1996 Blazer bouncy, drifting
Thread Starter
Joined: Jun 2008
Posts: 2
1996 Blazer bouncy, drifting
O.K, hopefully someone can help with this. here is what has been done so far.
1) all balljoints replaced
2) tie rod ends inner and outer replaced
3) new tires Cooper Cobra 235-70-R15
4) 4 new monroe sensormatic shocks
5) new idler arm and pitman arm
6) new Hub bearing right front
7) new front sway bar link bushings
8) Brakes done last year, still good
9) rear end grease replaced, new rearend cover installed (old one rusted almost through)
10) front end alignment done, and rechecked
Blazer still seems to want to dip and roll excessively on rough roads and when there is a small dip in the road. what else can I check. I have had it to 3 different shops and checked it myself. everyone says the same thing, everything looks good, brand new. its still not as it was, any suggestions?
1) all balljoints replaced
2) tie rod ends inner and outer replaced
3) new tires Cooper Cobra 235-70-R15
4) 4 new monroe sensormatic shocks
5) new idler arm and pitman arm
6) new Hub bearing right front
7) new front sway bar link bushings
8) Brakes done last year, still good
9) rear end grease replaced, new rearend cover installed (old one rusted almost through)
10) front end alignment done, and rechecked
Blazer still seems to want to dip and roll excessively on rough roads and when there is a small dip in the road. what else can I check. I have had it to 3 different shops and checked it myself. everyone says the same thing, everything looks good, brand new. its still not as it was, any suggestions?
Thread
Thread Starter
Forum
Replies
Last Post
Howard Kuflik
2nd Generation S-series (1995-2005) Tech
0
May 27, 2012 11:14 PM
