Nice

 

Welded my Flowmaster 44 on finally! pics in my build thread

 

Replaced my washer container in my 89 S15 Jimmy today with one I got off of ebay as NOS. My original washer container mounting holes were busted.

 

Couple small things.... first was replacing the passenger side windshield wiper arm (soooo much better). Also I replaced the rear water pump in my windshield washer tank. Piece by piece I will fix this baby up !!!

 

today i stared at the tires while drinking a cold one.


oh and i kicked a tire too. Maybe this weekend il do the control arm bushings.

 

I did nothing today, but tomorrow I am painting below the body trim flat black, cover up the surface rust that popped up over the winter.. Until I can fix it the right way (sanding and grinding, and then covering with chassis saver)

I will get before and after photos.

 

Today I got the wife's 2000 Blazer back from the shop. All the gear oil had leaked out the pinion shaft seal and the pinion bearings were completely shot and the pinion shaft as well. $1889.93 later the truck has a new ring and pinion, all the axle bearings it'll ever need, fresh fluid in the transfer case, and a new seal for that as well.

At least she's happy. I probably could have sent her shoe shopping and she would have been twice as happy for half the price.

 

Toby, ouch. did you consider a junk yard or pick a part unit?

 

Warshed her then Vacuumed her, and then rubbed her down real good
then staired at her... im talking bout my Envoy, not some PYT

 

Painted below the trim flat black, washed, waxed, showcar glazed, and shined the tires, cleaned all the windows, cleaned the interior and vacuumed it out. Looks like it just rolled off the lot.