whenever i go and make a U turn i always have to reverse and finish or go offroading and ride the grass .. anyways does anyone else notice the crappy turn to turn diamater? i think its 44" but im not sure .. is there somehting i can do it increase this? perhabs a new steering bar thats connected to the steering wheel?

 

I think my jimmy has a wicked turning radius compared to most other vehicles I have driven...

 

The Blazer has a turning diameter of ~35 feet. What are you comparing it against?

 

I can make pretty sharp turns in my blazer I don't see a problem with it, just requires me to turn my steering wheel a lot faster than in my moms car.

 

Its steering ratio is probably just higher than in your mother's car. Since Blazers were never designed with a bias toward handling, that's probably a good thing.

 

2006 colorado - by alot
2003 nissan sentra
1998 ford mustang
1988 ford F250 - by alot
2006 ford f150 - by alot

I've even had a few people comment on how tight it turns down some trails too. they have to back up to make the corner, yet i can make it one go.

 

Yeah she has a ford escape and there is like 22 years difference between my car and her car prob just a lot different design.

 

My 04 Blazer turns tight, however when turning on pavement with the wheel to the stop it feels like it pushes. Anyone else notice this.

 

love doing u-turns on dirt, little to the right, hard left and punch the throttle. fun in the snow too, just not as pedictable.

 

this thing turns waaaay tighter than my moms little fifth ave did, only it seems to get wheel hop