires and amp lead from the radio to beheind the glove box and then down along with the power wire.
The fuel pump does run when I jump it in the engine bay.
Thread
Thread Starter
Forum
Replies
Last Post
JohnBarJB
Audio/Video Electronics
17
Sep 28, 2020 07:34 PM
hypertek
2nd Generation S-series (1995-2005) Tech
26
Mar 3, 2013 04:58 PM
SDadam
1st Generation S-series (1983-1994) Tech
1
Aug 9, 2010 09:58 PM
rogggg1020
1st Generation S-series (1983-1994) Tech
8
Sep 24, 2008 06:53 AM
