OK, in my 1974 K5 blazer it currently has bucket seats which are worn but ok and i wanna replace them with a single bench seat, because it has no back seat at all...so i want to put a bench seat in the front...what would i get this seat out of? K10 C10???? where do i find it lol...and will i have any trouble bolting it in, will i have to tap any new holes or what?


Thanks again

 

i highly doubt that's possible, the hump in the center to clear the tranny will make it impossible, or very difficult, to put a bench seat in it.

 

as for where to get the bench i might look in about the same year silverado, but to make it fit i would mount the old brackets to the bench. in my truck the seem to clear the tranny tunnel, then you could just run the cable from the driver side to the passanger side to make the seat slide.

 

Thanks for the info guys! I think i can make it work.

 

how bout a suburban? they had bench seats, try on craigslist.org ...