Project: One LOUD Blazer
sup everyone im new here. i own a 2000 chevy blazer 2dr. i know haven't seen to many serious SPL car audio build's here. so thought i might post up mine. Here's the equipment i plan on running FOR NOW notice how that's in cap's lol.
Equipment
Door's: 6.5 peerless india mid's.
Highs in the dash: 3" vifa's
Headunit: Alpine 9887
Battery bank: Stinger spv70's
Wire: All Shok Industries Shok Industries be sure to check em out. plan on doing two runs of each two power and two ground. ground all batt's to frame as well as run buss bars.
Alternator: Either Singer Alternator's or DC Power once again(gotta save up).
BIG 3: All Shok wiring as well.
Subwoofers: Two custom 18's sundown Nightshade v1 motor's with Shocker Audio softparts
Amplifiers: 4 sundown 1500ds GONE On the way Sundown NS-1

Enclosure: In the works
Exterior
Plan on fixing body defect's such as small dent's in doors etc.....
Paint chevy symbol high gloss black with leaving the chrome outside.
Projector headlight's with halo's & as well L.e.d. turn signal's to match
Smoke out tail light's wet sand and clear coat them.
Cowl hood
Interior
sand down all interior pieces with grit and use SEM filler primer get all grit out
High gloss and clear coat interior pieces.
Stinger voltmeter right under center console.
I know that's a long list guy's but believe me it will deff happen all through time
. stay updated. uploading some pic's right now.
Equipment
Door's: 6.5 peerless india mid's.
Highs in the dash: 3" vifa's
Headunit: Alpine 9887
Battery bank: Stinger spv70's
Wire: All Shok Industries Shok Industries be sure to check em out. plan on doing two runs of each two power and two ground. ground all batt's to frame as well as run buss bars.
Alternator: Either Singer Alternator's or DC Power once again(gotta save up).
BIG 3: All Shok wiring as well.
Subwoofers: Two custom 18's sundown Nightshade v1 motor's with Shocker Audio softparts
Amplifiers: 4 sundown 1500ds GONE On the way Sundown NS-1


Enclosure: In the works

Exterior
Plan on fixing body defect's such as small dent's in doors etc.....
Paint chevy symbol high gloss black with leaving the chrome outside.
Projector headlight's with halo's & as well L.e.d. turn signal's to match
Smoke out tail light's wet sand and clear coat them.
Cowl hood
Interior
sand down all interior pieces with grit and use SEM filler primer get all grit out
High gloss and clear coat interior pieces.
Stinger voltmeter right under center console.
I know that's a long list guy's but believe me it will deff happen all through time
. stay updated. uploading some pic's right now. Last edited by loudblazer21; Aug 27, 2011 at 11:41 PM.
there are a couple other loud builds going on. Personally, i'm not getting rid of my rear seat so, a 10 cubic box is the largest i can go. Your build sounds like it'll be crazy man.
Where you from and i'm assuming you're going to be competing with the system.
Where you from and i'm assuming you're going to be competing with the system.



