c10 front end
#1
c10 front end
Hello everyone I was this picture of a 1st gen blazer. The blazer had a 67 c10 fornt end and I fell in love with the look. I dnt know if any one has seen it. But know I want one. And I don't know how they did it but it looks like a tone of fab. I know that they didn't just bolt the c10 fenders and hood. I think by looking at the pic that they might of cut the top and front side of the c10 fender and then welded the bottom of the s10 fender but I don't know. If any one can help me out that would be grate. I have a pic of it. But I don't know how to upload it. You can find it on th wed its a green color and its slamd to the ground
#2
Is this the one you are reffering to? There are probably hundreds if not thousands of man hours to make this happen! As sick as it looks the chances of recreating it and making it look good as this one does are pretty slim. The entire truck has been reworked to make the body lines correct and the entire front would have to be sectioned out to narrow it to fit the s10 body as well. I don't have a clue of your abilities but I know whoever built this is one talented **** to make it look so pretty!
Last edited by rexmburns; 02-07-2013 at 08:39 AM.
#3
Thread
Thread Starter
Forum
Replies
Last Post
colgad
New Member Area
0
04-26-2015 01:49 PM
brino1
Steering, Suspension & Drivetrain
5
02-25-2011 08:05 PM
ComputerNerdBD
2nd Generation S-series (1995-2005) Tech
5
03-18-2009 06:13 PM