1997 Blazer A/C Evaporator Replacement
#21
08-23-2012, 10:08 AM
Originally Posted by laliyah79
any way these pictures can be emailed to me? I am having the same problem & would like to see how hard the job could be. thanks
#23
02-07-2013, 02:40 AM
Photos of Evap replacement
Originally Posted by Eric D
I used a utility knife and razor blade to cut the soft rubber outer housing, and attached a bungie cord to the hard plastic inner case to pull the side facing the engine apart. In one of the pics you can see the bungie cord. There are a few screws that were hard to see that hold the hard plastic case together, so use a flashlight and scan it good.
Below is a link to the photos of the evaporator replacement. Let me know if the link works.
Shutterfly Kodak Gallery Customer Welcome Page | Kodak Gallery and Shutterfly
Below is a link to the photos of the evaporator replacement. Let me know if the link works.
Shutterfly Kodak Gallery Customer Welcome Page | Kodak Gallery and Shutterfly
#24
02-07-2013, 02:55 AM
Eric, I could not figure out how to PM you but I don't care about posting my email address if you can send me the pics. I tried the link but it says Kodak is closed or something like that.------------------- is my email address. Thank you very much!
Last edited by bigmac993; 02-07-2013 at 10:10 PM.
#25
02-07-2013, 10:09 PM
Originally Posted by Eric D
I used a utility knife and razor blade to cut the soft rubber outer housing, and attached a bungie cord to the hard plastic inner case to pull the side facing the engine apart. In one of the pics you can see the bungie cord. There are a few screws that were hard to see that hold the hard plastic case together, so use a flashlight and scan it good.
Below is a link to the photos of the evaporator replacement. Let me know if the link works.
Shutterfly Kodak Gallery Customer Welcome Page | Kodak Gallery and Shutterfly
Below is a link to the photos of the evaporator replacement. Let me know if the link works.
Shutterfly Kodak Gallery Customer Welcome Page | Kodak Gallery and Shutterfly
Thanks Again!
#26
06-09-2013, 10:47 PM
Evap removal?
Eric, I could not figure out how to PM you. Could I get those pics too? Messed up my evap trying to remove stuck orifice tube. Much appreciated! 
SteelyTed at gmail .com
SteelyTed at gmail .com
#28
06-11-2013, 10:25 AM
can you pm the pics or email me at [email protected]***.net. ive been trying to figure out a way to do this with removing everything
#30
06-13-2013, 12:59 AM
I'd love a copy of those pics as well. If you would be so kind to email them to me at [email protected] I would be very appreciative. If they get posted somewhere accessible that would be great as well!
