Ok can someone chop this for me
i want it lowered approx 2 inchs in the back
tail lights tinted, roll pan, and a cowl hood with the center flat black
and darker windows. thanks to whoever wants to do it

*ok well im not lowering it
so now i just need a roll pan, cowl hood, and tinted tails
forget the tinted windows too

thanks

 

Rollpan, ****ty looking cowl, and I lowered/leveled it 2" just so you'd change your mind :P

Just drop it using coils and Blocks IMO.

I like the old school Cragars with that sidewall combo.

 

wow that 2/2 drop looks pretty good,
some people say i have too much tire, but i love the size of tires that are on them

 

Personally, I'm not a fan of the forward raked look, I think it's looks better with the front and rear sitting level but that just me. Everything else would look prett B.A. Good luck!

 

thanks
and also to lower it 2 inches in the front, i should get 4 inch springs because i already have 2 inch springs from the zq8 suspension right?
and how do you think it will look if i lower it only in the back?

 

IF you lowered it only in the rear you'd probably end up with a level ride which is nice. If you do the rollpan I'd dump your exhaust right after the muffler... your tip will look out of place...

 

thats what i was thinking
and yea i did that last week, it is now dumped about 6 inchs before the axle and sounds amazing
im looking for a gm factory roll pan now

 

Yeah, lowering the back only would give it a nice flat stance which would look awesome with the rollpan!

 

i might just lower it 2 inchs in the rear with blocks
i think itd look awesome

 

Cheapest way to do it, and it'd look awesome.

Factory roll pan?

I'd go this route personally... http://www.lmctruck.com/icatalog/cst/full.aspx?page=91
Get it painted to match an it'll look sick.