stalls/no start when hot
#1
Starting Member
Thread Starter
Join Date: Jul 2012
Posts: 1

2002 blazer
160,000 miles
p0410 and p0128 codes
Blazer runs okay in morning drive to work. Afternoon drive home stalls after driving 20 miles. After short rest, I can pump gas and get Blazer to start enough putput off to a parking lot. After long rest, Blazer will start and run normal. weather is hot but vehicle temps are okay.
After reading all these threads, I'm just trying to figure out where to start. Can't duplicate problem while at home. read that po410 will not effect driving conditions, so I've narrowed it down to ICM getting hot or Fuel Pump overheating.
Please Help!
160,000 miles
p0410 and p0128 codes
Blazer runs okay in morning drive to work. Afternoon drive home stalls after driving 20 miles. After short rest, I can pump gas and get Blazer to start enough putput off to a parking lot. After long rest, Blazer will start and run normal. weather is hot but vehicle temps are okay.
After reading all these threads, I'm just trying to figure out where to start. Can't duplicate problem while at home. read that po410 will not effect driving conditions, so I've narrowed it down to ICM getting hot or Fuel Pump overheating.
Please Help!
#3
Starting Member
Join Date: Aug 2012
Location: Stamford CT
Posts: 3

I just replaced my cap rotor wires an plugs. The cap came with a tech note to remove one of the bottom screws under the rotor to allow heat to escape. I did not save the paper but it was a AC delco cap. Hope this helps
Thread
Thread Starter
Forum
Replies
Last Post
frustrated_chevy_girl
2nd Generation S-series (1995-2005) Tech
31
07-23-2011 09:49 AM
firechief70
2nd Generation S-series (1995-2005) Tech
6
06-27-2011 10:08 PM
ravenhurst
2nd Generation S-series (1995-2005) Tech
15
04-26-2009 07:53 AM
see119
2nd Generation S-series (1995-2005) Tech
1
08-30-2005 02:00 PM






