lost ????
#1
lost ????
i put some gabriel hijacker air shocks on the rear and it now noticeably leans to the front drivers side a good 2 inchs the air shocks are tied together with 40psi i measured the lenght of them at that pressure and there equal what would cause a lean? should i replace the front shocks also? any suggestions
#4
not takin wrong at all ya it was on level ground i even got a level to check the ground and it never leaned before what else is there that would cause that and the back is 1 inch higher than before on both sides in the rear and would it be better to run one line to each so there not tied together?
and another thing any idea where i can get the slide on nuts for the rear shocks mounts there cheap pos's and mine rusted out there for the top mount
and another thing any idea where i can get the slide on nuts for the rear shocks mounts there cheap pos's and mine rusted out there for the top mount
Last edited by argon929; 11-23-2009 at 05:18 PM. Reason: forgot words
#7
Use 1 air valve and run sep hoses to each shock.. make sure the hoses are not located near the exhaust or sharp metal..if you push down on your front fenders how much does the truck bounce when ya stop pushing on it? You could have a bad shock or even a broken spring..
Thread
Thread Starter
Forum
Replies
Last Post
wxj1974
2nd Generation S-series (1995-2005) Tech
10
01-03-2007 10:09 PM