need help
#1
need help
i just replace the uper and lower intake gasket on my 2000 blazer 4.3 and now it hard to start and idles rough and my tachometer has stoped working and while going down the road it act like it is skiping sometimes any help
#3
Did you make sure you were on TDC before you stabbed the distributor?
Check all pig tails and connections.
Check for vacuum leaks. lose hoses, broken hoses, ect. etc.
Check all pig tails and connections.
Check for vacuum leaks. lose hoses, broken hoses, ect. etc.
Last edited by BAGnDRAG-K5; 07-26-2010 at 05:01 PM.
#4
my ckeck engine light is on took to get check and they said it was the camshaft sensor i got a new one but where is its location? lol
Last edited by bulletuga; 07-26-2010 at 07:00 PM. Reason: spelling
#5
Run down through the diagnostic trouble shooting and see if anything jumps out at you. The CMP is in the distributor.
Also, please do not double post your question. If you forget to mention something, please edit your original post to include that information rather than posting another thread. Your other thread about your tach has been deleted.
Also, please do not double post your question. If you forget to mention something, please edit your original post to include that information rather than posting another thread. Your other thread about your tach has been deleted.
Thread
Thread Starter
Forum
Replies
Last Post
maximashift
2nd Generation S-series (1995-2005) Tech
1
11-17-2009 09:36 AM