control arm bushing question
#11
thanks for everyones help. i got the new ball joints in, new shocks, new axle shaft and one wheel bearing, new brake pads and rotors. i also replaced the rubber grease caps on the outer tierods. clead out all the old grease and repacked them.
i figured out what the vibration was. one wheel had no balance weights and the other wheel only one weight. that was on the rear which had new tires installed recently.
i also had another issue. i opend up the factory sunroof only to have it not close. i was so upset. turns out the computer for the sunroof went bad. wth?! pulled the little computer out and jumper wired the sunroof motor to get it closed. what a pain in the backside.
i figured out what the vibration was. one wheel had no balance weights and the other wheel only one weight. that was on the rear which had new tires installed recently.
i also had another issue. i opend up the factory sunroof only to have it not close. i was so upset. turns out the computer for the sunroof went bad. wth?! pulled the little computer out and jumper wired the sunroof motor to get it closed. what a pain in the backside.
Last edited by bansheedave; 03-19-2012 at 05:15 AM.
Thread
Thread Starter
Forum
Replies
Last Post
er0ck273
2nd Generation S-series (1995-2005) Tech
3
11-14-2014 02:48 PM
05BlackJimmy
2nd Generation S-series (1995-2005) Tech
5
03-26-2012 09:05 PM