ok got a 1998 chevrolet blazer,

i got a few problems that i would like some help with.

Intake gaskets, just got a set of fel-pro ones from advanceautoparts.com suprisingly they are metal and rubber,

i need a complete tool list because i dont have many tools but i do have some, any pics/videos would be awesome to! i have doen alot of work when it comes to cars but never a intake gasket..

Would really like help on this.

Daddy Dustin

 

I found this to be really helpful. I just did mine this weekend. Wasn't too bad really, just take your time.

I opted to replace my water pump and hoses while I was at it as well as the valve cover gaskets that come in the FelPro kit, thermostat, etc.

Nothing too special here. A descent set of metric sockets and wrenches. A set of torx wrenches (the folding ones worked best), and I borrowed/rented the fan clutch wrenches from Advance Auto.

There is also a good write up in the DIY section that I printed out and had on hand while I was working to refer to.

 

+1, not a hard job at all. Just take your tme, take pictures too, it aids with putting it all back together if you have never done it. You will save hundreds of dollars by doing it yourself.