96 S10 Blazer
#1
96 S10 Blazer
Hi, I recently picked up this blazer and am receiving a DTC P0753. I am preparing to replace both (A,B) shift solenoids. While the transmission pan is off i figured I might as well replace the filter as well.
While reading up on these procedures, I have heard that a lot of people were having trouble removing the pan from the vehicle(A lot of talk about having to remove cross members and "Y" pipes??). I was just hoping that someone could clarify for me what the exact problems were and how to get around them. I have looked all around the pan and it seems to be clear, but would like to hear from someone that has actually done it. I plan on starting this little project in a few days and would just like to know any tips to making it easier.
While reading up on these procedures, I have heard that a lot of people were having trouble removing the pan from the vehicle(A lot of talk about having to remove cross members and "Y" pipes??). I was just hoping that someone could clarify for me what the exact problems were and how to get around them. I have looked all around the pan and it seems to be clear, but would like to hear from someone that has actually done it. I plan on starting this little project in a few days and would just like to know any tips to making it easier.
#2
no just the crossmember the trans mounts on. the rear of the pan must be able to drop down without busting off the solenoids, the ones u r going to replace. just jack with wood under t case and remove member and ur totally fine then its easy after that.
Thread
Thread Starter
Forum
Replies
Last Post
Dallas1970
2nd Generation S-series (1995-2005) Tech
12
02-22-2019 05:05 PM
94BlazerGirl
Engine & Transmission
1
08-28-2014 06:14 PM
rfine67
Paint, Body, & Interior
3
08-13-2011 01:04 PM
1994BlazerS10
The Lounge
5
03-03-2010 08:52 AM