just another nex guy
Thread Starter
|
New Member
Joined: May 2011
Posts: 3
just another nex guy
Hi guys/gals
New to the forum.
I have a 2000 Chevy blazer LT 4 door 4x4 bone stock.
I also have a 98 jeep grand cherokee that I have chopped up and is a tube buggy rock crawler on 37 Iroks that im stripping down.
Plan is to do a solid axle swap with long arms and run a 35" tire on the blazer. (any advice you care to throw my way would be great.)
Will start another post on that so to keep things in the right parts of the forum after I do some much needed searching.
New to the forum.
I have a 2000 Chevy blazer LT 4 door 4x4 bone stock.
I also have a 98 jeep grand cherokee that I have chopped up and is a tube buggy rock crawler on 37 Iroks that im stripping down.
Plan is to do a solid axle swap with long arms and run a 35" tire on the blazer. (any advice you care to throw my way would be great.)
Will start another post on that so to keep things in the right parts of the forum after I do some much needed searching.
Thread Starter
|
New Member
Joined: May 2011
Posts: 3
Thanks for the welcome.
Lots of info on this site will make the build a lot easier.
What I have so far is a set of 79 ford bronco axles 44 hp front and big bearing 9" rear. Both have cromoly axle shafts and 4.88 gears. Full spool in the rear. I have a set of long arms so I can convert it over to coil springs all the way around.
Lots of info on this site will make the build a lot easier.
What I have so far is a set of 79 ford bronco axles 44 hp front and big bearing 9" rear. Both have cromoly axle shafts and 4.88 gears. Full spool in the rear. I have a set of long arms so I can convert it over to coil springs all the way around.
Thread
Thread Starter
Forum
Replies
Last Post
chrishorton74
2nd Generation S-series (1995-2005) Tech
3
Jun 2, 2010 09:03 PM
