finished disassemble...through with the project
#1
finished disassemble...through with the project
the interior is completely stripped down to the metal, except for the dash. i tried to get as much from the motor as i could but i feel like i am getting burned out.
i wanted to pull the tranny but my work area is in a garage with a dirt floor and i don't feel that safe putting the truck on stands in case the floor shifts while torquing certain bolts.
i'm going to post it for sale for a few days then get it haul out of here. i won't get paid but it will cover the cost of the tow. i really wanted those darn wiring harnesses though ;\
i did good and i am proud of myself. i learn a few neat trick for the future when i get a new blazer. i will continue posting with updates until it's finally all gone.
i wanted to pull the tranny but my work area is in a garage with a dirt floor and i don't feel that safe putting the truck on stands in case the floor shifts while torquing certain bolts.
i'm going to post it for sale for a few days then get it haul out of here. i won't get paid but it will cover the cost of the tow. i really wanted those darn wiring harnesses though ;\
i did good and i am proud of myself. i learn a few neat trick for the future when i get a new blazer. i will continue posting with updates until it's finally all gone.
Thread
Thread Starter
Forum
Replies
Last Post
nicknieves
2nd Generation S-series (1995-2005) Tech
3
11-05-2008 01:04 PM