pulling my hair out!!!
#1
pulling my hair out!!!
i have a 1994 s10 blazer and it will not start. I hooked up a fuel pressure gauge and i am gettring around 60lbs of pressure. I have no spark now. replaced coil, still nothing. replaced the ignition module and it started but then a few hours later no start again. Replaced rotor cap and rotor, then it started again. it ran fine for a few minutes and then it started to stall. it would start back up a few times but then it would stall. now it will not start period. getting no spark to the plugs. any ideas?
#2
What was your fuel pressure leak down rate? A leak inside the intake could cause the stalling, but wouldn't cause a no-spark condition.
Thread
Thread Starter
Forum
Replies
Last Post
Skitzoape
1st Generation S-series (1983-1994) Tech
12
03-01-2014 01:56 PM
stan kelly
2nd Generation S-series (1995-2005) Tech
0
03-10-2013 06:05 PM
BlackFireLS4.3
Engine & Transmission
9
01-29-2010 10:00 PM
noyb72
2nd Generation S-series (1995-2005) Tech
4
05-12-2008 10:48 PM
gareth12
2nd Generation S-series (1995-2005) Tech
5
10-11-2007 08:17 AM