Body Swaps
#11
Old body is almost stripped. Need to pull the window motors, regulators and glass out of the doors and tailgate. I hate having a night job, I would have been done already.
#12
My uncle must have been bored. He pulled what was left and scrapped the rest this morning. (It is at his place).
#13
If anyone is interested, a stripped 1990 k5 body is ~900lbs. However that does exclude the topper, hood, and radiator support.
Last edited by nktidwel; 12-18-2011 at 08:38 PM.
#14
4 rotted body mount brackets and a bent frame. What should I do?
I have a body to put on, but cant.
Everything mechanical on the truck work, and has many new parts with 0 miles.
What to do? Junk it, repair it, or find a frame?
I have a body to put on, but cant.
Everything mechanical on the truck work, and has many new parts with 0 miles.
What to do? Junk it, repair it, or find a frame?
#15
Well you will have to weld new body mount brackets on. And i dont know what you can do about the frame. you might be able to heat it up and bend it back. how did it get bent in the first place?
#16
It is bent where near it is rotted. There is a Reese hitch there too... Maybe the pressure from a trailer? It is not a side to side bend, but a down up type bend right after the hitch
#17
some one proly overloaded or put max load on the trailer and bc the fram was rusted and weaker then new it pulled the frame down
#18
What's involved in putting a 3rd gen body on a 2nd gen frame?
#19
Did any k5 have an IFS?
#20
NVM 92+ but have longer wheelbases, etc.
Last edited by nktidwel; 01-31-2012 at 08:42 AM.